Stihl FCS KM Support and Manuals
Get Help and Manuals for this Stihl item
View All Support Options Below
Free Stihl FCS KM manuals!
Problems with Stihl FCS KM?
Ask a Question
Free Stihl FCS KM manuals!
Problems with Stihl FCS KM?
Ask a Question
Stihl FCS KM Videos
The best gas edger Stihl KM 131 R Kombi power head + FCS KM Straight shaft edger | A TRUE BEAST
Duration: 9:12
Total Views: 23,619
Duration: 9:12
Total Views: 23,619
Popular Stihl FCS KM Manual Pages
Instruction Manual - Page 3
...
FCS-KM
This instruction manual is important that you can be observed to reduce the risk of the KombiEngine and edger KombiTool to operate this power tool combination. For further information you read, understand and follow the safety precautions and the operating and maintenance instructions in the two manuals. Original Instruction Manual
Contents
KombiSystem
2
Guide...
Instruction Manual - Page 4
....
2
FCS-KM In this manual.
NOTICE
Indicates a risk of property damage, including damage to or embossed on the machine are marked with the following symbols and signal words:
WARNING
Indicates a hazardous situation that , if not avoided, will result in this instruction manual the functional unit formed by illustrations. N Lever (2) ...
English
KombiSystem
In the STIHL KombiSystem...
Instruction Manual - Page 5
... observed to the machine. during a work break), shut it . Most of your model. Tiredness may cause blades to property, never let your KombiEngine and KombiTool. Read the instruction manuals and the safety precautions of these manuals.
STIHL does not recommend the use of an edger when cutting in use it off and make sure your body, it...
Instruction Manual - Page 6
...blades. Wear sound barriers (ear plugs or ear mufflers) to protect your doctor before operating this machine. Good footing is above shoulder level. Steel-toed safety boots are using.
4
FCS-KM... to the operator´s face, STIHL also recommends that could become caught on proper clothing see the safety precautions in the instruction manual of movement.
Continual and regular users...
Instruction Manual - Page 7
...EDGER KOMBITOOL)
For illustrations and definitions of doubt, have it checked by STIHL for use with the specific STIHL KombiEngine are authorized. WARNING
Never modify this power tool in good condition before starting. Only attachments supplied by STIHL and expressly approved by your STIHL servicing...position.
Replace damaged blades before putting a power tool down. FCS-KM
5
...
Instruction Manual - Page 8
... serious or fatal injury may result. For specific starting throttle and allow other part of your body. See also the safety precautions on the deflector must be diverted away from the fueling spot, outdoors only.
Watch for hidden obstacles such as possible.
English
The arrow on Starting in the instruction manual of the KombiEngine.
Instruction Manual - Page 9
... KombiEngine instruction manual on...danger. Operating Instructions
WARNING
Do not operate your edger as mold or..., wear and damage. WARNING
This edger is normally to be used at...), read and follow the instructions and warnings that accompany the...more fully exposed and the edger may be in particular ...and property (e.g. Use of an edger above ground level or with ... and the blade for the type of eye and ...
Instruction Manual - Page 10
... stopped before replacing the cutting attachment.
Forestry Service if you have any grease solvents for maintenance and repair. Do not attempt any maintenance or repair work immediately. Use of burn injury, do not use metal blades around flammable materials or around dry vegetation or brush.
Contact your instruction manual. To reduce the risk of non-STIHL parts may be...
Instruction Manual - Page 12
N Hold and guide your height and the way you hold the edger. N Operate at no more than 5 mm (0.2 in the normal working position,...the wingnut clockwise. Edging
257BA006 KN
2
3 B
N Tighten down -
The deflector has been set at full throttle. N Do not push the blade into the ground.
10
FCS-KM Use the following procedure:
N Adjust the depth wheel (2) so that the arrow on the ...
Instruction Manual - Page 14
... R KombiMotor, its rigid shaft must be re-installed if the FCS-KM is used with STIHL multipurpose grease or gear lubricant.
0000-GXX-3240-A0
N Push the flexible shaft into the gearbox - turn the gearbox back and forth as stop .
The rigid shaft must not project from a STIHL servicing dealer. The flexible shaft is available from...
Instruction Manual - Page 16
...Remove, clean and inspect the cutting blade. WARNING If the engine is started, the blade may rotate as soon as the ...instruction manual for the KombiEngine or basic power tool
Storing the Machine
For periods of accident! English
Starting / Stopping the Engine
Starting the engine
To start the engine, basically follow the instructions for use for the KombiEngine or basic power tool
14
FCS-KM...
Instruction Manual - Page 17
...replaced by a servicing dealer.
3
N Undo and remove the screw (1). If the parts are then reassembled, the captive function is peened over to remove the wingnut from the screw. In such a case have servicing and repair...tighten the screw (1)
FCS-KM
15
STIHL recommends that the wingnut (2) does not work carried out exclusively by an authorized STIHL servicing dealer.
Removing the ...
Instruction Manual - Page 18
..., fit a new one - it may be replaced as soon as the gearbox (2) (arrow) becomes visible. Replacing the Wear Guard
4
4
5
N Remove the cutting blade - see "Mounting the Cutting Blade".
16
FCS-KM see "Mounting the Cutting Blade". see "Mounting the Cutting Blade".
STIHL recommends you do not replace the wear guard in good time. N Replace the blade (1) if its length (A) is out-of...
Instruction Manual - Page 21
... system, please refer to the air emissions systems warranty in this manual. FCS-KM
19 STIHL recommends that other repair work be identified by the STIHL part number, the { logo and, in some cases, by authorized STIHL servicing dealers using genuine STIHL replacement parts.
Definitions
1 Cutting Blade Metal cutting blade for required depth of cut.
5 Wingnut Must be loosened to shift...
Instruction Manual - Page 22
...Law Trademarks
STIHL InjectionTM
AutoCut® FARM BOSS® iCademy® MAGNUM® MasterWrench Service® MotoMix® OILOMATIC®
4-MIX ™ BioPlus ™ Easy2Start ™ EasySpool ™ ElastoStart ™ Ematic ™ FixCut ™ IntelliCarb ™ Master Control Lever ™ Micro ™ Pro Mark ™ Quiet Line ™ STIHL M-Tronic ™
20
FCS-KM
Stihl FCS KM Reviews
We have not received any reviews for Stihl yet.