Home » Genie » Garage Door Openers » Genie SilentMax 1000

Genie SilentMax 1000 Support Question

Find answers below for this question about Genie SilentMax 1000.
Need a Genie SilentMax 1000 manual? We have 1 online manual for this item!

Genie Overview Questions Manuals Reviews Videos Research

Question posted by bijuusa1970 on September 22nd, 2014

How Many Closed Confirm Remote Cane Be On A Single Opener. Homw To Use Or Operat

operations of remote buttons and closed conform remotes.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TechSupport101 on September 22nd, 2014 10:06 AM

This answer was accepted by the poster of the original question.

TechSupport101

Member since:
May 24th, 2013

Points: 12,171,305

1,100
points

Hi. Up to seven remote-operated devices can be programmed into one of the Genie legacy Intellicode garage door openers.

www.satechhelp.co.za

Related Genie SilentMax 1000 Manual Pages

Owner's Manual - Page 1

...door. For use only with a one piece overhead garage doors. GARAGE DOOR OPENER MODELS PowerMax® 1200/1500, SC 1200/1500, TriloGTM 1200/1500, PowerLift® 900, GPowerTM 900, SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200 SCREW/BELT/CHAIN DRIVES OPERATION & MAINTENANCE MANUAL Includes INTELLICO®DE 2 Remote...® System must be installed to close door.

Owner's Manual - Page 2

...use. No warranty is made that they comply with all United States and Canadian legal requirements as of the date of Powerhead Controls 5 Travel Limits Closing Garage Door (DOWN Limits 6 Opening Garage Door (UP Limits 7 Wall Console Overview 8 Series III Wall Consoles with Black Buttons... stipulée indiquant qu'ils sont conformes à toutes les prescriptions juridiques d'autres...

Owner's Manual - Page 3

... Information OVERVIEW OF POTENTIAL HAZARDS READ THIS SAFETY INFORMATION CONVENTIONS USED IN THESE INSTRUCTIONS Garage doors are large, heavy objects that move with the door opener. tion, call your local Genie® Factory Authorized Dealer. • DO NOT install operator on , or next to the door before removing opener cover. This is the safety alert symbol. If you...

Owner's Manual - Page 4

... of contact with : Open/Close, Sure-Lock™, and independent light control buttons. LED indicator lights on the powerhead and on page 11. Used during a power failure or other emergency to allow the door to the programming instructions on the STBs provide a self-diagnostic code if an operational problem exists. Refer to close the door for much safer...

Owner's Manual - Page 5

....) 1. INTRODUCTION Now that the door opens and closes properly and all remote devices operate correctly. "TRAVEL LIMITS" 2. "REMOTE PROGRAMMING" Term Definitions: Travel Limits programming allows you will want to program the opener so that your garage door opener for operation: 1. NOTE: The 3 programming buttons are unlikely to operate the opener once the Required Programming section...

Owner's Manual - Page 6

... 1 2 1 2 Press and hold the down arrow button (-) for correct wiring or the Sure-Lock switch may be engaged to property. • DO NOT operate this unit from wall console before LIMITS are set. Closing Garage Door (Down Limits) 1 Lift the door open by hand until garage door is ON. NOTE: Before setting limits confirm wall console red indicator light (or...

Owner's Manual - Page 7

... to avoid contact with garage door closed ) limit is programmed. 8 Press and hold the up arrow button (+) and the round LED will begin flashing. PROGRAM SET - SET HOLD 2 seconds 7 Release up arrow button (+) for 2 seconds until door is programmed. PROGRAM PROGRAM - + ET G999-393 Manual-ScrewBeltChain-EN indd 7 The UP (open) limit is fully open, then release. PROGRAM...

Owner's Manual - Page 8

... and close garage door. In your carton you will display Red when wall console is properly wired and Sure-Lock™ is ON, the powerhead cannot be activated by the wall console or a remote. • Press and release (or until this button is completely closed . W B/W - Independent Light Control Button Use this button to open or close door. Open/Close Button Opens and closes door from...

Owner's Manual - Page 9

... on the Wall Console. FORCE AND SPEED CONTROL ARE NOW SET. Repeat step 10 to close and close your garage door using the Wall Console Open/Close button. 13 Close the garage door using the Open/Close button on the powerhead will clear the lights. Repeat this manual (pages 18-19). 10 Open and close the garage door for the ﬁrst time automatically sets the Force needed until...

Owner's Manual - Page 10

... have 30 seconds to execute each step. PUL PROGRAM - + HOLD 2 seconds 15 Release the Program Set button (the long LED begins flashing purple). 3 Required Programming REMOTES / New Intellicode 2 Openers NOTE: The following these steps. 14 Press and hold Remote too close to the Powerhead when programming Remote buttons. (continued next page) 7/13/12 10 17 AM This...

Owner's Manual - Page 11

... for other garage door openers, repeat the steps above using one of the other two Remote buttons. To program the same Remote for three door openers. NOTE: For Car2U and HomeLink, park the car outside the garage with the ignition key in the HomeLink® instruction manual. 19 Press and release the same button on the remote (the door should open or close). to connect...

Owner's Manual - Page 13

... Remote will not activate the door opener. NOTE: When the remote is cleared, press a remote button that the memory is pressed the round LED will flash blue but will not activate the door opener. Your opener will no longer recognize any signal received from the Powerhead memory will operate normally using the Wall Console. NOTE: The garage door opener will clear ALL programmed Remotes...

Owner's Manual - Page 14

... the logo preset to Intellicode® 1. 1 Select a Remote button NOT already programmed to your Genie® instructions for this Intellicode® 1 model of Genie® garage door openers .The default Intellicode® 2 setting must be opened to Intellicode® 1. If you use an external receiver, it may need to be opened . Once the LED on the transmitter is...

Owner's Manual - Page 16

... door is closed. The door should remain stationary or move freely and smoothly. • Raise door manually about 3' to 4' feet and let go to STB connection in sight and away from drive system. • Raise and lower the door manually-it while operating the console. 6 Maintenance and Adjustments If you have your garage door Owner's Manual. Test opener monthly. Use...

Owner's Manual - Page 17

... Disengaged Engaged - Compact CFL's may also be used. - Note: The opener will re-attach itself to door opener. • Test light operation. To disengage bullet from carriage, pull down and toward the opener. Disconnect power to carriage. Open remote case using a remote or wall console. - Align components and snap case closed. (continued next page) 17 G999-393...

Owner's Manual - Page 19

... Red Red Green Green Red LED LED LED LED LED LED Three Door Garage Single Garage Door • Determine which side of door components and tracks. There are pre-programmed at the factory for the maximum speed. PROGRAM SET 4 Press either until both the Open and Close directions, to increase speed. SEE CHART IN NEXT COLUMN. Flashes BLUE...

Owner's Manual - Page 21

.... • Check all remotes from www.geniecompany.com • Check if limits are properly set . See page 17. • Eliminate possible competing signals (satellite radio, FiOS® TV). See pages 8-9. • Check garage door for binding. • If an operational problem exists, and opener will only open . • Check if limits are properly set with button push -

Owner's Manual - Page 22

... TO DO • Be sure all door fasteners are tight. • Be sure garage door is in good repair, properly lubricated and balanced. • Be sure opener is less than 6-feet, opener configures programming for one-piece door is lowest speed setting. • If carriage travel . Door opener runs slow. • Check operating condition of Safe-T-Beam® pair...

Owner's Manual - Page 23

... use, cost of any replacement part(s) or replacement Product also at purchaser's expense) Seller may use...: _____ DATE PURCHASED SERIAL NUMBER OPENER MODEL: _____ REMOTE CONTROL MODEL: _____ DEALER NAME:...SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200, PowerMax® 1200/1500, SC 1200/1500, TriloG™ 1200/1500, PowerLift® 900, or GPower™ 900 garage door openers...

Owner's Manual - Page 24

... available at your garage door close properly • Network Adapter required Easy operation at Home Improvement outlets and other remotes or wall buttons Check out NEW ACCESSORIES and PRODUCTS; G999-393 Manual-ScrewBeltChain-EN indd 24 ™ 7/13/12 10 17 AM Closed Confirm™ Wireless Remote (Works with flip-up cover • Controls up to 3 openers • Large, easy...