Intel S875WP1 - EATX MBD 875 P4 DDR-2CH SATA RAID VID GETH Support and Manuals
Get Help and Manuals for this Intel item
View All Support Options Below
Free Intel S875WP1 manuals!
Problems with Intel S875WP1?
Ask a Question
Free Intel S875WP1 manuals!
Problems with Intel S875WP1?
Ask a Question
Popular Intel S875WP1 Manual Pages
Product Guide - Page 4
... Serial ATA Cable (Optional 54 Connecting Internal Headers 55 Connecting the Front Panel Header 55 Connecting the USB 2.0 Header 56 Connecting Hardware Control and Power Cables 57 Connecting Fans ...58 Chassis Intrusion...58 Connecting Power Cables 58 Setting the BIOS Configuration Jumper 58 Clearing Passwords ...59 Replacing the Battery...60
iv
Intel Server Board S875WP1-E Product Guide
Product Guide - Page 9
... ATA
connectors.
ATI Rage* XL Video Controller with support for RAID 0, 1, and 10. 1 Server Board Features
This chapter briefly describes the main features of the desktop board. Table 1 summarizes the major features of Intel® Server Board S875WP1-E.
Table 1. This server board is planned. • The server board S875WP1LX includes an additional four-port Serial ATA controller to...
Product Guide - Page 10
Table 1. Server Board Features (continued)
BIOS
Intel/AMI BIOS with support for:
• Advanced Configuration and Power Interface (ACPI)
• 8 megabit symmetrical flash memory
• Support for SMBIOS • Intel® Rapid BIOS Boot • Intel® Express BIOS Update
Power Management
Support for ACPI:
• Suspend to RAM (STR)
• Wake on USB, PCI, RS-232, PS/2, ...
Product Guide - Page 14
... 8x
14
Intel Server Board S875WP1-E Product Guide
It is driving the processor data bus, although the data bus ECC can be disabled or enabled by design, but only fully qualified DIMMs will be supported.
The FWH provides the nonvolatile storage of the following : • An integrated DDR memory controller with AHA bus • Intel 82802AC Firmware Hub (FWH...
Product Guide - Page 15
... to
the LAN connect component • 33 MHz Peripheral Component Interface (PCI) Local Bus slots supporting PCI
specification, Rev 2.3. • Power management logic (ACPI Rev 2.0-compliant). • Support for storing and updating of platform information
Video
The server board S875WP1-E contains two separate, mutually exclusive graphics subsystems. You can use either the AGP connector or the...
Product Guide - Page 18
... the BIOS Setup program.
18
Intel Server Board S875WP1-E Product Guide The serial ports' NS16C550-compatible UART supports data transfers at speeds up to 115.2 kb/s with the 82077 diskette drive controller and supports both PC-AT and PS/2 modes. The serial port A connector is located on /reset.
The +5 V lines to these connectors are located on /reset password can be set...
Product Guide - Page 19
... the back panel. USB 1.1 devices will function normally at USB 1.1 speeds. By default, Legacy USB support is used even when the operating system's USB drivers are implemented with USB 1.1 devices. Use s shielded cable that fully support USB 2.0 transfer rates. Legacy USB support is set to install an operating system that supports USB. The S875WP1-E server board fully supports UHCI and...
Product Guide - Page 20
...
All 32-bit, 33-MHz PCI I/O for the server board S875WP1-E is set to Enabled and follow the operating system's installation instructions.
✏ NOTE
Legacy USB support is for the server board S875WP1-E is disabled. 2. When the user applies power to disable the device.
20
Intel Server Board S875WP1-E Product Guide Other USB devices are recognized and may be allocated a GPIO to...
Product Guide - Page 22
... protocol is similar to Ultra DMA and is device driver compatible.
✏ NOTE
ATA-100/66 is a 1 x 2-pin connector that can be wired to the BIOS. The interface handles the exchange of the add-in SCSI controller and the IDE controller.
22
Intel Server Board S875WP1-E Product Guide The BIOS supports Logical Block Addressing (LBA) and Extended Cylinder Head...
Product Guide - Page 26
...Support
When the PME# signal on the PCI bus is disabled by default in BIOS).
26
Intel Server Board S875WP1-E Product Guide In addition, software, drivers, and peripherals must be capable of these wake-up events from an ACPI S1, S3, S4, or S5 state (with Wake on PME enabled in the BIOS Setup... PME# signal Resume on Ring (back panel Serial Port A) USB PS/2
...from this option to provide ...
Product Guide - Page 33
...When the S875WP1-E server board's jumper is set to Available in Setup are automatically configured for use by specifying manual configuration in ESCD format. Reattach the AC power cables and power on the server. 9. Replace the jumper at jumper block J8G1 so that is identified as necessary. The S875WP1-E server board supports system BIOS shadowing, allowing the BIOS to configure...
Product Guide - Page 34
... unless another language is fault tolerant to that the updated BIOS matches the target system to prevent accidentally installing an
incompatible BIOS. • Updates both the BIOS boot block and the main BIOS. With this utility, the BIOS can be flashed in the BIOS Setup program.
34
Intel Server Board S875WP1-E Product Guide
BIOS Updates
The BIOS can be updated from a CD-ROM disk.
Product Guide - Page 68
... features
Selects boot options and power supply controls
Saves or discards changes to Setup program options
* For information about the BIS, refer to normal mode at : http://developer.intel.com/design/security/index1.htm
68
Intel Server Board S875WP1-E Product Guide This chapter tells you should write down the current Setup settings. The BIOS Setup program is set to the Intel Web site...
Product Guide - Page 88
... only if a user password has been set .
88
Intel Server Board S875WP1-E Product Guide This feature appears only if both a user password and a supervisor password have been set . 2.
Table 33. Notes:
1. User Password Is
No options
Reports if there is a supervisor password set .
Limited: User can view BIOS Setup, but cannot make limited changes in BIOS Setup, except for intrusions...
Product Guide - Page 96
... to set correct values. continued
96
Intel Server Board S875WP1-E Product Guide Pri Master HDD Error Pri Slave HDD Error Sec Master HDD Error Sec Slave HDD Error
Could not read /write test of DMA controller. CMOS Battery Low
The battery may have either been corrupted or the battery has failed. Replace the battery soon. These values have been corrupted.
BIOS Error Messages
Error...
Intel S875WP1 Reviews
We have not received any reviews for Intel yet.