Cub Cadet RT 65 Rear Tine Tiller Support Question
Cub Cadet RT 65 Rear Tine Tiller Support Question
Find answers below for this question about Cub Cadet RT 65 Rear Tine Tiller.Need a Cub Cadet RT 65 Rear Tine Tiller manual? We have 1 online manual for this item!
Question posted by tt6452 on March 11th, 2015
Rt65 Tiller Pull Cord Stuck
Unable to start tiller. pull cord stuck
Current Answers
Answer #1: Posted by TommyKervz on March 11th, 2015 5:03 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,843
Member since:
January 10th, 2013 Points: 17,776,843
Follow the instructions on the link http://homeguides.sfgate.com/fix-pull-starter-cub-cadet-lawn-mower-102091.html
Related Cub Cadet RT 65 Rear Tine Tiller Manual Pages
Operation Manual - Page 1
...-0019
Form No. 769-05933 (February 22, 2010) RT65
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Printed In USA
CUB CADET LLC, P.O. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Rear Tine Tiller -
Operation Manual - Page 2
..., OH • 44136-0019
2 Review this manual may cover a range of the tine shield. Characteristics and features discussed and/or illustrated in this manual frequently to familiarize yourself... your complete satisfaction at the front right corner of product specifications for purchasing a Garden Tiller manufactured by standing at the operator's position and looking down at all times. ...
Operation Manual - Page 3
... with all persons, particularly small children and pets. HEED ITS WARNING! California Proposition 65
WARNING! Engine Exhaust, some of its constituents, and certain vehicle components contain or ...slacks and shirt. b. This machine is spilled on the machine and in the manual(s) before starting the engine.
4. Remove all instructions on yourself or your clothes which can be trained and...
Operation Manual - Page 4
...start making any damage before starting and operating.
12. Repair any adjustments, or inspections.
13.
Never tamper with the rotating parts can result in reverse or pulling...After striking a foreign object, stop before unclogging the tines, making an unusual noise or vibration, stop engine before... the ground and propel the tiller forward. Start the engine according to keep feet...
Operation Manual - Page 6
ROTATING TINES Do not put hands or feet near rotating parts. Contact with the rotating parts can amputate...parts can amputate hands and feet.
HOT SURFACE Engine parts, especially the muffler, become extremely hot during operation.
WARNING- ROTATING TINES Do not put hands or feet near rotating parts.
Your Responsibility-Restrict the use of this manual and on the machine. SAVE...
Operation Manual - Page 7
... tine shield...tiller out of the tiller are determined from behind the machine in the slot, under the tine shield and up through the tine shield and depth stake assemblies. Tip the tiller...tine shield assembly.
4. Remove the packing material.
5. Secure it rests on the tines.
7 Place the flat washer on the floor. Assembly & Set-Up
3
Contents of Carton
• One Tiller... the tiller (i.e., ...
Operation Manual - Page 8
... handle
mounting brackets.
6.
3. See Fig. 3-4.
Figure 3-4
Fasten the threaded eyebolt onto the bail by securing it to check the clutch cable adjustment before operating the tiller. Assembly & Set-Up Route the clutch cable to the right side of the cable. WARNING! handle mounting brackets, but do not remove the bottom bolt...
Operation Manual - Page 9
... - Insert the shorter, angled end of the cable a few turns counter-clockwise - Position the tiller so the front counterweight is needed. With the gear selection lever in the gear selector handle and secure... move the hex nuts at the end of the control rod through the hole in NEUTRAL, start the engine.
Section 3 - Control Rod
1. See Fig. 3-5.
Insert the longer end of...
Operation Manual - Page 10
... the engine with gasoline and oil as instructed in the separate engine manual packed with your tiller may be maintained on your tiller. WARNING!
WARNING! Read the instructions carefully. Reduce the tire pressure before operating the tiller. Never fuel the machine indoors or while the engine is extremely flammable and the vapors are...
Operation Manual - Page 11
... to select NEUTRAL, REVERSE, or one of the engine controls.
Any time the tiller is not in the OFF (vertical) position. Controls and Features
Gear Selection Handle...and functions of the FORWARD modes.
The primer is in the carburetor when starting a cold engine. Depth Stake
The handle may be adjusted to the ...tine drive mechanisms.
Throttle Control
The throttle control lever is used when...
Operation Manual - Page 12
... can be raised to the RUN position. Grasp the starter handle and pull out slowly, until the engine starts.
7. Allow it to the RUN position.
To adjust the depth stake...
3.
Stopping the Engine
To stop the engine, move to prevent accidental starting while the equipment is controlled by using the tiller for more passes over the area.
4. Place the side shields in ...
Operation Manual - Page 13
....
To adjust the side shields, remove the wing nuts. Tighten securely. Start the engine as instructed in the Engine Operator's Manual.
3.
Make certain the tiller is between gears, the engine will stall.
5. A partial engagement may be necessary when engaging the tines. Squeeze the clutch handle against the handle to the desired position and...
Operation Manual - Page 14
... under extremely dusty conditions. Lubrication
Transmission
The transmission is recommended at the start of the transmission on page 2.
Engine Adjustment
Refer to the Engine Operator... grease, lay the right half of each tiller season;
This grease can be serviced. Tine Shafts
Remove the tine assemblies and lubricate the tine shafts at your nearest authorized dealer by ordering...
Operation Manual - Page 16
...level performance is empty.
Transporting or tipping engine spark plug down may cause smoking, hard starting, spark plug fouling, or oil saturation of maintenance to drain oil, drain fuel from...service intervals and the kind of air cleaner. More frequent service is secure.
2. To prevent accidental start-up . Changing the Oil
NOTE: Be sure to touch the muffler. Be sure fuel fill cap...
Operation Manual - Page 18
...;4 turn after the spark plug seats to compress the washer. See Fig. 6-3. Do not spray engine with a spark plug wrench to compress the washer. Using a garden hose or pressure washing equipment can become very hot and may damage the engine. Inspect and clean before every use a spark plug wrench to touch...
Operation Manual - Page 20
...
recommended. Figure 7-1
• Clean the exterior of
Lubrication instructions. Lubricate the tiller as fertilizer. Screws
4. Belt
Belt Keeper
Idler Pulley Engine Pulley
Figure 7-1
5....Fig. 7-2.
Service
8
Belt Replacement
Your tiller has been engineered with a belt designed for the correct engine storage instructions.
• Wipe the tines with a non-OEM belt. Disconnect and...
Operation Manual - Page 21
... object lodged in gas cap plugged. 5. Not shifting properly.
5. Remedy
1. Connect wire to start position.
3. Connect and tighten spark plug wire. 3. Clear vent. 5. Refill with clean, fresh gasoline. 2. Refer to authorized service dealer. 4. Replace tine clevis pin(s). 3. Take tiller to the Engine Operator's Manual 3. Replace clevis pin. 2. Refer to the Operation Section for...
Operation Manual - Page 22
...-1117
Clutch Cable
934-04365
Tires, 16 x 4.6 x 8
714-04043 911-0415 714-0147 911-0415
Cotter Pin, Tine Assembly Clevis Pin, Tine Assembly Cotter Pin, Depth Stake Clevis Pin, Depth Stake
951-10794
Air Filter
951-10292
Spark plug
Phone (800) 965-4CUB to order replacement parts ...
Operation Manual - Page 24
... including, without limitation, expenses incurred for substitute or replacement lawn care services or for use or exposure. com. Refer ... LLC MANUFACTURER'S LIMITED WARRANTY FOR
edgers, string trimmers & tillers
The limited warranty set forth in this warranty provide the..., its Normal Wear Parts as : batteries, belts, blades, tines, wheels and tires. d.
Phone 1-800-668-1238
GDOC-100087...
Similar Questions
My Pull Cord Came Out Of My Ss470 Cub Cadet How Do I Replace It
(Posted by ncdwhite 8 months ago)
Csv 050 Can't Pull Cord.
can't pull cord to start. Jammed. No movement whatsoever. Used twice.
can't pull cord to start. Jammed. No movement whatsoever. Used twice.
(Posted by foxthg 7 years ago)
How Do You Replace Pull Cord On Bc509 Weed Eater?
(Posted by Cdyess181971 8 years ago)