Intel BOXD201GLY2A Support and Manuals
Get Help and Manuals for this Intel item
View All Support Options Below
Free Intel BOXD201GLY2A manuals!
Problems with Intel BOXD201GLY2A?
Ask a Question
Free Intel BOXD201GLY2A manuals!
Problems with Intel BOXD201GLY2A?
Ask a Question
Popular Intel BOXD201GLY2A Manual Pages
Product Specification - Page 3
...CAUTION
Cautions are included to important information.
# INTEGRATOR'S NOTES
Integrator's notes are used in all specifications of this level of the BIOS error messages and POST codes
Typographical Conventions
This section contains information about the Desktop Board D201GLY2 and its components to system integrators. It is intended to provide detailed, technical information about the...
Product Specification - Page 24
...; Supports wake events (driver dependent) • Mic in pre-amp that supports dynamic, condenser, and electret microphones
The audio subsystem supports the...Intel Desktop Board D201GLY2 Technical Product Specification
1.7.1 Serial Port
The serial port A connector is located on the back panel. The serial port supports data transfers at speeds up to set the parallel port mode. Use the BIOS Setup...
Product Specification - Page 29
... can be turned off . working D0 -
device specification specific.
The operating system uses information from the computer.
Table 7 lists the power states supported by the system chassis' power supply.
2. working state. sleeping state
G1 -
No power to the system. Full power > 30 W
G1 - D3 - No power to the system. Product Description
1.11.1.1 System States...
Product Specification - Page 30
...Intel Desktop Board D201GLY2 Technical Product Specification
1.11.1.2 Wake-up Devices and Events
Table 8 lists the devices or specific events that provides full ACPI support.
Setting this state
S1, S4, S5 (Note)
Modem (back panel Serial Port A) PME# signal Power..., drivers, and peripherals must fully support ACPI wake events.
1.11.2 Hardware Support
CAUTION
Ensure that the power supply...
Product Specification - Page 31
...wake-up signal that provides full ACPI support.
1.11.2.1 Power Connector
ATX12V-compliant power supplies can damage the power supply.
Failure to provide adequate standby... technologies from an AC power failure, the computer returns to the power state it is in the BIOS Setup program's Boot menu. ...power supply must be set using the Last Power State feature in a power-managed state.
Product Specification - Page 44
... jumper blocks. Intel Desktop Board D201GLY2 Technical Product Specification
2.3 Jumper Blocks
CAUTION
Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer before changing a jumper setting. Otherwise, the Desktop Board could be damaged. Item A B
Description Front panel audio header/jumper block BIOS Setup configuration jumper block...
Product Specification - Page 46
... two match. Table 20 describes the jumper settings for booting.
Recovery
321
None
321
The BIOS attempts to configuration mode and the computer is displayed. When the jumper is set to recover the BIOS configuration. A recovery diskette is required.
46 Intel Desktop Board D201GLY2 Technical Product Specification
2.3.2 BIOS Setup Configuration Jumper Block
This 3-pin jumper block...
Product Specification - Page 50
... merely following the instructions presented in this document will result in a system with the reader. Failure to do so could cause components to the Intel Celeron Processor 200 ...regulator circuit. Intel makes no changes are based on chassis selection, please refer to the case studies in the TMDG document. Intel Desktop Board D201GLY2 Technical Product Specification
2.6 Thermal ...
Product Specification - Page 63
... Features
What This Chapter Contains
3.1 Introduction 63 3.2 BIOS Flash Memory Organization 64 3.3 Resource Configuration 64 3.4 System Management BIOS (SMBIOS 65 3.5 Legacy USB Support 66 3.6 BIOS Updates 66 3.7 Boot Options 67 3.8 Adjusting Boot Speed 68 3.9 BIOS Security Features 70
3.1 Introduction
The board uses an Intel BIOS that is stored in the BIOS and reports if...
Product Specification - Page 64
...cards. Intel Desktop Board D201GLY2 Technical Product Specification
Table 29 lists the BIOS Setup program menu features. BIOS Setup Program Menu Bar
Maintenance Main
Advanced Security
Clears passwords and displays processor information
Displays processor and memory configuration
Configures advanced features available through the chipset
Sets passwords and security features
Power
Boot...
Product Specification - Page 65
...ATA hard drive as event detection and error logging Non-Plug and Play operating systems ...manual configuration in the BIOS Setup program, the BIOS automatically sets up to optimize capacity and performance. The BIOS supports...status, and installation dates for accessing this support, an SMBIOS service-level application ...Resource data, such as memory size, cache size, and processor speed •...
Product Specification - Page 66
...on the Web. • Intel® Flash Memory Update Utility, which enables automated updating while in the
Windows environment.
Legacy USB support is disabled. 2. NOTE
Review the instructions distributed with the upgrade utility before attempting a BIOS update. For information about
BIOS update utilities
Refer to
http://support.intel.com/support/motherboards/desktop/sb/CS022312.htm...
Product Specification - Page 67
...specification. The default setting is for details.
3.6.2 Custom Splash Screen
During POST, an Intel® splash screen is invoked even if the following devices are supported in the Intel® Integrator Toolkit utility. Boot devices are available in US English. Accordingly, if there is supported in the BIOS Setup...ROM installed. Check the Intel website for the hard drive to be set ...
Product Specification - Page 70
... characters in the BIOS Setup program. Intel Desktop Board D201GLY2 Technical Product Specification
3.9 BIOS Security Features
The BIOS includes security features that restrict access to the BIOS Setup program and who can boot the computer. This is not displayed on the screen.
Supervisor and User Password Functions
Password Set
Supervisor Mode
User Mode Setup Options
Neither
Can...
Product Specification - Page 75
... Sleep state
F8
EFI boot service ExitBootServices ( ) has been called
F9
EFI runtime service SetVirtualAddressMap ( ) has been called
FA
EFI runtime service ResetSystem ( ) has been ... to recover
Error Messages
75 Port 80h POST Codes (continued)
POST Code
Description of POST Operation
DXE Drivers
E7
Waiting for user input
E8
Checking password
E9
Entering BIOS setup
EB
Calling...
Intel BOXD201GLY2A Reviews
We have not received any reviews for Intel yet.