Pfaff hobby serger Support and Manuals
Get Help and Manuals for this Pfaff item
View All Support Options Below
Free Pfaff hobby serger manuals!
Problems with Pfaff hobby serger?
Ask a Question
Free Pfaff hobby serger manuals!
Problems with Pfaff hobby serger?
Ask a Question
Most Recent Pfaff hobby serger Questions
Pfaff Hobby Serger Ts381a Is Any Good?
Is pfaff hobby serger ts381a any good? Would I be better off getting a new? Please recommend me one....
Is pfaff hobby serger ts381a any good? Would I be better off getting a new? Please recommend me one....
(Posted by yowilson 2 years ago)
Popular Pfaff hobby serger Manual Pages
Owner's Manual - Page 3
TURNING SQUARE CORNER
9
RESTITCH PART OF SEAM
10
QUESTIONS?
JOIN TWO PIECES OF FABRIC
12
CARING FOR YOUR MACHINE
12
CHANGING NEEDLE
12
PERFORMANCE CHECKLIST
12
- BLINDSTITCH
11
CONTACT YOUR PFAFF DEALER
DECORATIVE FLATLOCK
12
WHERE YOU PURCHASED THIS PRODUCT.
INSTRUCTION SYMBOLS
3
CONNECTING AND RUNNING MACHINE
3
TRIAL SEWING
3
ADJUSTING THREAD TENSION
4
...
Owner's Manual - Page 4
... nism. Thread guide 13. Presser foot holds fabric against feed system.
18. Lower looper forms lower stitch.
6. Foot switch (#287597) runs machine.
2. Style 2020 size 14 14. Upper looper forms upper stitch.
17. Sewing speed selector Low (toward II" speed selection.
8. Press down to ensure a smooth flow of machine.
19
10. PRINCIPAL PARTS
77...
Owner's Manual - Page 5
...2 x Needles (1 in
light will go out.
• Connect foot switch (3) to run machine and turn on lever)
• Turn hand wheel to make sure it is not tangled under needle... switch plugged in machine) #2020-014
3 x Demo thread spool (on machine)
INSTRUCTION SYMBOLS
To simplify understanding, the following symbols are used throughout operator's manual.
• Swing thread guide holder up to ...
Owner's Manual - Page 6
...fabric.
Turn upper thread tension dial counter clockwise to a tighter
tighter setting. Note: Seam guide is plugged into machine.
• Press foot switch to wrong
side of fabric, side...tension dial
tension dial
dial clockwise
clockwise to a clockwise to a to a
looser setting. tighter setting.
Threads lock together smoothly, well balance. • Plug in adaptor and foot ...
Owner's Manual - Page 7
..., it is necessary to rethread machine. (refer to Page 6)
• Unplug foot switch.
• Swing thread guide holder up to operating position. • Remove front cover by lifting gently at tab on right side. • Connect AC adaptor (only) to turn on light for threading. • For best sewing performance use proper spool...
Owner's Manual - Page 8
...; Insert threader into two discs.
Dj
Use tweezers to near internal cover (about width of tweezers).
Place thread between two loopers. A
• Bring thread through guide (A-2).
4
A4
• Raise lower looper to place thread into left .
THREADING PATH A (LOWER LOOPER) STEP 1
Ai • Draw thread (A) through threader.
• Pull threader towards...
Owner's Manual - Page 9
... to lowest position. fID iII
• Use tweezers to place thread into right side hole (B-4).
• Guide thread through threader.
• Pull threader towards you threading looper from back to front.
• Guide thread through rear guide (B-3). needle clamp body
• Turn handwheel toward
Lower needle clamp body to highest position.
THREADING PATH...
Owner's Manual - Page 10
... fabric feed.
• Turn handwheel about 8 times to form thread chain.
• If chain will not form check threading. • After producing chain , start to guide (0-2).
PREPARATION FOR FORMING THREAD CHAIN
9 (,c/
• Lower needle clamp body to lowest positon.
• Use tweezers to needle. (towards left .
• Pull thread down to...
Owner's Manual - Page 11
... High or Low sewing speed. • Stan stitching.
\
• Lightly guide fabric.
• When seam is preset to limit stitch width to approximately 11...large needle and thread chains under stitches.
• Place fabric under presser foot touching needle and against seam guide.
SECURING TAIL CHAINS
• Place needle clamp body to lowest position.
• Apply liquid fray preventer...
Owner's Manual - Page 12
...,
overlap stitching 1 inch (25mm).
• Remove fabric and sew tail chain.
• Puil fabric to overlap previous • Lower presser foot. . IH
(I
nside Corner -
RESTITCH PART OF SEAM
4 N.
'%
• Place fabric under presser foot. • Adjust fabric to left in straight tine. • Stitch and hold fabric in fabric.
Owner's Manual - Page 13
... lines of decorative flatlock stitches.
• Turn fabric to wrong side. • Fold hem back as shown.
4.2mm
- 0
LI
• Place folded edge against seam guide.
• Stitch making sure needle just barely catches the fold. wrong skie
I \M
Fold fabric in half with wrong side facing up. BLINDSTITCH
DECORATiVE FLATLOCK
ongde...
Owner's Manual - Page 14
...; Insert flat side of needle to guide the fabric.
• Tighten screw firmly.
• Thread machine correctly. (page 6,7 & 8)
• Replace needle. (page 12) • Adjust tension. (page 4) • Thread correctly. (page 6,7 & 8) • Insert needle correctly. (page 12) • Align bar symbols (page 3)
• Replace needle. (page 12) • Set needle firmly in position.
(page 12...
Pfaff hobby serger Reviews
We have not received any reviews for Pfaff yet.