Danby DAC12010E Support Question
Danby DAC12010E Support Question
Find answers below for this question about Danby DAC12010E.Need a Danby DAC12010E manual? We have 1 online manual for this item!
Question posted by Davidsturge on July 2nd, 2015
Ac Unit Not Blowing Cold Air
My DAC12010E is going into its 3rd summer and is no longer producing cold air. The temp is set at 62 degrees, but it is producing air that is similar to what I would get with a fan. I have cleaned the filter and looked for debris, which does not appear to be be blocking anything. Do these units need to be charged? I would be disappointed if only after 2 summers of use it did need a repair or a recharge. Please advise with suggestions. Thanks
Current Answers
Answer #1: Posted by Odin on July 2nd, 2015 6:31 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Danby DAC12010E Manual Pages
Product Manual - Page 2
... Danby TOLL FREE:
1-800-26-
(1-800-263-2629)
CAUTION: Do not leave a room air conditioner unattended in an enclosed, unattended space.
1
WELCOME
Thank you for "Through-the-wall" installation. NOTE: This unit is NOT designed for choosing a Danby Room Air Conditioner to read the instructions thoroughly and familiarize yourself with the following information, located on...
Product Manual - Page 3
...Fan only operation) Interior air outlet
Interior air inlet
Cabinet Exterior air inlet
Control Panel
Filter
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING
ELECTRICAL SPECIFICATIONS
1) All wiring must comply with the unit...NOT use an approved "air conditioner" extension cord only (available at 60°C temperature rating.
3) This 115V air conditioner uses 10 or less ...
Product Manual - Page 4
... property. Therefore, it is recommended that chosen setting.
2) The filter is cooling off cannot drip on control side of the unit. More frequent cleaning may cause basepan to overflow to your comfort needs and leave at that you have someone assist you during the installation of your air conditioner before installing or servicing.
SAVING TIPS Follow...
Product Manual - Page 5
... into the
shutter tabs on the side channel of the air conditioner, as shown in Fig. 3, using four (4) 3/8" screws.
2) Assembly of the Side Curtains to make some modifications for ample air circulation through the unit (See Fig. 2).
F) DO NOT install unit where leakage of the unit should be necessary to Cabinet. • Extend the shutter from...
Product Manual - Page 6
...
3) Completing the Installation • Cut the foam (non adhesive) sealing strip to fit the area of the
window sill that the air conditioner will rest on.
3/4" screws
• Carefully place the air conditioner into the window with the "L" shaped mounting bracket (on the "recessed" portion of the window frame. The bottom of the cabinet...
Product Manual - Page 7
... to clean the air conditioner filter (see page 9) Once the filter has been cleaned and replaced, depress the Check Filter button in 30min./1hr.
CHECK FILTER: The adjacent indicator light will resume to resume operation. increments. Once the program is on the electronic display, press both the "Temp/Timer"adjust arrows simultaneously to increase or decrease the Temperature setting in...
Product Manual - Page 8
... or degree Celsius. b) The main unit does not respond to program the main unit.
7 BATTERIES SHOULD BE REPLACED WHEN: a) No signal (beep) is capable of 8 meters (26 ft.) from one to the other , press and hold the left and right Temp/Timer buttons at the same time for 3 seconds. 7) Cancels current Timer ON/OFF settings...
Product Manual - Page 9
...°C). IMPORTANT: DO NOT forget to install the air filter. AIR FILTER REMOVAL: The air filter is not removed from the room air and may cause damage to the finish and deformation of plastic parts.
2) Never attempt to clean the unit by hand in a dry location.
CARE AND MAINTENANCE
CLEANING: When cleaning the air conditioner, be sure to turn the SELECTOR knob to...
Product Manual - Page 10
... Air conditioner will not operate. • No power to the unit.
• Check connection of mold, mildew, or algae • Clean unit ...FAN (only) operation until frost melts. • Remove and clean filter. proper unit capacity for a possible solution. Switch unit to unit.
4) Odors
• Formation of power cord to power source.
• Check fuse or circuit breaker. • Set...
Product Manual - Page 20
...your area.
Model • Modèle DAC8010E, DAC10010E, DAC12010E
For service, contact your nearest service depot or call the TOLL ...233;gional. To request service and/or the location of the unit.
Pour obtenir le service et/ou la localité de ...Ontario Canada N1H 6Z9 Danby Products Inc, Findlay, Ohio USA 45840 AIR CONDITIONER The model number can be found on the serial plate located ...
Similar Questions
Ar Ventilation Switch - Push Or Pull?
I have Danby DAC 12010E with a ventilation switch. Should I push or pull to stop the freash air comi...
I have Danby DAC 12010E with a ventilation switch. Should I push or pull to stop the freash air comi...
(Posted by raghavkarpal 9 years ago)
My Unit Is No Longer Filling With Water, Instead It Blows Cold Air A While And T
(Posted by k36saturn 10 years ago)
My Dandy A/c Does Not Drain Water Or Blow Cold Air Anymore.both Drain Plugs Empt
(Posted by patlawson12 10 years ago)
Why My Ac Unit Not Blowing As Cold As It Used 2? Need Coolant?
my ac unit dpac7008 not blowing as cold as it was a year ago and not cooling the room like it used t...
my ac unit dpac7008 not blowing as cold as it was a year ago and not cooling the room like it used t...
(Posted by tzone82 11 years ago)