Amana AGR5844VDS Support and Manuals
Get Help and Manuals for this Amana item
View All Support Options Below
Free Amana AGR5844VDS manuals!
Problems with Amana AGR5844VDS?
Ask a Question
Free Amana AGR5844VDS manuals!
Problems with Amana AGR5844VDS?
Ask a Question
Most Recent Amana AGR5844VDS Questions
Where Is The Oven Ignitor?
(Posted by Anonymous-170635 2 years ago)
Hot Air On Top Of Stove?
Why does the range top blow hot air causing condensation when I heat the oven? Thank you!
Why does the range top blow hot air causing condensation when I heat the oven? Thank you!
(Posted by behrrn3 11 years ago)
Where Can I Get Replacement Parts Like The Burners And The Racks
(Posted by adornobernice 12 years ago)
Popular Amana AGR5844VDS Manual Pages
Dimension Guide - Page 1
... C. 46 " (119.1 cm) overall height (max.) with product. 30" (76.2 cm) Freestanding Gas Range
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
AGR5844VD AGR6011VD Gas supply: This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with a manual shutoff valve. Provide a gas supply line of LP gas must extend beyond cabinet fronts by ½" (13...
Installation Instruction - Page 2
... is the safety alert symbol. WARNING: If the information in this manual is , tell you don't follow instructions. Always read and obey all safety messages. These words mean:
DANGER
You can be performed by a qualified installer, service agency or the gas supplier.
Installation and service must be killed or seriously injured if you how to light any...
Installation Instruction - Page 4
... driver
■ Quadrex®† or Phillips screwdriver
■ Masking tape
Parts supplied Check that the floor covering can withstand at least 200°F (93°C).
■ Use an insulated pad or ¼" (0.64 cm) plywood under range if installing range over carpeting. Any method of NLW Holdings, Inc.
4
Tools needed Check local codes and consult gas...
Installation Instruction - Page 5
... not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.
5 Cabinet Dimensions
Cabinet opening dimensions shown are for installation of wood or metal cabinet is covered...
Installation Instruction - Page 7
... should be as an adjacent cabinet.
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be used for connecting range to the gas supply line.
■ A ½" (1.3 cm) male pipe thread is for turning on or shutting off gas to the range opening and closing its individual manual shutoff valve during any pressure testing of...
Installation Instruction - Page 9
... regulator and the other adapter to the standards in the following installation instructions. Align anti-tip bracket holes with screws provided. Any method of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Nipple I
H
G
F. Move range into its final location making sure rear leveling leg slides into holes...
Installation Instruction - Page 10
... the anti-tip bracket is installed, use a flashlight and look underneath the bottom of the range.
■ Look for the anti-tip bracket securely attached to the gas pipe. Use a combination wrench and channel lock pliers to attach the flexible connector to follow these instructions can result in the gas supply line. Check that connector...
Installation Instruction - Page 13
... to see the "Range Care" section of the Use and Care Guide. 6.
Slowly push the storage drawer into a grounded 3 prong outlet.
■ Electrical supply is closed position.
5.
Once the storage drawer is an extra part, go back through the opening in its fully forward position. 2. Complete Installation
1. Check that the gas supply line shutoff valve...
Installation Instruction - Page 14
... valve "closed position. See "Replace Oven Racks and Warming Drawer" section.
2.
Gas pressure regulator cap with solid end facing out C. Remove plastic cover from LP gas to Natural gas must be done by a qualified installer.
Explosion Hazard Use a new CSA International approved gas supply line. Failure to rear range foot. LP Gas Conversion
A
A. Turn the manual shutoff valve to...
Installation Instruction - Page 16
... result in death or serious burns to adjust the "LO" setting for proper burner ignition, operation, and burner flame adjustments. Turn the manual shutoff valve to ½" (1.3 cm) long. Gas pressure regulator cap with hollow end facing out C. Gas regulator shutoff valve (shown in the "Installation Instructions" section of storage or warming
drawer compartment.
Checking for...
Installation Instruction - Page 17
...range cooktop to help hold the orifice spud holder in plastic parts... literature.
6.
Set gas orifice spud aside. Orifice spud B. C A
D
B
A. Replace the burner base...driver while changing it counterclockwise and lifting out. Spark electrode
4.
Gas tube opening C. Place LP gas orifice spuds in place while removing and replacing the orifice spuds.
A B
A
A. Replace the LP gas...
Use and Care - Page 6
...gas tube opening the oven door may cause element cycling to the oven bottom finish, do not service...can be adjusted, contact a trained repair specialist.
4. Press CANCEL to ...in use, the time of some models), repeating each minute after the ...Fahrenheit, but can be set between 30°F (15°C) and -30°F (-15°C).
... If "LOFF" is displayed. Replace the burner cap, making sure the...
Use and Care - Page 8
...) area around the model and serial number plate because scrubbing may result in death to avoid damaging.
■ Stainless Steel Cleaner and Polish Part Number 31462 9not included): See cover for contact information.
To stop the self-cleaning cycle at www.amana.com.
Electronic Oven Control with a damp cloth. The last 30 minutes of the cycles...
Use and Care - Page 11
... and is reported to Amana within 30 days from the date of purchase.
6. Outside the 50 United States and Canada, this limited warranty does not apply. Repairs to parts or systems resulting from warranty coverage.
3. Stainless Steel Cleaner and Polish (stainless steel models) Order Part Number 31462
All-Purpose Appliance Cleaner Order Part Number 31682
Gas Grate and Drip Pan Cleaner...
Warranty - Page 1
... workmanship and is reported to Amana within 30 days from the date of purchase.
6. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance for factory specified parts and repair labor to correct defects in accordance with published installation instructions.
11. Costs associated with original model/serial numbers that is...
Amana AGR5844VDS Reviews
We have not received any reviews for Amana yet.