Singer S18 I STUDIO Support and Manuals
Get Help and Manuals for this Singer item
View All Support Options Below
Free Singer S18 I STUDIO manuals!
Problems with Singer S18 I STUDIO?
Ask a Question
Free Singer S18 I STUDIO manuals!
Problems with Singer S18 I STUDIO?
Ask a Question
Popular Singer S18 I STUDIO Manual Pages
Instruction Manual - Page 1
or its Affiliates. or its Affiliates. ©2014 The SINGER Company Limited S.à.r.l. INSTRUCTION MANUAL S18
SINGER and STUDIO are trademarks of The SINGER Company Limited S.à.r.l. All rights reserved.
Instruction Manual - Page 2
... or service center for household use bent needles. 13. Read all moving parts.
Keep fingers away from 8 years and above and persons with relevant National legislation relating to break. 14. Children shall not play with the appliance. IMPORTANT SAFETY INSTRUCTIONS
When using this sewing machine is used or where oxygen is required around the sewing machine needle...
Instruction Manual - Page 3
...sew with the straight stitch 27 How to start stitching on the edge of thick fabrics....... 27 Securing seams 27 Pivoting a corner 28 Using the cloth guide 28 Using the seam guide... the Feed Dog 23 Selecting the Sewing Mode 24 Help Button 25 Selecting the Stitch Pattern 25 Customizing Machine Settings 26
Resumption setting 26 Sound setting 26 Language selection 26
PIECING AND QUILTING...
Instruction Manual - Page 6
... F-2 17. Button sewing foot T 18. ...Set of needles 13. Edge/quilting guide 25. Narrow hemmer foot D 4. Darning/Embroidery foot P-2 14. Spool pin caps (Large) 22. Overedge foot C 3. Overcasting foot M 9. Screwdriver 11. Cloth guide with guide O 15. Quarter inch foot with screw 19. Instruction book 27. Foot storage compartment (marked with letters
corresponding to the machine...
Instruction Manual - Page 7
...sewing speed by the foot control and the speed control lever. The machine runs at the maximum speed set by the speed control slider when the foot control is varied by the speed control lever according to install...on the controller the faster the machine runs.
when attaching or removing parts.
- For appliances with a polarized plug (one way. To increase sewing speed, slide the lever to...
Instruction Manual - Page 8
...bobbin.
5 Thread cutter signal
NOTE The auto thread cutter can damage your machine. The cutting action may cause stitching problems. Improper bobbins can be used for threads #30 or finer. If you ...face plate of the machine to become tangled if the needle is not set in a down position the LED signal on the button will remain on the machine.
4 Reverse button When sewing with the needle up...
Instruction Manual - Page 11
.... Match the ribs on knee lift while sewing will effect feeding of fabric and the thread tension.
11
NOTE Keep leg away from lifter while sewing. The lifter will advise you to lower the... about 1/4" (0.7 cm)
higher than the locked up , the machine will beep and the LCD screen will not
stay locked at this higher setting. The extra area helps
1
when putting different presser feet on ...
Instruction Manual - Page 12
... needle and presser foot to your machine.
1 1
2
3 2
Removing...: Align the hole in the presser foot holder with the threaded hole in the manual for further information.
See page 25 in the presser bar and insert the thumbscrew...Pin 6 Identification letter
CAUTION When selecting the proper foot for the right sewing technique. Lower the presser foot holder to the information in place. ...
Instruction Manual - Page 14
...bottom of the spool. The spool caps may cause stitching problems. Improper bobbins can cause the threads to drop down from...2 Bobbin case cover plate
3 Bobbin
NOTE Use only SINGER® Class 15 bobbins in your bobbin case and machine.
3 1
2
3
5
5
1
4
4
Go... small spools.
4 Small spool 5 Small spool cap
NOTE When sewing with spool caps. Winding the Bobbin 1
Removing the bobbin Slide...
Instruction Manual - Page 15
...fully wound, the machine will stop the bobbin when it has made several turns, and cut the thread. 2 2
1 1
Winding the Bobbin
Step 1 Pass the thread through the thread guide on the thread guide post from behind.
1 Thread guide bar
Step 2... spindle
Step 4 Put the bobbin on the bobbin winder spindle. The SINGER® Studio™ S18 sewing machine has an independent motor for bobbin winding.
Instruction Manual - Page 33
... 1) 3-7 Overedge foot C 3
3 Place the fabric edge next to the guide of the foot and then
2
sew.
1 Edge of fabrics
1
2 Guide of fabric
to prevent fraying.
After sewing, trim the seam allowance close to
create beautiful and flat seam finishes. The SINGER® Studio™ S18 sewing
machine is on the machine, set the stitch width at 5.0 or wider to prevent the...
Instruction Manual - Page 35
...sew the left side of the zipper, attach zipper
foot E with a long stitch length and loosened thread tension. Lower presser foot holder and snap onto right or left pin.
1 Groove
2 Pin
3 Zipper foot connected to right side
4 Zipper foot connected to install...the groove of the zipper opening in fabric.
Zipper Sewing
Machine Setting Stitch pattern: Thread tension: Presser foot: Foot ...
Instruction Manual - Page 36
... at the end of the upper fabric 6 Opening size 7 Fold 8 Seam with basting stitches
Step 4 Set the stitch length and thread tension back to the fold and secure in place with the pin on the right...to the original settings on the zipper tape. Lower the foot and stitch the remainder of the seam. 9 Slider 10 2" (5cm) before zipper foot E reaches the slider on the sewing machine. Lower the ...
Instruction Manual - Page 56
... manual is adjusted by the needle drop position.
The patterns 04 and 05 cannot be changed, but the needle drop position will move. Sew guiding the fold along the guide. 4 Guide...Blind Hem
Machine Setting Stitch pattern: 04 or 05 (Mode 3) Thread tension: 1-4 Presser foot: Blind hem foot G Foot pressure: 3
Select the pattern 04 for woven fabrics or pattern 05 for a blind hem when manual is ...
Instruction Manual - Page 60
... the automatic thread cutter with the handwheel.
The LCD screen shows a twin needle icon and the maximum permissible stitch width is not available in the machine. 1 2
3 4
To sew
Machine Setting Stitch Pattern: 23 (Mode 3) Thread tension: 2-4 Presser foot: Satin stitch foot F Foot pressure: 3
Press the twin needle button . The maximum permissible stitch width is...
Singer S18 I STUDIO Reviews
We have not received any reviews for Singer yet.