Nikon 4645 - ML 3 Camera Remote Control Support and Manuals
Get Help and Manuals for this Nikon item
Popular Nikon 4645 Manual Pages
User Guide - Page 1
...selected for purchasing the Nikon Modulite Remote Control Set ML-3. For example, lightly pressing the ...
TIPS ON CARE
32-33
ABOUT BATTERIES
33
SPECIFICATIONS
34-35
2
FOREWORD
Thank you for signal ...instruction manual of F5, F100, F90X/N90s, F90-Series/N90 or D1 camera by using the auto trigger function. CONTENTS
FOREWORD NOMENCLATURE PREPARATION Transmitter
3 4-6 7-18
Installing...
User Guide - Page 2
power is lightly/fully
conditions (with channel selector set to ON or transmission button is
off; blinks during transmission
the signal that activates the camera's exposure meter and autofocus functions; fully depress ...
shooting, C for continuous shooting, DELAY/TEST
LED): Lights up for a moment when power switch
for delaying shutter release or checking transmitting is set to A.
User Guide - Page 3
...)
Bracket (optional): For use when receiver cannot be mounted on the camera. sliding the battery chamber lid. • Be sure the transmitter's power switch is set to install batteries as shown in the battery chamber.
7
User Guide - Page 4
ON FF
O cHL,caip TRIG
(MD
)
Cir
Y
((1a)
)
4 Set power switch to . CH1 or CH2.
9 If the monitor light comes on , check battery installation or replace batteries with the channel selector
set .
5 Set the channel selector to ON. . If it does not come on for a moment, batteries have sufficient power.
sliding it blinks, batteries may be...
User Guide - Page 6
... lens or the receiver's reception sensor.
Battery check
Nikon
M.3 RECENER
O
it
0
1 Set the power/channel selector switch to the channel selector setting on the transmitter. (Receiver operates with either CH1 or CH2 setting when the channel selector setting on , check camera's battery installation or replace camera's batteries with .
If it
O
Insert the bracket between . to CH1...
User Guide - Page 8
approx. 8m (26.2 ft.) 0-10° - Distance range 10°
10°
oc ,o0g
AD, ,9a8
Channel selector setting
Set each corresponding transmitter/receiver pair to two ML-3 sets can be used in the same area without interference.
• If the transmitter is askew), the range changes
as follows: 0° - Up to the same...
User Guide - Page 9
...: Focus modes: C or M Film advance modes: C-1L or lat, Exposure modes: Programmed auto (PIPs),
Aperture-Priority Auto or ShutterPriority Auto (see camera's instruction manual) exposure
mode. lightly press the transmission button. If a connected Speedlight is set to prevent incorrect exposure caused by light leaking through the finder.
18
Single frame shooting (S)
) C141412r . Camera...
User Guide - Page 10
... direction of the reception sensor and . shooting mode selector to C. • If the camera's focus mode is set to adjust focus manually before
shooting. In the autofocus mode, focus detection starts immediately. Be sure to set the camera's focus mode to C. • Depending on .
21 The monitor light on . Point the transmitter in...
User Guide - Page 11
...
In this case, be sure to adjust focus manually before shooting.
23 DELAY/TEST. • If the camera's focus mode is set the
camera's focus mode to indicate that pictures are taken • continuously as long as the transmission button is pressed lightly.
N , OFF
Cr)
r
1 Set the shooting mode selector to S, the camera...
User Guide - Page 12
... before actual shooting.
24
Auto triggering
In this mode, the shutter is not sent during a delayed- If the camera's focus mode is recommended.
2ik TRIG
1 Set the transmitter's channel .
The monitor light will light up for a moment. The reception indicator LED starts blinking rapidly and continues blinking until a picture is useful...
User Guide - Page 13
... units are working correctly. • If the reception indicator LED blinks after lighting up, battery power is exhausted.
RaNi3 iRkECoEInVER
•
Set the receiver's 14/ ) .
Up to S or C.
Replace camera batteries.
1 Set the camera's focus mode . shooting mode to three MC-21 cords can be joined together.
!6
27 to M and the film advance...
User Guide - Page 14
... too fast, crossing at an unfocused area or from an unexpected direction, etc. • With the transmitter's shooting mode selector set to C, 2-second-continuous shooting is possible. • With the MF-26's AutoSequence Shooting function, 2-secondcontinuous shooting is possible.
...will cross the infrared ray, (2) choose an appropriate shutter speed to A. 1 1 PIG
Adjust focus manually
5 .
User Guide - Page 15
Then, attach camera to camera's remote terminal. camera plug to the tripod with standby positions (SB-29, 28/28DX, 27, 26, 25, 24, 23, 22s, 22 and 20) are recommended.
1 Attach the Speedlight to the 2 . For extended operation, speedlights with the bracket in between. bracket. No
a
3 Connect the receiver's .
F camera.
WIRELESS FLASH OPERATION
When preparing for shooting, ...
User Guide - Page 16
... batteries by storing equipment in continuous frame shooting, always use batteries with different model numbers.
Continuous frame shooting For optimum results in a cool, dry place.
...Avoid leaving in use near TV tower). At other electrical equipment such as radios or TV sets. Temperature Battery life ratings are discharged (e.g., near the sea, wipe equipment
first with a ...
User Guide - Page 17
... and OFF
Number of output Three channels (CH1, CH2 and
channels
A.
All specifications apply when fresh alkaline batteries are subject to CH1 or
CH2, monitor light blinks...single-frame shooting
C for continuous shooting
DELAY for a
moment
With weak battery power and
channel selector set to change without notice.
35
34 TRIG mode
Operating temperature -20°C - 60°C ...
Nikon 4645 Reviews
We have not received any reviews for Nikon yet.