Hoover U6634900 Support Question
Hoover U6634900 Support Question
Find answers below for this question about Hoover U6634900 - Self Propelled WindTunnel Bagless Upright Vacuum.Need a Hoover U6634900 manual? We have 1 online manual for this item!
Question posted by kwlaursen on January 15th, 2014
Very Little Suction
Vacuum has very little suction. Hose is not plugged. Filter is clean. Could gaskets on the removable dirt collector need replaced?
Current Answers
Answer #1: Posted by BusterDoogen on January 15th, 2014 2:01 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,437
Member since:
October 30th, 2011 Points: 28,565,437
Only if you feel air bypassing the rubber seals. Check the beater bar to see of its clogged with strings & hair. Good luck!
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Hoover U6634900 Manual Pages
Manual - Page 1
Self-Propelled WindTunnel™ Bagless with Powered Hand Tool by HOOVER
®
This product was designed for easy Assembly (See page 3)
www.hoover.com
Manual - Page 2
...plug. Index
Assembling Cleaner 3 Carton Contents 3
How To Use Cleaner Descriptions 4 Cleaning Tools 6-7 Embedded Dirt FINDERTM Feature .5 Upright Cleaner 4-6 Self-Propel Feature 4
Important Safeguards 2 Maintenance
Authorized Service 13 Cleaning Filters 8-9 Emptying Cup 7-9 Lubrication 13 Replacing Belts 10-11 Replacing... (Depot).
• Use vacuum cleaner only for warranty service...
Manual - Page 3
...remove...hose in order to need assistance during assembly, make sure switch (A) is in the OFF position.
If switch lock has come off during assembly or operation,
Visit us online at the back of your cleaner. Carton contents
1-1
Accessories
C
D
A
B
Remove all parts from self-propel... include an extra hose
Note: The white...Remove label (D) from carton and identify each item...
Manual - Page 4
... use.
2-2
2-3
The assembled cleaner will fit in upright position, tilt cleaner back on bottom of electric shock, this appliance has a polarized plug (one way.
slide knob to 27. Handle
pet being cleaned.
2. Dirt cup
22. HEPA cartridge filter
cord around and under furniture, noncarpeted floors), slide the self-propel button to OFF to room, put handle in...
Manual - Page 5
..., the following carpet height settings are removed.
The green light will come on handle release lever to turn brush roll ON for a considerable amount of dirt which the system may stay on . To let you should take additional cleaning strokes in the area until it is in upright position, brush roll is first turned...
Manual - Page 6
... at bottom of carpet or furniture.
2-13
2-14
2-15
F
G
E
Stair Cleaning
Use the hose and powered hand tool or furniture nozzle for convenience in the OFF window, brush roll... roll OFF" and for stair cleaning. Cleaning lightweight flexible rugs
Stand on handle. Cleaning tools
When using cleaning tools, cleaner handle must be in the upright position to remove dirt in the ON window, brush...
Manual - Page 7
..., lighting fixtures, venetian blinds, baseboards, shutters, and registers.
How to unlock. To attach hose to your vacuum cleaner, follow the instructions below.
2-18
M N
Turn cleaner OFF before using the cleaner for this type of dust, empty the cup and clean the filters often.
3-2
F
Dirt cup
The dirt cup assembly consists of the above tools.
2-19
Slide...
Manual - Page 8
... cartridge filter and pre-filter are essentially self-shedding. The pre-filter can also be removed for additional cleaning.
3-7
J
K
3-8
Grasp end of the ends. Slide filter assembly out of HEPA cartridge filter as described in "How to empty the dirt cup. Tap filter until lid closes.
Empty cup.
Press latch (F) to the right to lock in "How to clean filter assembly
Remove dirt cup...
Manual - Page 9
... required. Check brush roll channels
Because your cleaner's excellent pick up and suction. Remove debris as shown and lift off lens. Remove any accumulation. Installing bulb
Pull old bulb straight out of the filter faces outward. Press door back into place. Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base type 912...
Manual - Page 10
... large pulley (C) while rolling the pulley in Fig. 3-18. Remove used belt Flat belt (B) operates the self-propel feature and indirectly drives the brush roll.
To check condition of brushes... stretch belt onto pulley.
3-22
Replacing bottom plate Reposition bottom plate and 4 Phillips head screws. Warning - To maintain cleaning effectiveness, replace agitator if brushes do not touch card...
Manual - Page 11
...40201200).
Belt may fit loosely when properly installed. Remove tool from hose and turn it out. Press the latches on ...outside of belt), slide back of belt over pulley and pull front of cleaner. 3-24
3-25
3-26
F
D
Replacing brush roll
Removing brush roll Slide brush roll control (Fig. 2-9) to last for a long time and is not normally replaced...
Manual - Page 12
... bottom plate as described in tool housing and snap into slots (E) on tool.
7. Replace belt guard (B) making sure it is not normally replaced.
Insert brush roll through 3-30.
3-35 F
E
2. Turn agitator, making sure not to remove. 3.
Remove belt from turbine pulley (F).
Remove bottom plate, belt guard and brush roll as described in guard. The belt...
Manual - Page 13
... the motor cools for an automated referral of the motor.
Other performance factors include Hose Power (ASTM Test F558), Surface Litter Cleaning, Hard Floor Cleaning, Edge Cleaning, Cleaning Width and Air Filtration. What to buy
When purchasing edge groomers, ask for dirt accumulation.
3. only).
When the thermal protector activates, the cleaner will only result in North...
Manual - Page 14
... "Cleaner suction
low".
Low suction or pick up ". Check fullness of the dirt cup or removing the cartridge filter as described in the "Filter assembly" section. • Pre-filter clogged • Clean pre-filter as described in upright position
• Ensure that entire filter assembly is found :
A. Remove agitator shield and remove any blockage from hose. Note: Electrical...
Manual - Page 15
... is rendered.
1. however, if you mail your appliance to one full year from date of the following authorized warranty service outlets. If further assistance is needed, or if there are covered by presenting the appliance to a Hoover Factory Service Center for a period of one of purchase. Full One Year Warranty
(Domestic...
Similar Questions
Hoover Windtunnel Anniversary Upright Vacuum, Self-propelled, Bagged, U6485900
won't shut off
won't shut off
(Posted by patciam 9 years ago)
I Changed Belts But Suction Isn't Working
(Posted by goldiestevens 10 years ago)
How To Use Hoover Turbo Cyclonic Bagless Upright Vacuum Model Uh70055
(Posted by gambdianeb 10 years ago)
My Hoover Windtunnel T-series Pet Rewind Bagless Upright Vacuum Wont Turn On.
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
(Posted by megancorgan 11 years ago)