Haier HC125FVS Support Question
Haier HC125FVS Support Question
Find answers below for this question about Haier HC125FVS.Need a Haier HC125FVS manual? We have 1 online manual for this item!
Question posted by Matthewcruz88mc on August 22nd, 2017
Ptc Starter Replacement For Hc125fvs Haier Fridge
My fridge quit getting cold. I believe the ptc starter has gone bad. The ptc starter i have now is P6R8MC OR0606. And I'm having difficulty finding the correct replacement. Someone suggested the 312200500017 starter, however it looks different and I'm concerned. I also found the P470MC ORT1510. Looks identical but I realize that doesn't necessarily matter. Please help!
Current Answers
Answer #1: Posted by Odin on August 23rd, 2017 4:47 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
I can't identify a part for your fridge called starter or ptc starter. The most common causes/solutions of your problem applicable to your fridge are laid out at https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Refrigerator/51-198-682290-/Haier-Refrigerator-not-cooling-HC125FVS. The needed parts are also identified (and can be ordered there).
If the above does not suffice and you're intent on locating a "ptc starter," consider the suggestions at http://bit.ly/2xdVmEt.
If the above does not suffice and you're intent on locating a "ptc starter," consider the suggestions at http://bit.ly/2xdVmEt.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Haier HC125FVS Manual Pages
User Manual - Page 2
... all electric service cords that have become frayed or otherwise damaged. Always grasp the plug firmly and pull straight out from the outlet. 4) Repair or replace immediately, all of the instructions before using this appliance, always exercise basic safety precautions, including the following: 1) Use this appliance only for its length, the...
User Manual - Page 3
... center, take off the doors. Model number Serial number Date of the beverage center.
This easy-to your beverage center. You will guide you in getting the best use of child entrapment.
English
DANGER
Risk of your manual. Remember to obtain warranty service.
2
Before you for using our...
User Manual - Page 7
... plug adapters or cutting off the third grounding in any location not properly insulated or heated e.g. The marked rating of the extension cord must be corrected with proper grounding to power the beverage center.
• Avoid the use of potential safety hazards under certain conditions. garage etc. If it provides no...
User Manual - Page 8
Remove hinge cover screw. 2. Remove the top hinge cover. 3. Adjust the door or put a spacer in between and then tighten the
screws. 5.
Loosen the top hinge screws using a Phillips Head Screwdriver. 4. Replace the top hinge cover. fig. # 1
7 English
Door Alignment (see fig. # 1)
1.
User Manual - Page 9
... by turning counter clockwise. Insert and tighten the screws.(see fig. # 3) Tilt unit slightly back to the corresponding holes in the lower hinge bracket to replace the lower hinge support. Move the pin to the opposite hole and tighten. (see fig. # 3) Tilt unit slightly towards back and remove the lower hinge...
User Manual - Page 10
... in the upper hinge bracket but forms a tight seal. Replace the hinge cover, insert the screw and tighten completely. (see fig. # 1)
10. Adjust the door as needed. English
9. spacet door pin
fig. # 3
lower hinge bracket ...
User Manual - Page 11
Gently tilt the shelf up and slide forward until the shelf has been
completely removed. 2. To replace the shelf, gently slide the shelf back.
Turning the dial to your needs.
(Note: If the beverage center has... to OFF stops cooling in .)
6
5
fig. # 5
4
located on right side
Beverage Center Interior Shelves
To remove or replace a full-width slide-out shelf: (see fig. # 6) 1.
User Manual - Page 12
.... Simply flip the shelf as shown in .
6
fig. # 8a
5 4
fig. # 8b
11 To replace cover, insert the back slots into the casing (see fig. # 7) 1. Unscrew the bulb and replace it out (see fig. # 8a). fig. # 7
Light
• To replace burnt-out bulbs, remove the temperature control knob by pulling it with a new one...
User Manual - Page 13
... security, should you choose. English
Lock and Ley
• Your beverage center is equipped with a lock and key (located at the bottom center of the refrigerant circulating through the cooling coils.
• The thermostat control will click when it cycles on and off.
12 Simply close the beverage center door, insert...
User Manual - Page 16
...
high temperature and humid days. • Doors may have been opened frequently or for an extended
period of the beverage center: • This is too cold, adjust to a warmer setting
and allow several hours for temperature to maintain constant temperature during high humidity periods. • Prolonged or frequent door openings. •...
User Manual - Page 17
...such components caused by mechanical abuse or improper handling or shipping will be covered.
Haier America New York, NY 10018
16
The mechanical and electrical parts, which vary, ...sealed system are rendered.
Any mechanical or electrical part that repair is not appropriate or replacement part is determined that proves to state. Damage from service by the customer.
3....
Similar Questions
Compressor Relay
unable to purchase model HC125FVS compressor relay # P6R8MC ORO605 is there a replacement number I c...
unable to purchase model HC125FVS compressor relay # P6R8MC ORO605 is there a replacement number I c...
(Posted by dcedarholm 2 years ago)
Start Relay For Hc125fvs Model. Part P6r8mc Or0608
Can't find a start relay for hc125fvs
Can't find a start relay for hc125fvs
(Posted by Jwills 6 years ago)
My Haier Bev.ctr. Hc125fvs Wont Cool
The compressor gets hot to the touch and every few minutes i hear a click from the electric box atta...
The compressor gets hot to the touch and every few minutes i hear a click from the electric box atta...
(Posted by jcorso 7 years ago)
1.7 Cubic Inch Fridge I Received Works But Won't Get Cold.
1.7 cubic inch fridge I received works but won't get cold. The white cord in rear is loose. I'm pret...
1.7 cubic inch fridge I received works but won't get cold. The white cord in rear is loose. I'm pret...
(Posted by awe 12 years ago)