Kenwood KAC-PS500F Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood KAC-PS500F manuals!
Problems with Kenwood KAC-PS500F?
Ask a Question
Free Kenwood KAC-PS500F manuals!
Problems with Kenwood KAC-PS500F?
Ask a Question
Kenwood KAC-PS500F Videos
???????? ?????????? Kenwood KAC PS400M ? KAC PS500F. ????-????????!
Duration: 3:42
Total Views: 275
Duration: 3:42
Total Views: 275
Popular Kenwood KAC-PS500F Manual Pages
User Manual - Page 2
....
• Install this unit in the car. 7. terminal of the battery.
2CAUTION
• If sound is not output normally, immediately turn power off and check connections. • Be sure to turn the power off .
2CAUTION
Do not use because the surface of settings and connections possible according to applications, read the instruction manual well...
User Manual - Page 3
...-Pass Filter) position:
The filter outputs the band of higher frequencies than the frequency set with this control.
# Fuse (20 A × 4)
$ Battery terminal
% ...Set to this amp. Failure to use the unit as a stereo amplifier. • MONO (Lch) position: Amplifies the signal input from the beginning of the center unit connected to "Specifications" on the center unit's instruction manual...
User Manual - Page 4
... INDICATOR lights in a parallel configuration.
• Speakers that this wiring should be separated from troubles. NOTE
The speaker cable and the sigma servo cable should be obtained when the sigma servo ... combined impedance is particularly high with the ground. • The temperature of the internal parts may be the cause of breakdown.
This makes it lights in contact with the woofer...
User Manual - Page 5
... Terminals
Connect the speaker output cables to respective terminals. Lead terminal (Commercially available part)
2CAUTION
• Speakers that are to this unit should have an impedance of...
RIGHT
B
ΣSERVO Ι FEED BACK
A
B
Terminal cover
Battery cable (Commercially available part)
ΣΣ
Rear right speaker Rear left speaker
Front right speaker
FUSE(20A×4)
BATT....
User Manual - Page 6
... be added easily to the results calculated from the formula above. Failure to set a crossover frequency of 120 Hz using a coil and capacitor•••...
R
L
LINE OUT Σ SERVO Ι
R A+B
FEED BACK
Left speaker
Right speaker
sTri-mode
With the KAC-PS500F, a subwoofer can implement a wide range of 6dB/oct.
slope
0 dB -3 dB
Crossover Frequency
Coil (L): Passes low...
User Manual - Page 7
...set to the correct position.
of the sigma servo terminals is too small (or too large). Specifications
Specifications... (1 kHz) Signal to change without notice.
Troubleshooting guide
Often, what appears to be blown because the ...Replace the fuse with wrong + / polarity.
• A speaker cable is not set...calling for service, please...Set switches properly by a screw in the car ...
Kenwood KAC-PS500F Reviews
We have not received any reviews for Kenwood yet.