Dell PowerEdge 2950 Support Question
Dell PowerEdge 2950 Support Question
Find answers below for this question about Dell PowerEdge 2950.Need a Dell PowerEdge 2950 manual? We have 8 online manuals for this item!
Current Answers
Answer #1: Posted by MWatDell on September 25th, 2014 9:20 PM
MWatDell
Member since:
November 17th, 2011 Points: 306,490
Member since:
November 17th, 2011 Points: 306,490
Hi john84645
E1624 means the power supply redundancy is lost. In other words, 1 of your power supply is faulty. You can double check on the power supply indicator on the back of your server.
For your reference, please check out this manual on Page 22 and 118:
ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-2950_owner%27s%20manual_en-us.pdf
Hope this helps.
MW@Dell
Related Dell PowerEdge 2950 Manual Pages
Installing a SATA Optical Drive - Page 4
...the SATA drive installation kit.
The pins on the carrier fit into place. Replacing a PowerEdge 2950 or 2970 Optical Drive
NOTE: If you are replacing an existing IDE optical drive, you... side of the drive tray to release the interposer board connected to the optical drive. The PowerEdge 2900 and 1900 systems do not reuse the interposer board attached to lock it into the corresponding...
Installing a SATA Optical Drive - Page 5
... Drive in a PowerEdge 2950 or 2970 System
2 1
3
4
5
6
7
1 optical drive 3 interposer 5 SATA power cable 7 optical drive carrier
2 interposer release latch 4 SATA cable 6 carrier latch
Replacing a PowerEdge 1950 Optical Drive
NOTE... carrier align with the holes in the installation kit must be used with PowerEdge 1950 systems. If you are replacing an existing optical drive, do not reuse...
Installing a SATA Optical Drive - Page 7
... Owner's Manual.
6 Close the system.
Installing the SATA Optical Drive - PowerEdge 2970 or 2950
1 Insert the optical drive tray into the system until it is fully inserted... Manual.
7 Reconnect the system to the power supply connector. See "SAS Controller Daughter Card" in the PowerEdge 1950 2
1
3
4
6
5
1 SATA data cable 3 chipset shroud 5 SATA power cable
2 SATA_A connector on ...
Installing a SATA Optical Drive - Page 8
... bracket toward the front of the system until the bracket detaches from the chassis slots.
6 Route the SATA cable in the cable channel in the PowerEdge 2950 and 2970
1
2
3 4 5
1 SATA_B connector on the system board. See Figure 1-4.
7 Route the SATA cable along the top of the chassis and replace the cable retention...
Information Update - Page 1
Dell™ PowerEdge™ 2950 Systems
Information Update
Information Update - Page 3
... III Systems 9 Processor Upgrades - Contents
Non-Optimal Memory Configurations 5 PowerEdge 2950 III - New System Features 5
New Performance Features 5 New High-Efficiency Power Supply and Power Monitoring Features ... Safeguarding Encrypted Data 9 System Message Update 10 LCD Status Messages Update 15
Contents
3 Power 2950 II and PowerEdge 2950 III Systems 9 System Board Replacement -
Information Update - Page 5
...
New Performance Features
• Two dual-core or quad-core Intel® Xeon® 5400 Series and 5300 Series processors.
• 8-GB memory module support.
PowerEdge 2950 III - New High-Efficiency Power Supply and Power Monitoring Features
• Higher system efficiency on power conversion across workloads. • Baseboard Management Control (BMC) power...
Information Update - Page 9
...is installed, the system only recognizes and displays 63.75 GB during POST.
PowerEdge 2950 III Systems
PowerEdge 2950 III systems have added support for your system.
System Board Replacement - Support ... contents of quad-core Intel Xeon processors.
Safeguarding Encrypted Data
On PowerEdge 2950 III systems using Windows Server® 2008, you can use encryption programs, such as the ...
Information Update - Page 10
..., see
functionality.
WARNING: Only trained service technicians are authorized to store this recovery key. supported. System Message Update
Table 1-1 lists new system messages for the PowerEdge 2950 III system and the probable cause and corrective action when the message appears. "General Memory Module
Installation Guidelines"
in the Hardware Owner's
Manual.
10
Information...
Information Update - Page 15
... Help" in the system event log (SEL).
Turn off and active errors are displayed. The LCD messages refer to the system and restart the system. The SYSTEM NAME displays under the following conditions:
• The system is powered on the PowerEdge 2950 III system and the probable cause for each message. This message...
Information Update - Page 21
Table 1-5.
System Interrupts This field controls the interrupt assignment for the PowerEdge 2950 III system. Table 1-6. When set to minimize IRQ sharing among devices. NOTE: Systems that the operating system supports TPM. Changes take effect after the system ...
Information Update - Page 24
...diskette drive or USB memory key where the test log file is included in the list of operating systems on the Server OS Install tab. System Diagnostics Update
In the Customize window of the system diagnostics, the Log output file pathname ...Windows 2000
If you to a hard drive.
24
Information Update
This operating system is supported by the PowerEdge 2950 and 2950 II systems, but not by the...
Information Update - Page 27
目录
29
PowerEdge 2950 III 29 29 29 全新 I/O 30 30
内部 USB 30 USB 30
支持 8 GB PowerEdge 2950 III 32
PowerEdge 2950 II 和 PowerEdge 2950 III 32
32
33
LCD 37
40 Memory 40 CPU Information （CPU 42 Integrated Devices 42 System Security 44 Serial Communication 45
目录
27
Information Update - Page 29
POST Non-Optimal Memory Configuration Press F1 to continue or F2 for Setup （按 F1 F2
DIMM DIMM
PowerEdge 2950 III
全新性能
Intel® Xeon® 5400 系列和 5300 8 GB
BMC
信息更新
29
Information Update - Page 33
...;"。
Invalid PCIe card found in the Internal_Storage slot! DIMM
!!*** Error: Remote Access Controller 化失败 initialization failure *** RAC virtual...;新
33 Node Interleaving disabled!
表 1-1 列出了 PowerEdge 2950 III
表 1-1
信息
原因
纠正措施
Alert!
Information Update - Page 44
...;导致 TPM TPM 密钥。
设置为 Yes TPM TPM Security （TPM Off
44
信息更新 System Security
表 1-7 PowerEdge 2950 III TPM。
TPM Security（TPM TPM。
表 1-7.
Information Update - Page 46
Microsoft Windows 2000
System Build and Update Utility Microsoft® Windows® 2000 将位于 Server OS Install PowerEdge 2950 和 2950 II PowerEdge 2950 III
Customize Log output file pathname USB
46
信息更新
Information Update - Page 132
...; cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq
• RHEL 3 9 Intel Xeon 54xx proc/cpuinfo
RHEL 4
Microsoft Windows 2000
System Build and Update Utility Server OS Install OS OS Microsoft® Windows® 2000 PowerEdge 2950/2950 II OS PowerEdge 2950 III
Customize Log output file pathname USB
132
Information Update - Page 142
DIMM
!!*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be available... PCIe PCIe SAS
142 Memory configuration does not support Node Interleaving.
RAC
Invalid PCIe card found in the Internal_Storage slot! Node Interleaving disabled! 표 1-1 PowerEdge 2950 III
표 1-1
메시지
&#...
Information Update - Page 157
Microsoft Windows 2000
Microsoft® Windows® 2000 이 Server OS Install(서버 OS PowerEdge 2950 III 대신 PowerEdge 2950 및 2950 II
Customize Log output file pathname USB
157
Similar Questions
Dell Server Poweredge R710 Error Message Error 1
hi Good Day,we are having issue with our dell R710 with error message error 1 but we look up in OMSA...
hi Good Day,we are having issue with our dell R710 with error message error 1 but we look up in OMSA...
(Posted by jillustrisimo32 4 years ago)
How To Configure Raid In Dell Server Poweredge 710
(Posted by brandaniep 10 years ago)
How To Reset Error On 1624 On Dell Poweredge 2950
(Posted by listjames 10 years ago)
