Honeywell 6151 Support Question
Honeywell 6151 Support Question
Find answers below for this question about Honeywell 6151.Need a Honeywell 6151 manual? We have 1 online manual for this item!
Question posted by chungmyy2 on January 5th, 2012
Key Pad For Honeywell 6151. Need A Manual As To How To Use The Key Pad To Proga
Honeywell’s 6151 Fixed-English keypad
Current Answers
Answer #1: Posted by BusterDoogen on January 10th, 2012 11:14 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
There doesn't seem to be any instruction manual available, This is all they have at Honeywell. Good luck!
http://library.ademconet.com/MWT/fs2/2/5171.pdf
Related Honeywell 6151 Manual Pages
Installation Guide - Page 1
... screw-driver in the release snap),
then pull that side of the keypad
WWW.DIYWALWARMWFO.RUDM.ICOYM ALARMFORUM.COM The A, B, C, and D keys must be reported using the ECP address assigned to a single-
This feature should be pressed and held down for a more secure installation or when the on -board tamper switch detects removal of...
Installation Guide - Page 2
..., and then press
the bottom section down until it snaps into place
securely. See Figure 2. Connect the power/data wires to an electrical box using a screwdriver before mounting the case back. The 6151 allows seven items to the screw terminals on keypad PC board as shown in the case back (see Figure 2 for removal...
Installation Guide - Page 3
... step 6. Each expander address takes up by holding down the 1 and 3 keys for editing or viewing. disabled).
After that a unique address has been programmed for 3 seconds. d 1
8. Enter the keypad's local program mode within 60 seconds of power-up eight zones
(i.e., if using two 6151 s, zone 9 would be saved. Press [0] again to disable the feature...
Installation Guide - Page 4
... backup battery, use the following chart:
If Backlighting is loud, continuous, dual tone). www.honeywell.com/security
‡K6206V1EŠ
K6206V1 6/06 Rev. Display:
Fixed word LCD, ...keypad. On steadily
Use the 50mA current rating
Off when keypad is a fault that prevents data from Control Panel + Wired Zone 1 - Note: The keypad will display "OC" and beep periodically when there is Use...
Similar Questions
Ac Light Is Out On 1 Of 2 Of My Key Pad
recently my house alarm went off after lightning storm, but my alarm wasn't activated. I heard a lou...
recently my house alarm went off after lightning storm, but my alarm wasn't activated. I heard a lou...
(Posted by dfrank380 8 years ago)
Chime Bat Message On 6151 Key Pad.
when alarm is set then later on key pad will chirp with chime bat message
when alarm is set then later on key pad will chirp with chime bat message
(Posted by leewsr49 11 years ago)
How Do I Program The Address Of A Smoke Detector With The 6160cr-2 Key Pad?
(Posted by rthayer 11 years ago)