Kenwood TK-980 Support and Manuals
Get Help and Manuals for this Kenwood item
This item is in your list!
View All Support Options Below
Free Kenwood TK-980 manuals!
Problems with Kenwood TK-980?
Ask a Question
Free Kenwood TK-980 manuals!
Problems with Kenwood TK-980?
Ask a Question
Popular Kenwood TK-980 Manual Pages
Operation Manual - Page 1
INSTRUCTION MANUAL
VHF FM TRANSCEIVER
TK-780
UHF FM TRANSCEIVER
TK-880
800 MHz FM TRANSCEIVER
TK-980
© B62-1322-30 (M) 09 08 07 06 05 04 03
Operation Manual - Page 2
... FINE OR IMPRISONMENT OR BOTH. ◆ REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
Turn OFF your vehicle, make sure they are carried in progress, or where "TURN OFF TWO-WAY RADIO" signs have been posted.
SAFETY: It is detected coming from the container. If you chose KENWOOD for any transceiver.
PRECAUTIONS
Please observe the...
Operation Manual - Page 5
... cable kit
• Fuse (10 A) Mounting bracket Speaker jack cap Screw set:
• Self-tapping screw (4 pieces) • Hex-headed screw with washer (4 pieces) • Spring washer (4 pieces) • Flat washer (4 pieces) Instruction manual
Quantity 1
1 set 1 set
1 1
1 set
1
Microphone and microphone cable
(TK-980 only)
Microphone hanger with the carrier immediately. We recommend that you...
Operation Manual - Page 6
... instructions are required for installing the...install a rubber grommet.
2 Run the two power cable leads through .
• If no hole exists, use by your KENWOOD dealer, an authorized KENWOOD service... facility, or the factory. PREPARATION
VARIOUS ELECTRONIC EQUIPMENT IN YOUR VEHICLE MAY MALFUNCTION IF THEY ARE NOT PROPERLY PROTECTED FROM THE RADIO...
Operation Manual - Page 7
... PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE SUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN THE EVENT OF A COLLISION.
1 Mark the position of the transceiver. Flat washer
Spring washer
4 x 16 mm self-tapping screw (TK-980 only) Microphone hanger (TK-980 only)
Power input connector
Microphone and microphone cable (TK-980 only)
5 x 16...
Operation Manual - Page 8
ORIENTATION
FRONT PANEL AND MICROPHONE
q
w
e
r
t
y
u * The microphone comes only
with the TK-980 transceiver.
y MON, A, B, pC, Do, and SCN keys Press these keys to activate their programmable auxiliary functions {page 6}. u PTT switch To transmit, press and hold this ...
Operation Manual - Page 9
... the auxiliary function is pressed. Flashes when you are locked/ not locked out of the TK-980 transceiver is different.
5
Displays the system, group, and channel numbers. Also displays received ...Power input External connector speaker jack
Antenna connector * The above diagram shows the TK-780/ TK-880 transceiver. Appears when the selected channel is programmed as priority. The right...
Operation Manual - Page 10
... only be programmed with the auxiliary functions listed in the following table.
Please contact your dealer for additional programmable keys.
◆ Only the TK-780 and TK-880 transceivers support Conventional Format. Note: ◆ If "Function" is programmed onto one of the above mentioned keys, the microphone keypad can also
be used for...
Operation Manual - Page 13
... speak into the microphone. Release the PTT switch to receive.
• For best sound quality at a time. 5 To end the call only if the telephone service is available and you hear the dispatcher's voice, readjust the volume as Tel Disconnect.
9 Refer to "MAKING A DTMF CALL" on page 17. TRUNKING FORMAT
TRUNKED...
Operation Manual - Page 15
... channel. Three types of the scanning sequence are scanned. When a call .
Group Scan is set by your dealer for both trunked and conventional systems. This feature is useful when more than one...When scanning trunked systems, the revert groups and the groups not locked out of the scan sequence manually. It scans the revert groups as well as the new revert system and group. • ...
Operation Manual - Page 18
...PTT
Press to initiate a call.
(Microphone Keypad)
Use the microphone keypad to scroll manually.
FleetSync: ALPHANUMERIC TWO-WAY PAGING FUNCTION
FleetSync is an Alphanumeric Two-way Paging Function,...location data. 14 GPS REPORT
If a GPS unit (NMEA-0183 format) is installed on the transceiver and the Send GPS function is available on microphone keypads only.)... by JVC KENWOOD Corporation.
Operation Manual - Page 19
... talk group. A maximum of 9 received messages can be limited by using the microphone keypad if Manual Dial is enabled. (Press to erase an incorrect digit.)
4 Press the PTT switch and begin ...all fleets (Supervisor call , press the PTT switch and speak into the microphone.
■ Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. To respond to the...
Operation Manual - Page 20
... the station
you want to call. • You can also enter digits by using the microphone keypad if Manual Dial is
enabled. (Press to erase an incorrect digit.) 4 Press the A or # key to enter ... message you want to
transmit. • You can also enter digits by using the microphone keypad if Manual Dial is
enabled. (Press to erase an incorrect digit.) 6 Press the PTT switch to initiate the Status...
Operation Manual - Page 21
... in a RIC (Repeater Inter-Connect) Trunking system, the DTMF code is transmitted after a connection is transmitted after a connection with a...) CALLS
MAKING A DTMF CALL
Note: To make a call by dialing manually: 1 Press and hold the PTT switch. 2 Enter the desired digits ...the transceiver in order for more than 16 digits will cause an error
tone to sound. ◆ In store and sending mode, ...
Operation Manual - Page 23
... the TK-780 and TK-880 transceivers support the tone for further information on these tones. Please contact your dealer for Conventional Format. Tone
Alert Busy DBD On DBD Off Delay Deny Free System Ring Back Mode/ System Search Mode Group Call Individual Call Intercept Key Input Error Key Press [A] Key Press [B] Key Press [C] Password...
Kenwood TK-980 Reviews
Do you have an experience with the Kenwood TK-980 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Kenwood yet.
Earn 750 points for your review!