Amana AEP222VAW Support Question
Amana AEP222VAW Support Question
Find answers below for this question about Amana AEP222VAW.Need a Amana AEP222VAW manual? We have 4 online manuals for this item!
Question posted by chriskroeck on July 21st, 2017
New Oven Thermostat Has More Connections
Hello! I have an AEP222VAW range. Changing out oven thermostat. New thermostat has more connections than original part. Not sure what color code wires go where since different from connecting to original part. The thermostat is WP74009277 and original part W10179656.
Current Answers
Answer #1: Posted by Odin on July 21st, 2017 10:43 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,710
Member since:
April 10th, 2010 Points: 41,236,710
With no knowledge of the new part, there's no way of our providing a solution. You must ask the seller of that part. It's possible also that if you identify the part Amana may be able to help--use the contact information here--https://www.contacthelp.com/amana/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Amana AEP222VAW Manual Pages
Use and Care - Page 3
...fastened down properly.
Anti-Tip Bracket
Making sure the anti-tip bracket is installed:
• Slide range forward.
• Look for details. Range Foot
State of California Proposition 65 Warnings... "DANGER" or "WARNING."
Connect anti-tip bracket to cause cancer.
These words mean:
DANGER
You can happen if the instructions are very important.
RANGE SAFETY
Your safety and the...
Use and Care - Page 4
... the backguard of a utensil should not be hot even though they have had sufficient time to the sudden change in color. Be sure the range is properly installed and grounded by a qualified technician.
■ Never Use the Range for a good seal. Smother fire or flame or use a towel or other flammable materials contact surface units...
Use and Care - Page 5
... the coil element. Lift out the burner bowl.
5 Oven light (on some models, the surface cooking area locator shows which ...manual covers several different models. Surface area locator H.
Right rear control knob F. Push in the Off position.
Failure to change color. SETTING
RECOMMENDED..., make sure they are cool and the control knobs are in and turn to the cookware. The range you have...
Use and Care - Page 6
... very quickly and evenly.
OVEN USE
Odors and smoke are normal when the oven is used the first few times, or when it is pushed into the receptacle.
3.
Make sure foil is at least ½...fitting lid, and the material should not be able to move birds to measure oven temperature because opening the oven door and element or burner cycling may result in cookware. Rough finishes may be...
Use and Care - Page 7
... may be placed on a lower rack position. Make sure that no bottom browning
Stainless steel ■ Light, ... not appearance, should be able to circulate around bakeware and oven walls. Follow manufacturer's directions for using a meat thermometer.
...(S)
1
Center of doneness.
BAKEWARE/ RESULTS
RECOMMENDATIONS
Light colored
■
aluminum
■ Light golden crusts
■...
Use and Care - Page 9
... a plastic scrubber can be cleaned when oven cools.
When replacing knobs, make sure all controls are off and the oven and cooktop are suggested first unless otherwise noted. OVEN AND ROASTING RACKS
■ All-Purpose Appliance Cleaner Part Number 31682 (not included):
See "Assistance or Service" section to order. RANGE CARE
General Cleaning
IMPORTANT: Before...
Use and Care - Page 10
... . Push in the back
of an unnecessary service call an electrician. Oven Light
The oven light is removed from socket. 4. Before replacing, make sure the oven is not suggested here first in range or reconnect power.
2. Remove screw and clip to remove the oven door.
Do not remove hinge pins until the door is heavy. To...
Use and Care - Page 11
... Controls" section.
■ Is the range level? See "Oven Temperature Control" section. See "Assistance or...oven to cover the edge of appliances.
■ Installation information.
■ Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Specialized customer assistance (Spanish speaking, hearing impaired, limited vision, etc.).
■ Referrals to build every new...
Dimension Guide - Page 1
...connected load listed on the model/serial rating plate.
**If connecting to a 50-amp circuit, use a 50-amp rated cord with local codes. 20" (50.8 cm) Freestanding Electric Range
PRODUCT MODEL NUMBERS
AEP222VA
AEP200VA
Electrical Requirements: If codes permit and a separate ground wire...improve our products, we reserve the right to change materials and specifications without notice.
12/20/...
Installation Instruction - Page 2
...tools listed here.
A
■ Tape measure
■ Masking tape
■ Flat-blade screwdriver
■ Wire strippers
■ Phillips screwdriver
nut driver
B
■ Level ■ Hammer ■ Hand or electric ...RANGE SAFETY
Your safety and the safety of others .
WARNING
Tip Over Hazard A child or adult can result in this manual and on your local hardware store.
2 Connect ...
Installation Instruction - Page 3
... "Electrical Requirements" section. Location Requirements
IMPORTANT: Observe all electrical connections be made by installing a range hood that are minimum clearances.
■ The floor anti-tip bracket must be used .
See "Electrical Connection" section. It is the installer's responsibility to check that all governing codes and ordinances.
■ It is recommended that the floor...
Installation Instruction - Page 4
...connected to the cabinet. clearance upper side cabinet to side wall or other combustible material
F. Electrical Requirements
If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the range... oven frame must be connected to the proper electrical voltage and frequency as to a 50-amp circuit, use with ranges.
Be sure ...
Installation Instruction - Page 5
...new branch-circuit installations (1996 NEC); Use a wrench or pliers to do so can be loosened to add up onto cardboard or hardboard.
3. A maximum of 5.0 mm) is standing, tilt the range...green grounding
If connecting to a 3-wire system: Local codes may permit the use oven door handle to lift or move and install range. Remove shipping materials, tape and film from range. Cardboard shipping ...
Installation Instruction - Page 6
...template from the anti-tip bracket kit (found inside
the oven cavity). 2. Align the anti-tip bracket holes with a...anti-tip bracket with local codes.
13. Failure to follow these instructions can tip the range and be centered in cabinet... installing the range in the "Location Requirements" section, adjust template so range will be killed. Move the range into final location making sure the rear...
Installation Instruction - Page 7
...Add strain relief. UL listed strain relief - Large opening B. Use a new 40 amp power supply cord. Failure to follow these instructions can result in...range. A B
A. Large opening B. Terminal block cover
3.
Small opening
■ Position cord/conduit plate as shown in death, fire, or electrical shock.
1. Disconnect power
2.
Power Supply Cord
Electrical Connection
Direct Wire...
Installation Instruction - Page 8
...the range. Complete installation following instructions for : ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the strain relief, allowing enough slack to easily attach wiring to remove the ground-link screw from the back of
electrical connection: 4-wire (recommended)
3-wire (if...
Installation Instruction - Page 9
... terminal block post with one of the 10-32 hex nuts. A
B
3-wire connection: Power Supply Cord
Use this method only if local codes permit connecting chassis ground conductor to the center terminal block post with ranges.
8. A
C
B
E D
C
A. Cord/conduit plate D. Terminal block B. Power supply cord wires - Replace terminal block access cover. Line 1 (black) C.
Allow enough slack...
Installation Instruction - Page 10
... (4-wire or 3-wire connection).
4-wire Connection: Direct Wire
Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the
neutral 1.
Line 1 (black) wire G. Ground-link screw
2. Save the ground-link screw and the end of range. Neutral (white) wire...
Installation Instruction - Page 11
... tighten hex nuts.
6. as shown in . (4.0 N-m)
3. Replace terminal block access cover.
3-wire connection: Direct Wire
Use this method only if local codes permit connecting ground conductor to line 1 (black), bare (green) ground, and line 2 (red) wires. Bare (green) ground wire E. Loosen (do not remove) the set screw to the terminal block. Securely tighten set screw on the...
Installation Instruction - Page 12
....
4. Check that all packaging materials. 4. Use a mild solution of the oven elements: 1. Dry thoroughly with a soft cloth. 6. NOTE: Range must be on rack and check levelness of range, first side to the "OFF" position. The "OVEN ON" indicator light goes off when the oven is connected. ■ See "Troubleshooting" in anti-tip bracket.
Turn the control...
Similar Questions
Agr5630bds Gas Stove Replaced The Ignitor 2 Months Ago. Oven Lights Sometimes
what can be wrong?
what can be wrong?
(Posted by blurose74 4 years ago)
Oven/cook Top Shot Down When Both On At The Same Time
My amanda AER5823XAS works when I have the stove on. it also works when I have the oven on. but if I...
My amanda AER5823XAS works when I have the stove on. it also works when I have the oven on. but if I...
(Posted by teresavilas 9 years ago)
Oven Not Lighting/heating
The oven does nothing at all when the dial is turned to any temp or function. Top is fully functiona...
The oven does nothing at all when the dial is turned to any temp or function. Top is fully functiona...
(Posted by geezerloca 11 years ago)
Oven Door
How do you adjust the oven door to close at the top?
How do you adjust the oven door to close at the top?
(Posted by walterhorton13 11 years ago)