Home » Alpine » Automotive Audio & Video » Alpine PXE-H650

Alpine PXE-H650 Support Question

Find answers below for this question about Alpine PXE-H650 - System Integration Audio Processor.
Need a Alpine PXE-H650 manual? We have 1 online manual for this item!

Alpine Overview Questions Manuals Reviews Videos Research

Question posted by indianyuvraj on October 18th, 2017

Alpine Pxe-h650 Ir Receving Cable To Use With Remote Control

Hi Sir i need yr help regarding Alpine PXE-H650, i am having this unit but unfortunetly i lost the IR extension/Receiver cable, without it the remote control dosent work & i am unable to calibrate, can u pls send me the part number of IR extension cable or can arrange for me ? i am in india, please help me out to short out this issue.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on October 18th, 2017 10:35 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,100
points

We're an independent help site not connected with Alpine. Here's contact information for India:

Alpine of Asia Pacific India PVT.,Ltd
(Greater Noida Office)

Plot No 11, Sector 31, Ecotech-1, Kasna Industrial Area, Greater Noida, Uttar Pradesh, INDIA 201308
Tel: +91 (120)4204-625
Fax: +91 (0)120-4204629

(Gurgaon Office)

Plot No. D-26, Info city-II, GTPL, Sec-33, Gurgaon 122001, Haryana, India
Tel: +91 (0)124-2212573 / 4235532
Fax: +91 (0)124-2210573

LUMAX AUTO TECHNOLOGIES LIMITED

B-85, Mayapuri Industrial Area, Phase-I New Delhi - 110064, INDIA
Tel: +91 1800 200 5140
Fax: +91 11 28113631

* * * *

If for any reason the above is not sufficient, you may wish to try http://www.cablestogo.com/.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Alpine PXE-H650 Manual Pages

User Guide - Page 1

...Make sure the PXE-H650 will not be of the same amperage as shown on . Failure to repair the unit yourself. If... the fuse(s) blows more than once, carefully check all electrical connections for servicing. Temperature Be sure the temperature inside the vehicle is between +60°C (+140°F) and -10°C (+14°F) before turning your Alpine dealer or the nearest Alpine...

User Guide - Page 3

... Alpine PXE-H650 is tuned for the driver to watch Video/TV while driving WARNING any factory pre-equalization, Audyssey MultEQ™ ﬂattens the frequency response inside the vehicle's interior and adjusts the overall response to remove any vehicle. Features: • AntEQ and MultEQ (Imprint technology) • AUX Input (Audio) • 5-Channel Factory Head Unit...

User Guide - Page 4

... Amp Levels This track is used with auto ranging to the PXE-H650 is equipped with AntEQ for better noise immunity and signal processing. Therefore, it 's noisy). AntEQ setup This track is very important that the output from the factory radio be properly set so the PXE-H650 receives the correct audio level (not so high that...

User Guide - Page 7

... and is securely fastened using a sheet metal screw. • Battery (YEL) E This is controlled. 5 REMOTE IR INPUT (2.5mm mini-phono) - Use this input for an ...unit outputs. The signal goes high after the PXE-H650 audio mute is OFF. • Remote ON (BLU/WHT) If the OEM head unit is not turning on the EQ using the AUX INPUT. 8 CLIP - Note: Using this lead to maintain processor...

User Guide - Page 8

...grouped where the driver's head would be used. Use the Remote On wire from MIC position 2. Have the MultEQ CD, microphone...MIC position 1 and PRESET 2 settings are needed to the visor. Find the low cut -off is also needed in between the two front seats. It...not always a good idea as they are derived from the head unit or a source of stand is determined by default). The mid-...

User Guide - Page 9

... steps below. E If this is the very ﬁrst time the PXE-H650 is displayed. This will be controlled through the PXE-H650 using the supplied remote control. Press "ENTER" to take place. "ENTER TO START ANTEQ" - Volume will ensure that the volume control on the factory head unit is set at a high enough level to provide a good signal for...

User Guide - Page 10

...PXE-H650 is not muted at the prompt and press "ENTER." WARNING: Output of each crossover are at the same point. While listening to the system, use the amp's level controls...controls. Make adjustments to the system. Make sure volume levels are : 12 o'clock (middle position on gain controls...facilitate the trimming of the PXE-H650 is a Pink Noise signal ...PXE-H650 Setup Disc in...

User Guide - Page 11

... Speaker Detection process, the PXE-H650 displays the above , the MultEQ LED is blinking slowly. "CONNECT LED & MIC" If the PXE-H650 does not detect the microphone...remote control to ﬁnalize MultEQ ﬁlter calibration or "MEASURE" to begin (see Page 7). 4. Press "DONE" on the remote control to the next mic position of calibration. "ENTER TO START MULTEQ" - Prepare to use...

User Guide - Page 12

...used, the more microphone positions. 4 calibrated positions is the minimum for proper MultEQ response. 6 positions is recommended for this setting the same as previous MultEQ sequence. When ready, exit the vehicle and press "MEASURE" on the remote control... MultEQ LED is showing on the LCD and ﬁnally "ALPINE PXE-H650" is stored in the vehicle. Equalization and Time Delay will then...

User Guide - Page 13

... entire calibration procedure must be redone. • CANCEL: Press ENTER at this display to clear all remote controller buttons are not changed. • CLEAR SETTINGS: Press ENTER at this display to return the PXE-H650 to PXE-H650 STANDBY mode. Demo Mode Overview E N • Demo mode will allow the user to audition MultEQ/AntEQ ON and...

User Guide - Page 14

...use the ▼ or ▲ buttons to choose the MIC position to modify or to choose the EQ Adjustment mode. (PRESET 1 or PRESET 2) a) PRESET 1 refers to the MID and TREBLE adjustments. Navigate to "SAVE SETTINGS" screen and press ENTER to the PXE-H650... in a similar manner. SOUND CUSTOMIZATION Introduction Each output of the PXE-H650 has a 3-Band, parametric equalizer, up to the Second mic ...

User Guide - Page 15

... the Front and Rear speakers and the Subwoofer. The frequencies are listed below . * Use the button to return to the previous sub-menu. This is selected as described below . The Q determines how much wider audio bandwidth. Crossover Overview The PXE-H650 crossover allows custom cut-off points for the high-pass and low-pass...

User Guide - Page 16

...press ENTER to exit back to choose a channel. "SAVE SETTINGS" stores changes in 1 dB steps. 3. a) Use the ▼ or ▲ button to the "CROSSOVER" sub-menu. Once Fc is to a Band-pass crossover...make the selection. Just substitute "FRONT 1," "REAR," or "SUBWOOFER," for "FRONT 2." Note: Use the same procedure to select any point, to return to the previous sub-menu to adjustments for ...

User Guide - Page 17

...; buttons to select a Channel to the Primary Mic position. Doing this may or may be times when the delay needs to the next selection mode. However, there may not result in the display, use the button to move to 10ms in memory. N a) PRESET 1 refers to modify (FRONT LEFT 1/RIGHT 1, FRONT LEFT 2/RIGHT...

User Guide - Page 19

... dB/oct 50, 60, 70, 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190, 200 Hz General User Memory 2 Presets PC Control Interface USB Pre-amp Control Volume/Balance/Fader/Sub Level Source Select HU (Factory)/AUX Remote Turn-on Automatic Input Signal Sensing Turn-off Delay 5 minutes 21 21

User Guide - Page 20

SPECIFICATIONS MAIN UNIT MAIN Input AUX Input GENERAL SPECIFICATION Max Input Level Max ...;F to +140°F -10°C to +60°C) 252mm x 38mm x 149mm 1.0kg/35.3 oz Accessories RUE-4265 Remote Control x 1 Power Supply Connector x 1 Speaker Input Connector x 1 Microphone...x 1 IR Remote Sensor x 1 MultEQ LED...x 1 Batteries (AAA x 2 Owner's Manual x 1 Imprint Setup CD x 1 NOTES: Due to...