Zanussi ZGG65414XA Support and Manuals
Get Help and Manuals for this Zanussi item
View All Support Options Below
Free Zanussi ZGG65414XA manuals!
Problems with Zanussi ZGG65414XA?
Ask a Question
Free Zanussi ZGG65414XA manuals!
Problems with Zanussi ZGG65414XA?
Ask a Question
Zanussi ZGG65414XA Videos
Zanussi ZGG65414XA f?z?lap - Eluxshop.hu
Duration: 1:10
Total Views: 50
Duration: 1:10
Total Views: 50
Popular Zanussi ZGG65414XA Manual Pages
Product Manaul - Page 2
... the burners. These instructions are only valid in the chapter "Helpful hints and tips".
• The cookware must fully know the operation and safety features of the cooking surface www.zanussi.com Use • Remove all packaging away from the appliance before installation and use the appliance. Do not use the appliance for example room heating...
Product Manaul - Page 3
... a dishwasher or oven.
• Do not install the appliance adjacent to a combustion products evacuation device. Installation
• You must read these requirements.
• To prevent the risks of structural damage or physical injury, installation, connection of the appliance to the power supply and gas system, setting up and maintenance must be done by failure to obey these instructions...
Product Manaul - Page 4
... regulations in the following instructions about installation, connection and maintenance must...gas pipes if there are other fuel burning appliances in contact with a volume of minimum 3 mm. The following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions. The hob should be carried out by qualified personnel in compliance with the
www.zanussi...
Product Manaul - Page 5
... the hob.
Important!
Rigid connection:
Carry out connection by a GAS SAFE REGISTER installer. Remove the caps and crowns of the burners: 1.
tors and replace them with mechanical end). Replace the rating plate (it is changeable or different from the edges of the thread, fitted to the gas supply should be with an oven. You can find this instruction...
Product Manaul - Page 6
... manufacturer declines any hot parts. • The electrical installation must be done by -pass screw
- 4. If you change from the mains at all poles. Electrical connection • The electrical work necessary to liquid gas, fully tighten the adjustment screw in.
- If you change from natural gas G20 20 mbar to install the appliance must be earthed...
Product Manaul - Page 7
... outer sheath. Warning! www.zanussi.com
A
B
A) supplied seal B) supplied brackets Possibilities for insertion Kitchen unit with door The panel installed below the hob must be replaced for any reason, the wires..., or coloured green and yellow.
2. The replacement of wire present. Make sure that the cut off plug is marked with the following code:
Green and yellow Blue Brown
- Live
min...
Product Manaul - Page 8
...
5
4
180 cm2
Control knobs
Symbol
Description
no gas supply / off position
Symbol
Description ignition position / maximum gas supply
minimum gas supply
Operation
Ignition of the burner Warning! The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
50 cm2
120 cm2
a) Removable...
Product Manaul - Page 9
...
If the burner accidentally goes out, turn down the
flame to light the burner again after installation or a power cut. Turning the burner off To put the flame out, turn it into...burner. Flame will let thermocouple to obtain lower gas consumption.
id
Diameters of cookware 120 - 220 mm
80 - 160 mm
Warning! www.zanussi.com
9 If not, the gas supply will be interrupted.
3. Adjust the flame...
Product Manaul - Page 10
...dishwasher proof. Disconnect the appliance from spill and injury. They must not cook with a soft cloth.
• The pan supports are not recommended. Clean the appliance with a clean cloth. Cleaning of hob...acids.
www.zanussi.com
which contains starch), acrylamides can become tarnished if it cool down before you put them back.
• Wash stainless steel parts with a soft...
Product Manaul - Page 11
... speak your local Service Force Centre to check the conditions of food particles. Problem
There is no spark when lighting the gas
Possible cause •...gas ring burns unevenly
• Burner crown is blocked with food residues
Remedy
• Make sure that the injector is not blocked and the burner crown is clear of the gas supply pipe and the pressure adjuster, if fitted. www.zanussi...
Product Manaul - Page 12
... instruction booklet These data are available on the supplied rating plate.
• Model description
Technical data
• Product number (PNC
• Serial Number (S.N Use the original spare parts only. PROD.NO.
Labels supplied with the accessories bag Stick the adhesive labels as indicated below:
1
2
3
MOD. These data are necessary to help you operated the appliance...
Product Manaul - Page 13
... 20 mbar
Appliance class:
3
By-pass diameters
Burner
Auxiliary Semi-rapid
Rapid
Ø By-pass in 1/100 mm 28 32 42
Gas burners
BURNER
NORMAL POWER
kW
Auxiliary Semi-rapid
Rapid
1.0
2.0
3.0 (natural gas)
2.8 (...ensuring this product, please contact your local council, your household waste disposal service or the shop where you will help prevent potential negative consequences for the ...
Zanussi ZGG65414XA Reviews
We have not received any reviews for Zanussi yet.