Sealey BSCU170 Support and Manuals
Get Help and Manuals for this Sealey item
This item is in your list!
View All Support Options Below
Free Sealey BSCU170 manuals!
Problems with Sealey BSCU170?
Ask a Question
Free Sealey BSCU170 manuals!
Problems with Sealey BSCU170?
Ask a Question
Popular Sealey BSCU170 Manual Pages
Instruction Manual - Page 2
... the battery. have the cord or plug replaced immediately by the plug rather than the cord...part that are the same number, size and shape as this battery charger for charging LEAD-ACID batteries only. SAFETY SYMBOLS
1. Use of damage to a qualified service person when service or repair is not intended to supply power to use this manual contains important safety and operating instructions...
Instruction Manual - Page 3
... the battery will corrode and damage the charger.
8 8
DO NOT set the battery on .
6.6. Stay clear of the battery is necessary to the NEGATIVE (NEG, N, -) battery post as valve regulated lead acid batteries (VRLA), carefully follow all of the battery manufacturer's specific precautions while charging and recommended rates of the charger.
4.3. Connect...
Instruction Manual - Page 4
...will light when the battery is being drawn by its handle and set it does not fit the outlet, have a proper grounded outlet installed by tightening all modes. ●Digital Display. Use this ....you are unscrewed enough so they do not scratch the surface of the following instructions: Slide all local codes and
ordinances. This is the start and stop button for the correct input
voltage...
Instruction Manual - Page 5
...Set the type of battery to MANUAL CHARGE. (The TIME LED will light.
Set the BATTERY TYPE to 4A, 20A or 70A. Set the MODE to be used with 12V batteries with the safety instructions in Manual...five minutes then switch back to charge the battery completely, efficiently and safely.
Manual Charging
1.
NOTE: Be sure to set the time (shown in sections 5, 6 and 7.
2. Failure to do...
Instruction Manual - Page 6
...go into Abort Mode. If MANUAL CHARGE mode is selected and the timer is set to HOLD, the maximum time ...to 14.8, with Flash Reprogramming, press ● to OEM specifications). Desulfation Mode If the battery is left discharged for an ... deep cycle battery, the CHARGED LED comes on the following the instructions given in Sections 6 and 7.
2.
General Charging Notes Fans: The...
Instruction Manual - Page 7
...SPECIFICATIONS
Input 220-240V~ 50/60Hz 10A Output: Charging mode 12V 4A / 20A / 70A Desulfation mode 15.8V max. MAINTENANCE INSTRUCTIONS
12.1. 12.2. 12.3. After every 100 hours or whenever you see sections 5.8 and 6.7). Servicing... case. 12. These fans push a lot of air and are no user-serviceable parts.
13. Store the charger unplugged. Reprogram mode 13-14.8V 0-70A, 100A...
Instruction Manual - Page 8
... it must be sorted, taken to alter data, specifications and component parts without prior notice.
Note: It is accepted for ...proof of in compliance with the environment. TROUBLESHOOTING
PROBLEM
NO DISPLAY AND THE LEDS ARE NOT LIT. CHECK FOR OPEN...MAINTENANCE INSTRUCTIONS
BLOW THE DIRT AND GRIME OFF THE FAN BLADES USING COMPRESSED AIR AS DESCRIBED IN MAINTENANCE INSTRUCTIONS.
...
Sealey BSCU170 Reviews
Do you have an experience with the Sealey BSCU170 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Sealey yet.
Earn 750 points for your review!