Zanussi ZGG96624XA Support and Manuals
Get Help and Manuals for this Zanussi item
This item is in your list!
View All Support Options Below
Free Zanussi ZGG96624XA manuals!
Problems with Zanussi ZGG96624XA?
Ask a Question
Free Zanussi ZGG96624XA manuals!
Problems with Zanussi ZGG96624XA?
Ask a Question
Popular Zanussi ZGG96624XA Manual Pages
Product Manaul - Page 2
... hob without notice. For your safety and correct operation of the appliance, read this booklet's cover. Use • Remove all packaging away from children. This appliance is for commercial and industrial use the appliance. Refer to change without cookware.
• The appliance is cold. Contents
Safety information 2 Installation 4 Product description 8 Operating instructions...
Product Manaul - Page 3
... supplier.
• Only use built-in appliances after you assemble the appliance into correct built-in units and work surfaces that obey the standards.
• Do not install the hob over a domestic appliances if the installation instructions do not allow it.
• Install the appliance only on a worktop with flat surface.
• Do not change the specifications or modify this product. Hot...
Product Manaul - Page 4
... the connection cable does not come in compliance with the
www.zanussi.com
Installation
• If the fixing bracket is required. Flat the external gas pipes if there are fitted.
- Speak to your local Service Force Centre.
• The appliance must have the electrical installation which opens directly to the outside no air vent is near...
Product Manaul - Page 5
Screw the parts together without using metal rigid pipes (copper with an oven.
It is 400 mm.
Rigid connection:
Carry out connection by a GAS SAFE REGISTER installer. Remove the caps and crowns of the hob is important to the hob connecting pipe. With a socket spanner 7 remove the injec-
www.zanussi.com
5 For appliances installed in this plate in "Technical Data...
Product Manaul - Page 6
... removed from natural gas G20 20 mbar to the minimum position. The manufacturer declines any hot parts.
• The electrical installation must be connected ... (BS 1362) fuse.
6
www.zanussi.com If you quickly turn for Electrical Installation Contracting [NICEIC]). Electrical connection • The electrical work necessary to install the appliance must be done by -pass screw
...
Product Manaul - Page 7
...according to the terminal in the plug which is marked with door The panel installed below the hob must be secured on the outer sheath. Warning! Make sure that the ... or coloured black.
3. Replacement of electrical shock.
The cord clamp must be approximately 2 cm longer than the brown (or black) phase wire. There is marked with the following code:
Green and yellow Blue Brown...
Product Manaul - Page 8
www.zanussi.com To light the... use open fire in case misuse of air. this will be installed separately for safety reasons and to warm up. Adjust the flame after it
... gas supply / off position
Symbol
Description ignition position / maximum gas supply
minimum gas supply
Operating instructions
Ignition of the burner
Warning! a 60 mm
b
30 mm
min 20 mm (max 150 mm)
with oven The hob...
Product Manaul - Page 9
...160 mm
www.zanussi.com
9 The spark generator can ignite the burner without electrical device; Warning! Energy savings
• If possible, always put the flame out, turn the knob to maximum gas release position.... flame, push the relevant knob down the flame to the dimension of burner.
If after installation or a power cut. If the burner accidentally goes out, turn the flame down or ...
Product Manaul - Page 10
... pan supports are not dishwasher proof. Remove immediately: ...replace the pan supports to easily clean the hob.
• To clean the enamelled parts, cap and crown, wash them with water, and then dry them as the enamelling process occasionally leaves rough
10
edges. Deactivate the appliance...appliance and let it cool
down before you clean: limescale rings, www.zanussi.com Refer to the appliance...
Product Manaul - Page 11
... than one time, refer to check the conditions of hob. 2. www.zanussi.com
11 Cleaning of food particles.
Problem
There is no spark when lighting the gas
Possible cause • There is switched on.
•...if...
At the end rub the appliance dry with a damp cloth and some detergent. 3. Clean the appliance with a clean cloth. water rings, fat stains, shiny metallic discolorations....
Product Manaul - Page 12
... and keep this part
3 Stick it on instruction booklet These data are available on the supplied rating plate.
• Model description
Technical data
• Product number (PNC
• Serial Number (S.N Use the original spare parts only. They are available at Service Force Centre and approved spare parts shops. If you cannot find a solution to the problem yourself.
PROD.NO...
Product Manaul - Page 13
...Appliance class:
3
By-pass diameters
Burner
Auxiliary Semi-rapid
Rapid Triple Crown
Ø By-pass in 1/100 mm 28 32 42 56
Gas burners
BURNER
NORMAL POWER
kW
Auxiliary Semi-rapid
Rapid
Triple Crown
1.0 2.0 3.0 (natural gas) 2.8 (LPG)
4.0
REDUCED POWER
kW
0.33 0.45
NORMAL POWER
NATURAL GAS... your local council, your household waste disposal service or the shop where you will help prevent...
Zanussi ZGG96624XA Reviews
Do you have an experience with the Zanussi ZGG96624XA that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Zanussi yet.
Earn 750 points for your review!