Zanussi ZGG62414WA Support and Manuals
Get Help and Manuals for this Zanussi item
This item is in your list!
View All Support Options Below
Free Zanussi ZGG62414WA manuals!
Problems with Zanussi ZGG62414WA?
Ask a Question
Free Zanussi ZGG62414WA manuals!
Problems with Zanussi ZGG62414WA?
Ask a Question
Popular Zanussi ZGG62414WA Manual Pages
Product Manaul - Page 2
... 2 Safety instructions 3 Product description 5 Daily use 5 Helpful hints and tips 6
Safety information
Care and cleaning 7 Troubleshooting 7 Installation 9 Technical information 13 Environment concerns 14
Subject to change without supervision. Before the installation and use causes injuries and damages. General Safety
• The appliance and its accessible parts become hot...
Product Manaul - Page 3
...not install the appliance adjacent to the mains cable.
Always wear safety gloves. • Seal the cut -outs, fuses (screw type fuses re-
3 Electrical connection
www.zanussi.... damaged appliance. • Obey the installation instruction supplied
with water, but switch off the appliance and then cover flame e.g. Contact the Service or an electrician to extinguish a fire with the appliance. ...
Product Manaul - Page 4
...appliance.
• The information about the gas supply is on the rating plate.
• This appliance ...specification of combustion. Use
Warning!
They become hot.
• Set the cooking zone to current installation regulations.
This can release flammable vapours.
There is not connected to clean the appliance...in the dishwasher. • Clean the appliance with the correct shape ...
Product Manaul - Page 5
www.zanussi.com
5 Be very careful when you put cookware. Manufacturer decline any responsibility in case ... warm up. Always light the burner before you use
Warning!
Ignition of the flame
ple to the Safety chapters. If not, the gas supply will let thermocou- To light the burner:
1.
Product description
Cooking surface layout
1
2
1 Semi-rapid burner 2 Semi-rapid burner...
Product Manaul - Page 6
... up. If the control knobs are centrally put on the mains, after installation or a power cut.
Warning! Refer to maximum gas release
C
position. Make sure that pot handles is normal. Make sure that... maximum stability and to prevent from the burner. Do not use a flame diffuser.
6
www.zanussi.com Make sure that pots are under the bottoms of cookware 180 - 260 mm 120 - 220...
Product Manaul - Page 7
... supply is too much heated.
www.zanussi.com
7 Warning!
Troubleshooting
Problem There is no spark when lighting the gas
Possible cause • There is no effect on the surface have no electrical supply
Remedy
• Make sure that the arms of the pan supports are not dishwasher proof. Clean the appliance with a clean cloth.
If necessary, remove...
Product Manaul - Page 8
... quickly and correctly. PROD.NO. SER.NO DATA
0049
03 IT MADE IN ITALY
MOD.
SER.NO DATA
MOD. SER.NO.
They are available on instruction booklet www.zanussi.com These data are available at Service Force Centre and approved spare parts shops.
PROD.NO.
Product Manaul - Page 9
... safety requirements
This hob must be installed in Cyprus, you must change the nozzles refer to the type of this instruction booklet be allowed from the edges of a breakdown.
Provision for the engineer in this appliance are not applicable for Cyprus. Screw the parts together without using excessive force.
Warning! The gas settings of gas used. To change...
Product Manaul - Page 10
...- Replace the rating plate (it is essential that the main connection pipe does not exert any strain on the hob and installation. You can find this plate in touch with mechanical end).
Important!
Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of gas supply. er.
Warning!
Always pull the mains plug.
10
www.zanussi...
Product Manaul - Page 11
...appliance installed. Electrical Requirements
Permanent electrical installation must always be guided... by a qualified electrician (e.g.
The supply system is easily accessible with the equipment beneath the cooktop.
• Make sure that there is marked as follows:
Green and yellow Blue Brown
- Live
Replacement... regulations
3. www.zanussi.com
A
B
...
Product Manaul - Page 12
... appliance only on a worktop with the current regulations. The replacement of the connection cable To replace the connection cable use only H05V2V2-F T90 or equivalent type.
The electrical connection of safely. A cut off plug inserted into a 13 amp socket is disposed of the hob and the oven must be installed separately for connections
Kitchen unit with oven...
Product Manaul - Page 13
...
Width: Length:
580 mm 500 mm
Hob recess dimensions
Width: Length:
550 mm 470 mm
Heat input
Rapid burner: Semi-rapid burner: Auxiliary burner: TOTAL POWER:
Electric supply:
Gas connection: Category: Gas supply: Appliance class:
3.0 kW
2.0 kW
1.0 kW
G20 (2H) 20 mbar = 8 kW G30 (3+) 28-30 mbar = 567 g/h G31 (3+) 37 mbar = 557 g/h G30/G31...
Product Manaul - Page 14
... recycling of this product, please contact your local council, your household waste disposal service or the shop where you will help prevent potential negative consequences for LPG G30/G31...its packaging indicates that this product. BURNER Rapid
NORMAL POWER
kW
3.0 (natural gas)
2.8 (LPG)
REDUCED POWER
kW
NORMAL POWER
NATURAL GAS G20 (2H) 20 mbar
LPG (Butane/Propane) G30/G31 (3+)
28-30...
Zanussi ZGG62414WA Reviews
Do you have an experience with the Zanussi ZGG62414WA that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Zanussi yet.
Earn 750 points for your review!