Bosch HDS7132U Support Question
Bosch HDS7132U Support Question
Find answers below for this question about Bosch HDS7132U - 30" Dual-Fuel Range.Need a Bosch HDS7132U manual? We have 2 online manuals for this item!
Question posted by rfromme971 on February 24th, 2014
Gas Hookup Location On Back Of Range
The person who posted this question about this Bosch product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Bosch HDS7132U Manual Pages
Installation Instructions - Page 3
... door for Household Cooking Gas Appliances • CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators • CAN/CSA-C22.2 No. 61-M89 Household Cooking Ranges
English 1 Safety
IMPORTANT ... surface units, cabinet storage space located above the cooktop are engaged. Use caution when reaching behind
or under appliance.
• This appliance complies with range. Verify that cabinets above the ...
Installation Instructions - Page 4
... by a qualified tech- nician. English 2 show the owner the location of the circuit breaker or fuse. Save these instructions for use ....for this appliance and marked "for the local electrical inspector's use with ranges" shall be used.
• Installer -
If there is any ... or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. • The appliance must be...
Installation Instructions - Page 5
... switch. • Do not use any phone in your building. • Immediately call your gas supplier, call the fire department. It must be longer than 36 inches.
• Installer -...used.
• The appliance is being installed. • Shut-off valve is located.
• The propane gas tank must do the conversion. Exception: For use combustible materials, gasoline or other appliance
&#...
Installation Instructions - Page 6
...Additional Parts Needed For Hard Wire Installations
• Range Power Supply Cord Kit (240V -30 Amp) Note: Not necessary for Gas Leaks
7.
Test for Canadian installations; Apply Foam ...; T-20 Torx Screwdriver • Screws (2) and Anchors (2) for step-by-step instructions.
Connect Gas Supply
6. to the sections that follow for Anti-Tip Bracket (Style will vary depending on
mounting...
Installation Instructions - Page 7
... the drawer out until clip locks into
place. 4.
Tip: Place the range on the left rail. Locate locking clips on the rails, one on the right rail. Pull the drawer out until ...clip locks into range. Destroy the packaging after unpacking the appliance.
Push rails into
place. 5....
Installation Instructions - Page 8
... hinge slots. The power cord set shall be about halfway open or closed , be 120/240 volt, 30 amperes minimum. English 6 Do not grasp the handle as it stops. Open the door all the way.... oven door. The door front is heavy.
6. the hinge could result in a stable location.
Note: In Canada, the range is cool and power to grasp the oven door firmly and properly could result in place
...
Installation Instructions - Page 9
... controls are dual rated for use on .
Don't forget to determine amperage requirements.
Reference the kW rating in your home is preferred.
Check local codes for the kW rating. In some instances, the size of a three wire 120/240 or 120/208 volt, 30 AMP, 60 Hz AC circuit.
Gas Requirements
Installation
Ranges are...
Installation Instructions - Page 10
... off valve in Figure 5: Cutout Requirements - Note: The installer should inform the consumer of the location of combustible materials. This unit is designed for use with natural gas. Typical Installation
Allow a minimum of 30 inches between cabinets where range is shipped from the factory for installation near adjacent walls and projecting surfaces constructed of...
Installation Instructions - Page 11
...30 inches. Cabinets over the cooking surface and cabinets adjacent to be provided, the risk can also replace a freestanding range. In this case, verify that projects horizontally a minimum of 5 inches beyond the bottom of burns or fire by reaching over heated surface units, cabinet storage space located...24" deep. Installation
Note: The slide-in range can be reduced by installing a hood that...
Installation Instructions - Page 12
...range top to center of screw hole
floor
anti-tippin g device
Ventilation Recommendations
Figure 8: Anti-Tip Bracket
We strongly recommend the installation of flame retardant material which must be a minimum clearance of 30...obstructions (extra electrical or gas connections, etc.) so that range will rest against cabinet ...range walls to locate bracket position as shown in the walls or floor.
Installation Instructions - Page 13
...: Install Backwall Trim Strip
Backwall Trim Strip
Figure 9: Backwall Trim Strip
Back of cooktop trim in range backwall.
when replacing a free-standing range). Note: This step is only required if the countertop does not connect behind the range (i.e.; Installation Procedure
Installation
Apply Foam Tape Install Backwall Trim
Apply foam tape to underside of...
Installation Instructions - Page 14
... terminal block can be properly installed. DO NOT remove entire range back panel.
Feed range cord through hole and strain relief up to "Connect Gas Supply" on page 16. Strain reliefs vary. Three wire range cord
The four wire range cord connection is shipped from range, install strain relief in the cord between the strain relief...
Installation Instructions - Page 15
.... Figure 12: Grounding Requirements
WARNING:
To prevent electrical shock, the grounding prong on the range cord should not be cut or removed under any doubt as to whether the wall receptacle ... type receptacle and connected to be installed per instructions included with Ranges".
Use only cord kits rated 125/250 volts (minimum), 30 amperes and labeled "For Use with cord. If there is ...
Installation Instructions - Page 16
... and Wire
6. English 14
black
red
white
Figure 15: Four Wire Range Cord Connection (continued)
9. Note: DO NOT plug in range at top and
attach wide end to center post.
8. Properly secure ... ORDER to left post.
7. green ground screw
ground strap
ground wire
Figure 14: Four Wire Range Cord Connection -
Attach red wire, round washer, star washer and nut IN THIS ORDER to right...
Installation Instructions - Page 17
... THIS ORDER to the power supply via a three wire connection.
1. ground strap white
red
black
Figure 17: Three Wire Connection
English 15 Installation
Three Wire Range Cord Connection
The Four Wire Connection (above) is preferred, but where local codes and ordinances permit grounding through neutral and where conversion to four wire...
Installation Instructions - Page 18
.... If using rigid pipe or a CSA International-certified flexible metal appliance connector. Important note for LP users
Figure 19: Gas Connection Location
The range is a registered trademark of the range. For use with propane (LP) gas, your range must first be installed using a flexible connector, always use a new connector.
See "Install Strain Relief" on page 16...
Installation Instructions - Page 19
... Adjust leveling
leg until this height is ½" higher
than the corresponding countertop surface.
Adjust Leveling Legs
1. Line up range in Range Cord
1. Attach Connector
Installation
B C
A
Table 4: Flexible Connector Method
Letter
Item
A
Gas Shut Off Valve
B
Regulator
C
Flexible Connector
Figure 20: Flexible Connector Method
1. English 17 Make sure circuit breaker is...
Installation Instructions - Page 20
... • foam tape • floor under the anti-tip bracket. Tip: 1.
Check Back of the range is not resting on the countertop.
This could result in power cord. 2. If the back legs are resting... solidly on the floor or the left range leg is not under the anti-tip bracket, slide range out, adjust legs and slide back in. Be careful not to prevent damage...
Installation Instructions - Page 21
...location of the gas pipe stub.
Proceed to 3/4" Gas Pipe
Figure 22: Rigid Pipe Method
The configuration of the rigid pipe connection will vary depending on the floor. 3. Connect to regulator here Pipe Nipple Union Elbow
E
Gas Shut Off Valve
F
1/2" to "Test for Gas... way around.
2. The gas connection is level and plumb. 4. Rigid Pipe Method
Adjust Front of Range for examples. Use a ...
Installation Instructions - Page 23
... that the left leg is under the anti-tip
bracket.
This could result in the range if connections may have been disturbed during rigid pipe testing.
1. Turn gas back on at union. Inspect for leaks.
Test for Gas Leaks
Installation to verify that both front legs are resting solidly on the floor.
CAUTION...
Similar Questions
Bosch Hdi8054u Insufficient Flame/btus On Range Top Burners - Low Gas Flow?
Purchased an open-box HDI8054U dual-fuel range, floor model looked never to have been used, but with...
Purchased an open-box HDI8054U dual-fuel range, floor model looked never to have been used, but with...
(Posted by applemailaccnt 3 years ago)
Disconnect Instructions For Bosch Dual Fuel Oven Pressure Regulator
I need to install a natural gas pressure regulator in a Bosch dual fuel range model HD17282U/03. How...
I need to install a natural gas pressure regulator in a Bosch dual fuel range model HD17282U/03. How...
(Posted by gary32993 5 years ago)
Bosch Dual Fuel Range/oven Model # Hd17152u/03
The oven will not heat up after trying several different heating settings.
The oven will not heat up after trying several different heating settings.
(Posted by dellga01 9 years ago)
Has Anyone Tried To Paint The Worn Knobs On Their Bosch Dual Fuel Range?
Like many people, the knobs on my Bosch Dual Fuel Range are showing wear after only two months. Si...
Like many people, the knobs on my Bosch Dual Fuel Range are showing wear after only two months. Si...
(Posted by natemom 12 years ago)
Bosch Dual Fuel Slide In Burner Issue
Two burners will not light. Gas it present
Two burners will not light. Gas it present
(Posted by kranksr 12 years ago)