Genie GPower 900 Support Question
Genie GPower 900 Support Question
Find answers below for this question about Genie GPower 900.Need a Genie GPower 900 manual? We have 1 online manual for this item!
Question posted by cuznrik on April 15th, 2013
Genie 900 Safety Beam Flashes Red Other Green. Round Red Flashes On Unit
The person who posted this question about this Genie product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Genie GPower 900 Manual Pages
Owner's Manual - Page 1
...: LEAVE THIS MANUAL WITH HOMEOWNER
WARNING
To reduce the risk of Lear Corporation. ©The Genie Company 2012 PN#38209501773, 9/2012 38209501773 GARAGE DOOR OPENER MODELS PowerMax® 1200/1500, SC 1200/1500, TriloGTM 1200/1500, PowerLift® 900, GPowerTM 900,
SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200
SCREW/BELT/CHAIN DRIVES...
Owner's Manual - Page 2
...Safety Notifications 3 Important Safety Instructions 3 Infrared Protection Function 3
F3eatures
Safety 4 Opener 4
R4equired5Progra6mming
Introduction 5 Overview of Powerhead Controls 5 Travel Limits Closing Garage Door (DOWN Limits 6 Opening Garage Door...ndern. No warranty is made that
they comply with all United States and Canadian legal
requirements as of the date of ...
Owner's Manual - Page 3
...and adjustments must be fully grounded. 1 Safety Information
OVERVIEW OF POTENTIAL HAZARDS
READ THIS SAFETY INFORMATION
CONVENTIONS USED IN THESE INSTRUCTIONS Garage doors are large, heavy objects that move with...
release within reach, but a
avoiding contact with the door opener.
tion, call The Genie® Company or your local Genie® Factory Authorized Dealer.
• DO NOT install...
Owner's Manual - Page 4
...PROTECTION FUNCTION
1. The Safe-T-Beam® has no motion. 4
opener features
INTELLICODE® 2 Access Security System A new generation superior encryption system that all models) Some units have been completed. Wall Console Operates door opener from inside garage. Check that enhances the security of the door opener by
a person or obstacle, the garage door will stop and reverse a closing...
Owner's Manual - Page 5
... on the powerhead. The following information will take you through programming your Genie garage door opener is preset at the factory.
These buttons should NOT be used to operate the opener once the Required Programming section has been successfully completed.
INTRODUCTION
Now that the door opens and closes properly and all remote devices operate correctly. "TRAVEL LIMITS...
Owner's Manual - Page 6
...solid red or flashing LEDs on floor, then release.
NOTE: Before setting limits confirm wall console red indicator light (or backlight) is ON. Closing Garage Door (Down Limits)
1 Lift the door open by hand until the shuttle/bullet
engages the carriage on blue (round LED.../bullet has NOT been engaged to the opener can restart as many times as necessary to property.
• DO NOT operate this...
Owner's Manual - Page 7
....
6 Press and hold the up arrow button (+) for
2 seconds until door
is fully open, then release.
PROGRAM
PROGRAM
- +
SET
The DOWN (closed is programmed. HOLD
Opening Garage Door (Up Limits)
NOTE: Beginning with powerhead. PROGRAM
SET
-
9 Press and release the Program Set button (both
LEDs flash blue and go off). Watch carriage as it approaches the...
Owner's Manual - Page 8
... Press and release to open or close garage door. Powerhead lighting will remain ON until red light goes off
Open/Close Button Use this light is pressed again or a door action has been completed.
Note: If opener has a Motion Detector sensor, it will CLOSE the door only.
LOCK disables controls
after
door is ON, indicator light flashes.
B/W
-
Independent Light Control...
Owner's Manual - Page 9
.... Repeat this manual (pages 18-19).
10 Open and close your garage door. For further help, refer to the oor. ...Red LED lights on the Wall Console.
Repeat the Setting the Down Limit steps 1-5 to make certain the door is fully set DOWN limits.
Force and Speed Limits are factory programmed and automatically set themselves when you use the Wall Console to open and close the garage door...
Owner's Manual - Page 11
...
on the remote
(both LED's flash blue and then turn off). PROGRAM
IMPORTANT: Your HomeLink® device
will ONLY respond to Genie mode.
to connect to your Intellicode remote when it's searching
SET
- To program the same Remote for three door openers. Each Remote can be programmed for other garage door openers, repeat the steps above using...
Owner's Manual - Page 12
.... 12
1.
Press the Program key . 3.
Resetting PIN
If you must start the opener while the door is ready for programming. Press and hold Program Set key for 5 seconds or until backlight goes off (30 seconds)
NOTE: Rapid blinking of the red LED on steady. Enter your new PIN, press Program key . Note: For...
Owner's Manual - Page 13
...
HOLD 2 seconds
2 Release the Program Set button, round LED goes
off and the long LED flashes purple. NOTE: When the remote is cleared, press
a remote button that was previously programmed to the Powerhead.
NOTE: The garage door opener will clear ALL programmed Remotes and wireless Keypads.
Your opener will no longer recognize any signal received from...
Owner's Manual - Page 14
... on the Remote turns RED when the button is pressed, that button is programmed to the Intellicode® 1.
3 Find the Learn Code Button and Learn Code Indicator LED
on the Opener
turns OFF).
14
Once the LED on the Remote back to GREEN for this Intellicode® 1 model of Genie® garage door openers .The default Intellicode...
Owner's Manual - Page 16
... enough from another Safe-T-Beam® unit
(for multiple door installations). • No STB red or green LED displayed. - KEEP DOORS PROPERLY BALANCED. Have a trained door system technician make repairs to prevent contacting it while operating the console. Locate wall console within sight of travel, retest door opener. Check wiring and wire connections. The door should stop and
reverse...
Owner's Manual - Page 17
... the door. To disengage bullet from carriage, pull relaese handle down and back towards opener and let go )
• Chain/belt drive models: Verify bullet is installed and Limits are not pinched or
near moving parts.
1. Remote Battery Replacement Replace remote battery with greater than 100 Watt rating, PowerLift® 900, GPower™ 900 require...
Owner's Manual - Page 19
... LED ROUND LED
RED
RED
PURPLE
PURPLE
BLUE
BLUE
Note: One-piece doors are automatically set to confirm setting.
Speed Adjustment
Action
1 Press and hold for OPENING travel will cross. • Place the Source (Red LED) Safe-T-Beams on the direct sunlight side
Multiple Garage Doors • NEVER position Safe-T-Beam modules where signals will display.
BLUE BLUE
OFF Flashes...
Owner's Manual - Page 21
... page 17. • Reposition door opener antenna.
• Remote LED does not come ON with the garage door hardware or springs, contact
The Genie Company at 1-800-35GENIE. Door starts down , then STOPS before it is flashing. • Check Safe-T-Beam® system for beam obstruction or misalignment of lenses. • Check garage door for normal operation. Door starts up . DO NOT...
Owner's Manual - Page 22
... AM
Door opener runs slow.
• Check operating condition of Safe-T-Beam® pair and nearest other Safe-T-Beam® pair, see pages 10-11. No response from unit.
Safe-T-Beam® physical obstruction. Remove obstruction, recheck unit. POWERHEAD LEDS
Powerhead LED
Round LED
Long LED
OFF
OFF
ON/RED/ STEADY
ON/RED/ FLASHING
ON/BLUE/ FLASHING
ON/PURPLE/ FLASHING
ON/RED...
Owner's Manual - Page 23
...Genie Company ("Seller") warrants to the original purchaser of the below identified, SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200, PowerMax® 1200/1500, SC 1200/1500, TriloG™ 1200/1500, PowerLift® 900, or GPower™ 900 garage door openers... originally installed
** The Core Unit consists of the powerhead, wired wall control, Safe-T-Beam® system, J-Arm and...
Owner's Manual - Page 24
...; Network Adapter required
Easy operation at Home Improvement outlets and other remotes or wall buttons
Check out NEW ACCESSORIES and PRODUCTS;
can open door without remote • Lighted keypad with Revolution Series 1500, 1200 and 1000 Models)
• Sleek and compact design
• Beeps and flashes green when garage door closes. Genie-Net™ technology "tells" you!
Similar Questions
My Promax 1500 Garage Door Opener Not Working.3 Lights Flashing On Unit.
(Posted by cwestsupra 9 years ago)
Hi ..our Genie Door Opener 900 Is Slamming Down Very Hard . What Can We Do? Than
(Posted by Spkelly2005 9 years ago)
How To Program Genie Garage Door Opener Gpower 900 Videos
(Posted by dondJAN 9 years ago)
Why Is The Garage Door Opener Has Red Blinking Lights And Does Not Operate?
(Posted by aysegogini 10 years ago)
Need Owner's Manual For Genie 900 Series Garage Door Opener To Program Remotes.
(Posted by JAmaro 11 years ago)