Hoover SH40060 Support Question
Hoover SH40060 Support Question
Find answers below for this question about Hoover SH40060.Need a Hoover SH40060 manual? We have 1 online manual for this item!
Question posted by MIdavec1 on July 22nd, 2014
How To Fix Hoover Canister Vacuum Cleaner Sh40060
The person who posted this question about this Hoover product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hoover SH40060 Manual Pages
Manual - Page 1
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. Questions or concerns? PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE. Owner's Manual
Operating and Servicing ...
Manual - Page 2
... product to speak with a customer service representative; CODE
Hint: Attach your HOOVER® product. Fri 8am- 7pm EST. Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5
Carton Contents...5 How To Use...6
Cleaner Description 6 Maintenance...8
Dirt Cup...8 Cyclone Separator 9 Filters...9 Clearing Blockages 11 Troubleshooting...
Manual - Page 3
...• Turn off this manual. Do not place product on cord. Do not place carpet cleaner on bottom of cleaner. • Do not leave appliance when plugged in areas where they may reduce air flow.... RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
• Fully assemble before operating. • Operate cleaner only at voltage specified on data plate on stairs. • Do not use to pick up ...
Manual - Page 5
... Push Hand Grip
D
(D) firmly into Power Nozzle. To
F
remove Wand from
cleaner, press release buttons (C) on
end of packing
materials. 1. Dirt Cup (packaged ...wand to disconnect from nozzle.
1.4 G
5 Actual model may vary from carton and
identify each item shown. Canister
1.1
B. A
Make sure all parts from images shown.
Push button (F) on Wand Release Button (G) and ...
Manual - Page 6
... pedal (A) on back of the vacuum cleaner. Do not exceed the cord length beyond the red mark.
2.4
Actual model may vary from room to room.
2.3
A
Cord Release/Rewind
2.4 To rewind the power cord, press the cord rewind button located at the rear of canister, to switch the cleaner on and press pedal again to...
Manual - Page 7
... furniture, stairs and baseboards.
Attaching Tools
2.8 Tools may be parked for grooming a pet
Storage
2.9 For convenience there is a parking slot located at bottom of the vacuum cleaner where the floor tool and hose can be used in tight spaces, corners, and along edges in injury or damage. Stair Cleaning 2.5
2.5 Clean stairs from...
Manual - Page 8
.... This blockage may seal the filter and cause a reduction in place. CAUTION ! NOTICE ! A Thermal Protector has been designed into your cleaner will stop running. If this type of personal injury, unplug vacuum before the dirt reaches the fill line.
! To reduce the risk of dust, empty the cup and clean the filters...
Manual - Page 9
...filter assembly with a towel or rag.
To reduce the risk of personal injury, unplug vacuum before replacing. and Post-Motor Filters can be checked and cleaned periodically depending on the ...filter.
3.8 Gently tap the filter on the dirt cup, and twist it clicks.
Allow to air dry for Hoover® Part No. 304285001.
9 Actual model may vary from dirt cup.
3.4 Dirt and debris can be ...
Manual - Page 10
... ! To reduce the risk of use any detergents or boiling water to air dry for Hoover® Part No. 304286001.
3.12
3.13
IMPORTANT
Both Pre- How to Clean
It ...hours before servicing. Actual model may vary from images shown. 10
Place Post-Motor filter back into rear of the vacuum cleaner. and Post-Motor filter should be rinsed in place.
3.10
3.11
When to Clean
3.10 The Post-Motor...
Manual - Page 11
...in , turn over to check for suction. Low suction or pick up may vary from the vacuum cleaner by pressing the release button on , and check hose end for blockages, continuing with each ...step until the blockage is found then reconnect the hose securely.
3.15 Plug cleaner in the system. Refer to the following steps to bottom. Remove any obstructions.
3.16 Remove ...
Manual - Page 12
...the dirt cup - electrical outlet securely.
2. The motor Thermostat may be incorrectly 3. Thermal Protector activated. 4. The accessory may be incorrectly installed.
2.
unplug cleaner before switching the vacuum cleaner back on cleaner base.
2. Refer to "OFF". 3. dirt cup - p. 9
2. The dirt cup may have tripped.
1. p. 9
1. Ensure that the plug is found by using the checklist...
Manual - Page 13
...; Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. If you . • For an automated referral of the vacuum.) PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
13 In Canada, contact Hoover® Canada, Toronto: 755 Progress Ave., Scarborough, ON M1H 2W7 OR Hoover® Canada, Edmonton: 18129...
Manual - Page 14
... be governed and construed under this Warranty or the availability of warranty service outlets, phone the Hoover® Consumer Response Center, Phone 1-800-944-9200, Mon-Fri 8am7pm EST. HOW TO ...products purchased in a commercial operation (such as warranted, take or send the product to a Hoover® Sales and Service Center for a full one way. you specific rights; This Warranty shall...
Similar Questions
Bh50140 Hoover Vacuum Cleaner
Need exploded view of by 50140 Hoover vacuum cleaner
Need exploded view of by 50140 Hoover vacuum cleaner
(Posted by Vlumba 8 years ago)
Need Owners Manual For U6425-920 Vacuum Cleaner
How can I get a manual for Hoover model U6425-920 vacuum cleaner?
How can I get a manual for Hoover model U6425-920 vacuum cleaner?
(Posted by alanz55 11 years ago)
Problem With Brush Bar Rotating For Hoover Sh40060
How can I get the brush bar on my SH40060 to rotate? It won't budge and makes a horrible sound when ...
How can I get the brush bar on my SH40060 to rotate? It won't budge and makes a horrible sound when ...
(Posted by Anonymous-44494 12 years ago)
How To Remove Agitator Bar On Sh40060 Hoover Vacuum
I need to change the belt on my SH40060 as it broke. How does the agitator bar come off?
I need to change the belt on my SH40060 as it broke. How does the agitator bar come off?
(Posted by agggilli 12 years ago)