Lenovo IdeaCentre Q200 Support and Manuals
Get Help and Manuals for this Lenovo item
View All Support Options Below
Free Lenovo IdeaCentre Q200 manuals!
Problems with Lenovo IdeaCentre Q200?
Ask a Question
Free Lenovo IdeaCentre Q200 manuals!
Problems with Lenovo IdeaCentre Q200?
Ask a Question
Popular Lenovo IdeaCentre Q200 Manual Pages
Q200 User's Guide - Page 22
... disk will recover the system partition to install the software which is installed in your computer before this
operation, all the drivers and software automatically, or install some of data, be installed. In order to prevent loss of them selectively.
Note: After this operation.
31032755_IdeaCentre Q-UG.indd 17
User Guide 17
2007.12.21 2:28:36...
Q200 User's Guide - Page 35
...setting of protection against Trojan (spy) viruses, setting of the software. After the brightness setting is installed on your display brightness to the Internet before upgrade...Upgrade In the main interface of PC-cillin, click Update...set the proper display brightness according to upgrade the virus definitions of personal network and
30 User Guide... the following instructions. Note: ...
Q200 User's Guide - Page 46
...and might cause a system-wide malfunction. Perform the instructions displayed to install or uninstall a program. From the Control Panel, choose Programs and Functions. 5. Make sure the audio option in
succession Start ˠAll Programs ˠLenovo ˠDrivers and Software Installation.
5.3 Troubleshooting software problems
Problem: You are unable to the program before
removing...
Q200 Safety and Warranty Guide - Page 16
...problem with television tuner options installed
The notice below applies to products containing television (TV) tuner devices that connect to external antennas or to cable/CATV systems, or both, and that the cable ground shall be installed... guide 13
2007.12.10 3:54:49 PM There are no serviceable parts inside any component that follow local codes and ordinances when installing appliances...
Q200 Safety and Warranty Guide - Page 17
Example of antenna grounding
Ground clamp
Antenna lead-in wire Antenna discharge unit (NEC Section 810-20) Grounding conductors (NEC Section 810-21)
Figure 1. Proper grounding for the cable
Power service grounding electrode system (NEC Article 250, Part H)
Ground clamps Electronic service equipment
14 Safety and warranty guide
31032752_Keywest&Hawaii SWG_EN.indd 14
2007.12.10 3:54:52 PM
Q200 Safety and Warranty Guide - Page 30
... the product sales. has performed strict collation for reasons such as misunderstanding, Lenovo (Beijing) Co., Ltd. To provide better service, Lenovo (Beijing) Co., Ltd. Welcome to instructions and requirements in all the manuals included with your computer and the content of the manual at any time without prior written permission of all documents shipped with your...
Q200 Hardware Replacement Guide - Page 4
... is intended to as trained service personnel who are replacing Field Replaceable Units (FRUs).
This guide does not include procedures for parts ordering information. Note Use only parts provided by -step procedures. This guide contains procedures for replacing the following parts:
• Power supply • Memory modules • Adapter • Hard disk drive • Optical...
Q200 Hardware Replacement Guide - Page 38
... new speaker cable to the "Completing the installation." Remove any media (diskettes, CDs, or tapes) from the drives, shut down the computer, and turn off all power cords from electrical outlets. 3. Your speaker might need to confirm the updated information in the Hardware Maintenance Manual.
Replacing the External speaker
1. Disconnect the failing speaker...
Q200 Hardware Replacement Guide - Page 39
... hinges and sides of the defective CRU. Refer to "Starting the Setup Utility" in the User Guide or in the Hardware Maintenance Manual. Important
Correctly route all power supply cables to avoid interference with the CRU or will come a few days after the CRU arrives.
36 Hardware Replacement Guide
31032756_HaWaii-HRG_EN.indd 36
2008.1.8 3:31:44 PM
Q200 Hardware Maintenance Manual - Page 10
...ESD common ground or reference point when working on ac-operated computers. Hardware Maintenance Manual
Handling electrostatic discharge-sensitive devices
Any computer part containing transistors or integrated circuits (ICs) should be verified by equalizing the charge so that meets the specific service requirement. Most clothing is desirable but not required to electrostatic discharge (ESD...
Q200 Hardware Maintenance Manual - Page 19
... your name or your user name • Not be easily compromised. However, to set , you can set , it is set passwords to your supervisor password.
17 Using the Setup Utility
Using passwords
By using the Setup Utility program, you can be any passwords to use a strong password that cannot be a common word or a common name • Be significantly different from...
Q200 Hardware Maintenance Manual - Page 26
... 1 beep Memory refresh timer error
FRU/Action Reseat the memory, or replace with known good modules.
2 beeps Parity error in card, replace or reseat the
adapter)
video adapter. Remove all expansion
cards except the video adapter.
• If beep codes are absent, one at a time until the problem
happens again. Hardware Maintenance Manual
Beep symptoms
Beep symptoms...
Q200 Hardware Maintenance Manual - Page 28
... Mouse or set keyboardless operation in Setup to Enable. To purposely configure the computer without a keyboard, set PS2 Mouse support is no keys are invalid.
The computer loads the default configuration settings. You can be found Keyboard error
System Haulted Press TAB to reboot the machine. This message appears after a fatal error has been detected. Replace the battery...
Q200 Hardware Maintenance Manual - Page 51
... speaker cable from the computer and connect the new speaker cable to close the computer cover and reconnect cables, including telephone lines and power cords. Completing the installation
After replacing the parts, you might be connected to the Audio connector to "Locating connectors on the rear of the
computer" and "Locating connectors on the...
Q200 Hardware Maintenance Manual - Page 52
Refer to "Starting the Setup
Utility" in the User Guide or in the Hardware Maintenance Manual. Information about this will come with the CRU or will come a few days after the CRU arrives.
50 Hardware Maintenance Manual
3. To update your configuration settings, refer to "Locating connectors on the rear of the defective CRU. Close the computer cover...
Lenovo IdeaCentre Q200 Reviews
We have not received any reviews for Lenovo yet.