Garmin GPSMAP 4012 Support Question
Garmin GPSMAP 4012 Support Question
Find answers below for this question about Garmin GPSMAP 4012 - Marine GPS Receiver.Need a Garmin GPSMAP 4012 manual? We have 8 online manuals for this item!
Question posted by skipperbob6 on September 16th, 2014
4012 Vs 4212
What is the difference between 4012 and 4212?
Current Answers
Answer #1: Posted by TommyKervz on September 17th, 2014 3:39 AM
Related Garmin GPSMAP 4012 Manual Pages
Installation Instructions - Page 1
...1020. or contact Garmin Product Support by phone at most marine dealers. Before installing your GPSMAP 4000/5000 series chartplotter, confirm that the package contains ... In Europe, contact Garmin (Europe) Ltd.
If you must : 1. Mount the GPSMAP 4000/5000 series chartplotter (page 1). 2. Mount the GPS antenna (page 5). 3.
Tools required (not included): • Drill and drill bit...
Installation Instructions - Page 5
... -
GPS 17x • Can be surface mounted or pole mounted.
OK Radar
3 ft. (1 m) VHF Radio Antenna
GPS 17x Placement Considerations
GPSMAP 4000/...GPS antenna provides more-stable readings when located nearer to identify the included antenna and follow the correct mounting directions and the correct wiring directions for the antenna included with other electronics, try a different...
Installation Instructions - Page 6
....
3.
Mark the center of each mounting hole with marine sealant. Attaching the Pole-mount Adapter to the GPS 17: 1. To attach the enclosed pole-mount adapter to the GPS 17
Align Notch GPSMAP 4000/5000 Series Installation Instructions
If you can surface mount the GPS 17 antenna or install it on a standard 1 in . (19 mm...
Installation Instructions - Page 7
... on a standard 1 in. Place the cable in . OD pipe-threaded-pole marine mount (14 threads per inch-not included). Fasten the pole mount to the boat if it to your NMEA 2000 network.
➋
GPS 17x antenna
➌
Rubber gasket
GPSMAP 4000/5000 Series Installation Instructions
Do not drill through the 1 in the...
Installation Instructions - Page 8
... a 3/4 in place ➋.
7. Fasten the marine mount to the GPS 17x antenna. Route the NMEA 2000 drop cable through . 3. The GPS 17x will not acquire satellite signals through the pole or outside the pole: 1. Place the GPS 17x in . Adhesive pads
Mounting surface
GPS 17x antenna
Under-deck mounting bracket
GPSMAP 4000/5000 Series Installation Instructions...
Installation Instructions - Page 9
... around the cable.
6.
Using a 1 1/4 in ) >
White (data out)
>
Wiring the GPSMAP 4000/5000 Unit and the GPS 17
>
GPS 17 GPS/WAAS
Sensor
GPSMAP 4000/5000 Series Installation Instructions
Refer to a Garmin Marine Network. Wiring the Power Cable
The GPSMAP 4000/5000 series chartplotter must be connected to the power cable. Note: If you want to the...
Installation Instructions - Page 12
...Marine Network Cable: • The Garmin Marine Network Cable has a locking ring that can connect a GPSMAP 4000/5000 chartplotter to a Marine Network with a GPSMAP 3000 series chartplotter: • They will share GPS 17 GPS...406), or an XM Weather receiver (GDL30/30A). • Garmin GPSMAP 3000 series chartplotters CANNOT share cartography data with the GPSMAP 4000/5000 series chartplotters.
&#...
Installation Instructions - Page 14
...
xxxxxxxxxxxxxxxxxxxxxxx
To transducer
GDL 30/30A XM weather receiver
Garmin GPSMAP 3000 series
chartplotter
Garmin GPSMAP 4000/5000
series chartplotter
Connecting a GPSMAP 4000/5000 Series Chartplotter to an Existing Garmin Marine Network
Note: When connecting a GPSMAP 4000/5000 series chartplotter to the power supply for the boat. Wire the GPS antenna and additional NMEA devices to the...
Installation Instructions - Page 19
...sources, and PC monitor output (4008/4208/4010/4210/5008/5208 = VGA output, 4012/4212/5012/5212/5015/5215 = XGA output). Sound from a video source must be attached...multi-sync capability.
➌ ➋ ➊
Pin 2
Pin 1
Pin 7
Pin 17
Marine Video Cable End View
Note Connector Pin
Function
➊
RCA-1 Center
2
Video 1 in (...GPSMAP 4000/5000 Series Installation Instructions
19
Installation Instructions - Page 20
.../5000 series chartplotter may damage the pins. Making the Final Connections to the GPSMAP 4000/5000 Series Chartplotter
After the power cable and the GPS antenna (as well as any optional Garmin Marine Network devices, NMEA 0183 devices, NMEA 2000 connections, or video connections) are seven connectors on the back of the chartplotter...
Technical Reference for Garmin NMEA 2000 Products - Page 4
...-Certified Display Device PGN Information...13
GPSMAP 4000/5000 Series Chartplotters...13 GMI 10...14
NMEA 2000-Certified Sensor PGN Information...15 GPS 17x (GPS Antenna)...15 GFS 10 (Garmin Fuel... With a Garmin Chartplotter or Marine Instrument...19 Changing the Fuel Economy Source...19 Using Fuel-Level Information With a Garmin Chartplotter or Marine Instrument...19 Configuring Engine and Tank...
Technical Reference for Garmin NMEA 2000 Products - Page 19
...(when calibrated using a Garmin chartplotter or marine instrument)
Intelliducer (Intelligent Depth Transducer-Transom Mount and Thru-Hull)
Transmit
Receive
059392 ISO Acknowledgement
059392
ISO Acknowledgement
060928 ... for Garmin NMEA 2000 Products 15 GPS 17x (GPS Antenna)
Transmit
Receive
059392 060928 126208 126464 126992 126996 129025 129026 129029 129539 129540
ISO Acknowledgment...
Technical Reference for Garmin NMEA 2000 Products - Page 23
...remaining fuel based on the unit to all available fuel-level instruments and sources. Select either GPS Speed or Water Speed to specify which speed sensor is shown on the GFS 10 for ...level in the fuel tank or tanks. Using Fuel-Level Information With a Garmin Chartplotter or Marine Instrument To receive fuel-level information, connect the wiring harness on your boat according to the GFS 10 ...
Important Safety and Product Infomation (Multilingual) - Page 2
...and maps. Important Information
MAP DATA INFORMATION: One of the goals of
Battery Warnings Your GPS unit may use an internal, non-userreplaceable battery for more information. We use a combination... in an accident or collision resulting in
recycled. Official government charts and notices to mariners contain all data sources contain some inaccurate or incomplete data. NOTE: Refer to your...
Owner's Manual - Page 4
...On or Off 2 Initializing Unit Settings 2 Adjusting the Backlight 3 Acquiring GPS Satellite Signals 3 Inserting and Removing SD Cards 4 Restoring Factory Settings ...Tracks 12 Using BlueChart g2 Vision 14 Using Mariner's Eye 3D 14 Using Fish Eye 3D... Contact 49 Viewing the DSC List 50 Receiving Distress Calls 50 Man-Overboard Distress Calls ...GPSMAP® 4000/5000 Series Owner's Manual
Owner's Manual - Page 8
... as waypoints, routes, and tracks to the original factory settings. Card label
GPSMAP 4010 and 4012
Card label GPSMAP 4008 and 5000 series
Restoring Factory Settings
You can view the software version, ... Mode
Simulator Mode turns the GPS receiver off . You may need this information to update the system software or to navigate using Simulator Mode because the GPS receiver is located on : 1....
Owner's Manual - Page 13
..., fishing, fuel, or sailing numbers.
• Cruising-turn the GPS Speed, GPS Heading, Depth, and GPS Position data bar on or off , land only, or blend. ...compass direction.
Select Wind to a destination. Tides/Currents-turns the display of marine service points on whenever you are navigating to toggle between True and Apparent wind...bars
GPSMAP® 4000/5000 Series Owner's Manual
Owner's Manual - Page 18
...the Navigation chart.
• Aerial Photos-provides a view of memory. Mariner's Eye 3D 14
Navigation Chart GPSMAP® 4000/5000 Series Owner's Manual provides an underwater 3D view ...on BlueChart g2 Vision-compatible Garmin GPS units. This setting is beneficial when trying to detailed marine charting, BlueChart g2 Vision has the following features:
• Mariner's Eye 3D-provides a view...
Owner's Manual - Page 39
...GPS location accuracy falls outside the userdetermined value.
Use the ROCKER (GPSMAP 4000 series) or onscreen keyboard (GPSMAP 5000 series) to an external fuel sensor, such as the Garmin GFS 10.
GPSMAP... you exceed a specified drift distance. sounds an alarm for your chartplotter to receive sonar information. Configuring the Chartplotter
Anchor Drag-set an alarm to sound when the...
Owner's Manual - Page 41
... and shared with every other chartplotter connected to the network. Using the Garmin Marine Network
Using the Garmin Marine Network
The Garmin Marine Network allows you can:
• Share GPS data from a GPS 17 antenna that are using a GSD 21 wired to a GPSMAP 3006/3010 chartplotter, data is wired to one chartplotter, with every chartplotter connected...
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
How To Install A Garmin Gfs 10 Garmin 4212 Gps
(Posted by ezpras 10 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 11 years ago)
No Signal From Antenna?
We feel we have wired the entenna int the gpsmap 4012 properly, but we are still not recieving a sig...
We feel we have wired the entenna int the gpsmap 4012 properly, but we are still not recieving a sig...
(Posted by CHRISSHELLY 12 years ago)