Lowrance HOOK-7x Support and Manuals
Get Help and Manuals for this Lowrance item
View All Support Options Below
Free Lowrance HOOK-7x manuals!
Problems with Lowrance HOOK-7x?
Ask a Question
Free Lowrance HOOK-7x manuals!
Problems with Lowrance HOOK-7x?
Ask a Question
Popular Lowrance HOOK-7x Manual Pages
Operators Manual EN - Page 1
HOOK-X Series
Operation manual
ENGLISH
HOOK-4x
HOOK-5x
HOOK-7x
lowrance.com
Operators Manual EN - Page 2
All features and specifications subject to change without notice. Navico may find it necessary to change or end our policies, regulations and special offers at any time.
Compliance Statements
Lowrance HOOK-4x, HOOK-5x and HOOK-7x • meets the technical standards in accordance with Part 15.103 of the FCC rules • complies with CE under EMC...
Operators Manual EN - Page 3
...installation. This equipment has been tested and found to correct the interference by the party responsible for help
NOTE: This manual covers HOOK-4x, HOOK-5x and HOOK-7x units. However, there is encouraged to try to comply with the instructions,... technician for compliance could void the user's authority to Part 15 of the FCC rules. These limits are designed to radio communications.
Operators Manual EN - Page 5
Colorline 17 Range 17 Frequency 18 Ping speed 19 Fish ID 20 DownScan options 20 Sonar settings 22 Installation 23 DownScan operation 25 Trackback 25 DownScan menu 25 Ping Speed 27 DownScan options 27
Settings 30 Settings menu 30 System 30 Set language 31 Audio 31 Alarms 31 Units 32 NMEA 0183 (HOOK-5x and HOOK-7x only 32 Specifications 33
5
Table of contents | HOOK X series
Operators Manual EN - Page 7
... choose your own settings, do not run the setup wizard. Page menus
The DownScan and Sonar pages have menus that can only be accessed when those pages are displayed.
Basic operation
Setup wizard
The Setup wizard will appear when the unit is turned on the unit and the connected transducer.
7
Basic operation | HOOK X series Selecting pages...
Operators Manual EN - Page 11
...
Enables advanced features and settings. Restore defaults
Resets unit options and settings to clear the cursor. The following features are enabled when Advanced mode is use will run down your boat is not is turned on:
• Units (Enables distance, speed, depth, temperature, and bearings options)
• HOOK-5x & HOOK-7x only: NMEA 0183 Output...
Operators Manual EN - Page 15
... Lowrance conventional sonar transducers.
• 50/200 kHz (Low/High CHIRP)
• 83/200 kHz (Medium/High CHIRP)
To use CHIRP, select the desired CHIRP frequency from the Frequency menu.
15
Sonar operation | HOOK X series
Refer to the DownScan operation section for conventional sonar. Sonar operation
This unit supports two types of the selected transducer...
Operators Manual EN - Page 18
...any digital depth readings, or you may receive incorrect depth information. Only frequencies supported by the unit. Frequency Controls the transducer frequency used by your transducer will appear on the Frequency menu.
50 kHz
Sonar frequencies
Best depth penetration ...Low frequency ranges to help reduce/eliminate interference from other CHIRP transducers
Sonar operation | HOOK X series
18
Operators Manual EN - Page 19
..., and then filters out undesired signals.
19
Sonar operation | HOOK X series
When using fishing modes, ping speed settings are optimized for the selected fishing conditions, so in most cases, adjustments are not necessary. Ping speed adjustments can help reduce interference from other transducers. Sonar options
Noise rejection
Uses advanced signal processing to send...
Operators Manual EN - Page 22
... the selected depth range.
Manual mode
Restricts digital depth capability, so the unit will be used by advanced sonar users. Only adjustments made to conventional sonar settings will only send sonar signals to continue smooth scrolling if the bottom depth is out of transducer range. Sonar operation | HOOK X series
22 Sonar settings
Restricts unit's digital...
Operators Manual EN - Page 23
..., refer to the bottom.
Installation
Installation menu
Keel offset All transducers measure water depth from the transducer to clear settings adjustments made while using a fishing mode. see illustration next page.
23
Sonar operation | HOOK X series
Before setting keel offset, measure the distance from the transducer to the Basic Operation section. That is in manual mode, you may not...
Operators Manual EN - Page 30
Refer to factory default settings
Settings | HOOK X series
30
Settings
Settings menu
Accesses installation and configuration settings for your unit.
Displays software information
Restores settings and options to "Advanced mode" on page 11. System
Adjusts unit settings like language, mute audio and advanced mode.
(Advanced mode only, HOOK-5x &
HOOK-7x)
Settings menu
(Advanced mode ...
Operators Manual EN - Page 32
... activity. Units
Allows you to select the unit of measure used by the unit.
Basic Mode
Advanced Mode
Settings | HOOK X series
32 Unit options vary depending on the sonar screen
NMEA 0183 (HOOK-5x and HOOK-7x only) (optional Power/NMEA cable 000-0127-49)
You can also adjust the Baud rate. You can select...
Operators Manual EN - Page 33
... TFT
Waterproof IPX7
standard
Backlight
LED (11 levels)
Communications
HOOK-5x: NMEA 0183 Output (Requires optional Power/NMEA cable 000...transducer frequencies
455/800 kHz 50/83/200 kHz High/Medium/Low CHIRP
Max speed
70 mph
Transducer
HDI 50/200 kHz (Low/High CHIRP) HDI 83/200 kHz (Medium/High CHIRP) 83/200 kHz (Medium/High CHIRP)
Transducer cable 20 ft (6 m)
33
Specifications | HOOK...
Operators Manual EN - Page 34
... type
HOOK -7x General 5.3" H (234 mm) x 9.2" W (136 mm); 5.9" H (151 mm) with bracket (7" diagonal) 16-bit color Full VGA Solar MAX™ color TFT
IPX7
LED (11 levels) NMEA 0183 Output (Requires optional Power/NMEA cable 000-0127-49)
Power 500 W RMS
12 V
10 to 17 V Typical: 1.1 A 3-amp Automotive
Max depth
Available transducer frequencies...
Lowrance HOOK-7x Reviews
We have not received any reviews for Lowrance yet.