Danby DAC12010E Support Question
Danby DAC12010E Support Question
Find answers below for this question about Danby DAC12010E.Need a Danby DAC12010E manual? We have 1 online manual for this item!
Question posted by raghavkarpal on June 25th, 2014
Ar Ventilation Switch - Push Or Pull?
I have Danby DAC 12010E with a ventilation switch. Should I push or pull to stop the freash air coming into the room?
Current Answers
Related Danby DAC12010E Manual Pages
Product Manual - Page 2
... following information, located on the manufacturers nameplate on the rear panel of the unit.
To contact a Customer Service Representative, call Danby TOLL FREE:
1-800-26-
(1-800-263-2629)
CAUTION: Do not leave a room air conditioner unattended in an enclosed, unattended space.
1 NOTE: This unit is NOT designed for general inquiries. If properly maintained, your...
Product Manual - Page 3
...air conditioner, use an approved "air conditioner" extension cord only (available at 60°C temperature rating.
3) This 115V air conditioner uses 10 or less nameplate amps and may be installed by a qualified electrician. See Table 2 for Fan only operation) Interior air outlet
Interior air inlet
Cabinet Exterior air... PART IDENTIFICATION
Fresh Air Ventilation Switch (open for receptacle...
Product Manual - Page 4
...Measuring Tape Carpenters Level
Your Room Air Conditioner is very efficient in ...air filter clean.
However, under normal conditions.
Your Danby appliance is NOT designed for the installation of your comfort needs and leave at that you have someone assist you during the installation of hardware kit against the corresponding model check list, prior to your air conditioner...
Product Manual - Page 5
... "L" shaped channel to the
top of the cabinet as shown in direct sunlight, it may fail to allow for safe, proper installation.
INSTALLATION
LOCATION
A) This room air conditioner is advisable to provide an awning over the unit. B) Make sure window and frame are identified (on a side of the...
Product Manual - Page 6
...PLEASE NOTE: Window applications come in the "L" shaped mounting bracket (Fig. ...Pull the window down until it may be positioned on top) positioned in front of the upper window sash. INSTALLATION (cont'd)
INSTALLATION INSTRUCTIONS (cont'd)
Window sash
3) Completing the Installation • Cut the foam (non adhesive) sealing strip to fit the area of the
window sill that the air conditioner...
Product Manual - Page 7
...to initiate the Auto On/ Auto Off timer.
5) The time you to prevent the room from four different fan settings;Low , Medium , High and Auto during the same program...appear in the LED display. Mode Selector Energy Saver
Fan Speed Power Button
While the Air Conditioner is complete, the air conditioner will be displayed in either "Celsius" or Fahrenheit" according to resume operation.
Cool...
Product Manual - Page 8
... batteries (included ). b) The main unit does not respond to program the main unit.
7 Continue pulling (gently) until the cover
separates completely from one to the other , press and hold the up ...or decrease arrow will adjust the time in order to set temperature D: Fan speed setting Control Buttons 1) Power switch. 2) Mode. 3) Fan Speed. 4) Energy Saver. 5) Auto-Timer. 6) Used to the other ,...
Product Manual - Page 9
... water and dry thoroughly before re-installing.
4) Store (covered) air conditioner in lukewarm water below 40°C). CARE AND MAINTENANCE
CLEANING: When cleaning the air conditioner, be sure to turn the SELECTOR knob to the OFF position and disconnect the power cord from the room air and may result in machine failure. It is recommended that...
Product Manual - Page 10
...8226; Check fuse or circuit breaker. • Set SELECTOR SWITCH to
position other than once, contact a qualified technician.
2)...the outdoors to allow • Unit must always be pushed in cooling mode.
tripped.
• Turn the unit...
service depot or Danby's Toll Free Number for assistance: 1-800-26-
(1-800-263-2629)
PROBLEM
POSSIBLE CAUSE
SOLUTION
1) Air conditioner will not operate....
Product Manual - Page 20
...;ciales sont disponibles à votre centre de service régional autorisé. AIR CONDITIONER The model number can be found on the serial plate located on the back ...recommend a depot in China (P.R.C.)
Danby Products Ltd, Guelph, Ontario Canada N1H 6Z9 Danby Products Inc, Findlay, Ohio USA 45840 Model • Modèle DAC8010E, DAC10010E, DAC12010E
For service, contact your nearest ...
Similar Questions
Dpac 8399 Not Working Properly Anymore
this dpac 8399 piece of crap only worked well for the first 2 weeks . It's throwing hot air out the ...
this dpac 8399 piece of crap only worked well for the first 2 weeks . It's throwing hot air out the ...
(Posted by marypetersone 9 months ago)
Ac Unit Not Blowing Cold Air
My DAC12010E is going into its 3rd summer and is no longer producing cold air. The temp is set at 62...
My DAC12010E is going into its 3rd summer and is no longer producing cold air. The temp is set at 62...
(Posted by Davidsturge 8 years ago)
Dpac12099 - Filter Question Plus Use Of Switch By Spec Plate
I have the Owner's Use and Care Guide and on Page 9 there are instuctions which are confusing regard...
I have the Owner's Use and Care Guide and on Page 9 there are instuctions which are confusing regard...
(Posted by bonbon9 9 years ago)
How Do I Set Up A Danby Dpa100a1gd Portable Air Conditioner
How do I set up a portable air conditioner? How does it drain?
How do I set up a portable air conditioner? How does it drain?
(Posted by Jujubeads 10 years ago)