RCA MGWHTR Support and Manuals
Get Help and Manuals for this RCA item
Popular RCA MGWHTR Manual Pages
Warranty Card - Page 1
... BY PURCHASER FOR THE PRODUCT. This Warranty gives you specific legal rights and you may not cause harmful interference, and (2) this device must accept any interference received, including interference that should be plugged in so that interference will be repaired or replaced with the instructions, may not apply to you , call toll-free to...
Installation Manual - Page 1
MYGUARD
AUTOMATIC HOT WATER HEATER SHUT-OFF SYSTEM Installation Guide
Installation Manual - Page 2
...! Control unit
with connection wire and sensors attached
Automatic shut-off servo included in this package, and you through the steps to get set to provide an additional (3) Wire ties with anchors (2) Carriage Bolts, M5 x 30 x 0.8(mm)
(#6 x 1-1/4" Phillips pan-head... tap to stop a disaster before it happens! WHAT'S IN THE PACKAGE?
This installation guide takes you 're set up.
Installation Manual - Page 4
...
72mm(2.83")
Option 3: Masonry screws (included)
1. Press the control unit firmly against the wall where you want to drill.
2. Masonry screws
3. Draw x's on the screws.
5. Install the dry-wall anchors at each x for masonry applications)
1. Peel off the exposed side of the control unit. 3. Use a 5/32" masonry drill bit to mount...
Installation Manual - Page 5
... x 24)
2 flat washers 2 lock washers
Find the bracket slots on the shut-off servo
Find the following pieces in place.
ASSEMBLE THE SERVO RING & BRACKETS
A.
2. Install the brackets on the servo, shown here. Then repeat with the other bracket. Insert a short carriage bolt through the bracket and servo slot.
Installation Manual - Page 7
... build-up and makes the valve easier to close .
IMPORTANT: Keep the centers of the the servo motor and shut-off valve aligned throughout the installation and make sure they're aligned when you 've finished opening it 's been since the shut-off several times. Position the center of the servo...
Installation Manual - Page 8
... (1) wing nut over the shut-off valve's nut as shown here. If it doesn't, replace it ! Use the provided Allen wrench to remove the small Allencap screw.
2. Tighten with the larger ...centering ring provided in place.
Remove the pre-installed (small) centering ring.
3. Install the larger centering ring. If not, replace it with the Allen wrench. STEP 3 (continued)
Does...
Installation Manual - Page 12
...corresponding round and square holes on the floor near the hot water tank.
B.
Use the other parts of the installation. Line up the round and square plugs on the control box lead to the wall. Note...
2.
Snap the leads into place.
3. Then stick the back of the way. STEP 5: SET UP THE SENSOR AND CONTROL UNIT
A. Clean the wall first. Place the floor sensor on the floor near the...
Installation Manual - Page 15
...-OFF
When the alarm goes off valve.
If either sensor senses water, the alarm sounds and the servo closes your shut-off ... You can also set the audible alarm to 10 seconds only: Press and hold the Alarm Off button again. To change back, press and hold the Alarm Off button...
Installation Manual - Page 16
Questions?
Please call our toll-free customer service hotline at 1-800-645-7750
© 2018 Voxx Accessories Corp. 3502 Woodview Trace, Suite 220 Indianapolis, IN 46268 MGWHTR Install 03
RCA MGWHTR Reviews
We have not received any reviews for RCA yet.