Whirlpool LEV4634JQ Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool LEV4634JQ manuals!
Problems with Whirlpool LEV4634JQ?
Ask a Question
Free Whirlpool LEV4634JQ manuals!
Problems with Whirlpool LEV4634JQ?
Ask a Question
Popular Whirlpool LEV4634JQ Manual Pages
Installation Instructions - Page 1
... to panel. Failure to dryer. Check your Use and Care Guide for local electrical inspector's use. Service and Repair." Check with homeowner.
Shut off electrical supply to complete installation as instructed could void warranty. Installer: Leave installation Instructions with a licensed electrician to call, or call , you will need the dryer model number and serial number. leveling...
Installation Instructions - Page 2
... is greater than I /Sturdy floor to assure that the electrical installation meets all local codes and ordinances•
Copies of installation and servicing, Companion appliance spacing should not be considered.
**** Wall, door and floor molding may not shut off. I inch, install Extended Dryer Feet Kit, Part No. 279810.) Clothes may not tumble properly and automatic sensor cycles...
Installation Instructions - Page 3
... length of metal vent on the same line as the number of elbows. Service check: Back pressure in any exhaust system used must be exhausted outdoors. The installation of -the exhaust (such as possible. The dryer must not exceed 0.6 inches in water column measured with magnetic latches.
• Metal exhaust vent must be in...
Installation Instructions - Page 4
... sure all tape was removed.
PanelC
l m Put on
power supply.
Turn dryer drum counterclockwise to dryer.
Turn on safety glasses and gloves•
• Install exhaust
_ "_
hood. A.
diamond marking
• Remove tape from dryer drum. (Not all joints. Open dryer door and remove tape from dryer cabinet.
u Start to remove any dust. n Take two cardboard corners...
Installation Instructions - Page 5
... installation following instructions for joining copper to aluminum Follow the electrical connector manufacturer's recommended
procedure, C) Aluminum/copper connection must conform with local codes ...codes do NOT permit this appliance must be
connected to a grounded metal, permanent wiring
system; If using special connectors designed and Underwriters Laboratories Listed for your type of dryer...
Installation Instructions - Page 6
...
Where local codes Do Not permit
connecting cabinet-ground conductor to an adequate ground.
5, Remove the appliance harness ground wire (green with
.If"'_f" " _
Panel E Connect appliance harness ground ...of terminal block cover into slot of dryer rear panel. Tighten screws.
7. Insert tab of terminal block cover into __
slot of dryer rear panel. After reattaching the terminal cover...
Installation Instructions - Page 7
...• Set door (handle side up so screws are not long enough to level dryer, order Extended Dryer Feet Kit, Part No. 279810 (sold two legs per kit), from cabinet•
Complete door swing change following the instructions for your... side of cabinet. Available on Super-wide side-swing and Large side-swing door models only• If not reversing door swing, skip ahead to connect exhaust vent....
Installation Instructions - Page 8
... dryer,
then push dryer to power supply. Wall plate for the nearest authorized service
provider. Step 3 From over the
toP, snap vBnt totJether
Dura Safe and Sure (/ollnect are set in a running or "On" position.
i If house fuse is level.
After five minutes, open dryer door. If dryer makes an unusual noise, check the following :
I /propedy installed dryer...
Installation Instructions - Page 9
...use a metal foilvent, Failureto follow instructions.
Mobile home installations require:
• Mobile Home Installation Kit, Part Number 346764* • Metal exhaust system hardware*
Floorssloped greater than 1 inch:
Require Extended Dryer Feet Kit, Part No. 279810* *Availablefor purchasefrom your appliance. tial hazardsthat can happen if the instructions are not followed. Dura Safe...
Whirlpool LEV4634JQ Reviews
We have not received any reviews for Whirlpool yet.