Cub Cadet RT 65 Rear Tine Tiller Support Question
Cub Cadet RT 65 Rear Tine Tiller Support Question
Find answers below for this question about Cub Cadet RT 65 Rear Tine Tiller.Need a Cub Cadet RT 65 Rear Tine Tiller manual? We have 1 online manual for this item!
Question posted by juliegoss209 on July 12th, 2023
How To Replace Pull Rope
The person who posted this question about this Cub Cadet product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by SonuKumar on July 12th, 2023 9:04 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,618,310
Member since:
May 9th, 2021 Points: 16,618,310
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Cub Cadet RT 65 Rear Tine Tiller Manual Pages
Operation Manual - Page 1
... THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Rear Tine Tiller -
RT65
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. BOX 361131 CLEVELAND, OHIO 44136-0019...
Operation Manual - Page 2
...operation, or maintenance of product specifications for purchasing a Garden Tiller manufactured by standing at the operator's position and looking... Adjustment 14
Engine Maintenance 16 Service 20 Troubleshooting 21 Replacement Parts 22 Warranty Back Cover
Record Product Information
Before ... product information available at the time of the tine shield. Box 361131 • Cleveland, OH ...
Operation Manual - Page 3
...in this manual and on the machine and in serious injury or death.
California Proposition 65
WARNING! Training
1. Be familiar with a plastic liner. Children 14 and over and ...the safe operation practices in a safe place for future and regular reference and for ordering replacement parts.
2.
Keep this manual in this machine in handling gasoline. Preparation
1. Remove all...
Operation Manual - Page 4
... any damage before refueling. Maintain or replace safety and instruction labels, as on the ground. Important ...pulling machine towards you leave the operating position (behind and use care when in place and operating properly.
19. Rotating tines... occur which are not covered in the ground and propel the tiller forward. The tines may catch in this manual for an extended period.
4
Section...
Operation Manual - Page 6
ROTATING TINES Do not put hands or feet near rotating parts.
WARNING-GASOLINE IS FLAMMABLE Allow...before refueling. SAVE THESE INSTRUCTIONS!
6
Section 2 - WARNING- Contact with the rotating parts can amputate hands and feet.
ROTATING TINES Do not put hands or feet near rotating parts. HOT SURFACE Engine parts, especially the muffler, become extremely hot during operation. ...
Operation Manual - Page 7
...2. Insert the clevis pin through the tine shield assembly.
4. Secure it with the tiller (i.e., the Operator's Manual, etc.).
3. Roll or slide the tiller out of the depth stake assembly. ...washer on the floor. Tighten securely. Assembly & Set-Up
3
Contents of Carton
• One Tiller • One Depth Stake
• One Handlebar Assembly • One Operator's Manual
• ...
Operation Manual - Page 8
... the clutch bail. See Fig. 3-3. Figure 3-4
Fasten the threaded eyebolt onto the bail by securing it to check the clutch cable adjustment before operating the tiller. Thread the eyebolt and nut removed earlier into the internally threaded tube at the end of the handle and snap in position between the handle...
Operation Manual - Page 9
...Manual packed with oil and gasoline before checking this adjustment. See Fig. 3-5. Position the tiller so the front counterweight is needed. If the wheels do not spin with the previously ...to the Controls & Features Section.
2. Remove the hairpin clips from the control rod, put your tiller for proper fuel and engine oil recommendations.
1. Insert the longer end of the cable a few ...
Operation Manual - Page 12
...pulls slightly harder. See Figure 5-1. NOTE: When pushing the machine with the clevis pin and hairpin clip. Disconnect the spark plug wire and ground it against the engine before operating. Be sure that no one or two more detailed instructions. if equipped - To transport the tiller... control lever in their highest position.
5. Let the rope recoil slowly.
5. As the engine warms up sod ...
Operation Manual - Page 13
... highest position. 10. Select the wheel drive only. Section 5 - A partial engagement may be necessary when engaging the tines.
If it is stopped completely before engaging the clutch handle.
Make certain the tiller is recommended the garden be tilled twice (lengthwise, then widthwise) to one or two more passes over the area. 9. NOTE: Use...
Operation Manual - Page 14
...Maximum tire pressure under any circumstances is needed if the tines or wheels seem to cause serious injury. Equal tire pressure... cleaned and the gap reset every 25 hours of each tiller season; Maintenance & Adjustments
6
WARNING! Clean it against the...-lubricated and sealed at least once a season. Spark plug replacement is disassembled. Clutch Handle
Lubricate the pivot point on the ...
Operation Manual - Page 15
Remove the belt cover as described under Belt Replacement in the idler bracket.
5. Replace the spring washer and hairpin clip.
6. Disconnect and ground the spark plug wire against the engine.
2.
With the engine off and the clutch control bail ...
Operation Manual - Page 16
... performance is to be maintained. Engine Maintenance
7
Maintenance Schedule
Check Engine Oil Level Change Engine Oil Check Air Cleaner Service Air Cleaner Check Spark Plug Replace Spark Plug Clean around muffler
First 5 Hours
Each Use or Every 5 Hrs. Remove drain plug and allow oil to touch the muffler.
WARNING!
Every Season...
Operation Manual - Page 17
... this designation on the container.
more often if used oil. Replace paper element when dirty or damaged.
Air Filter
Paper filters cannot be cleaned and must be... replaced once a year or every 100 operating hours; Clean foam element or replace when damaged. NOTE: Please dispose of used motor oil in a manner...
Operation Manual - Page 18
... the Engine
If the engine has been running , the muffler will be securely tightened. Periodically remove dirt build-up from the paper element 4.
CAUTION! Using a garden hose or pressure washing equipment can become very hot and may damage the engine.
Inspect and clean before every use a spark plug wrench to cool...
Operation Manual - Page 19
...the oil. Touch up any damaged paint, and coat other fuel system components, serviced or replaced.
1. Tilting can cause fuel or oil leakage. Section 7 - Remove all fuel from... stops from forming in fuel system or on essential carburetor parts. See Changing the Oil earlier in storage. Replace spark plug and crank it slowly to have the carburetor, and other areas that may rust with a spark...
Operation Manual - Page 20
...engine storage instructions.
• Wipe the tines with a belt designed for storage. Figure 7-1
• Clean the exterior of the belt cover. Lubricate the tiller as instructed on page 2.
1. The... Engine Pulley
Figure 7-1
5. Service
8
Belt Replacement
Your tiller has been engineered with an oiled rag to prevent rust.
• Store the tiller in a clean, dry area.
Screws
4.
...
Operation Manual - Page 21
... level low. 2. Clevis pin missing. 2. Refer to authorized service dealer. 4. Clean, adjust gap or replace. 8. Drain fuel tank. Take tiller to the Engine Operator's Manual 5. Replace belt.
21 Blocked fuel line. 4. Dirty air cleaner. 3. Tine clevis pin(s) missing. 3. Clear vent. 5. Replace clevis pin. 2. Fuel tank empty or stale fuel. 2. Throttle control lever not in fuel...
Operation Manual - Page 22
...
Tires, 16 x 4.6 x 8
714-04043 911-0415 714-0147 911-0415
Cotter Pin, Tine Assembly Clevis Pin, Tine Assembly Cotter Pin, Depth Stake Clevis Pin, Depth Stake
951-10794
Air Filter
951-10292
Spark plug
Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have your full model number and serial...
Operation Manual - Page 24
...FOR
edgers, string trimmers & tillers
The limited warranty set forth...limitations may not apply to the parts as : batteries, belts, blades, tines, wheels and tires. Cub Cadet shall not be greater than the amount of... loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for rental expenses to applicable manufacturer's warranty for loss...
Similar Questions
I Have A Cub Cadet Bc 490 The Pull Rope Broke How Do I Rewind Both The Springs T
BC 490 Cub cadet rewinding both the springs so it will retract again
BC 490 Cub cadet rewinding both the springs so it will retract again
(Posted by Fishino3 7 months ago)
How Do You Put A Pull Rope On A Cub Cadet Bc490
How do you fix the pool rope on a BC 490 Cub Cadet weedeater
How do you fix the pool rope on a BC 490 Cub Cadet weedeater
(Posted by elicharmasson25 2 years ago)
How Do You Replace Pull Cord On Bc509 Weed Eater?
(Posted by Cdyess181971 8 years ago)