Husqvarna YTH18K46 Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna YTH18K46 manuals!
Problems with Husqvarna YTH18K46?
Ask a Question
Free Husqvarna YTH18K46 manuals!
Problems with Husqvarna YTH18K46?
Ask a Question
Husqvarna YTH18K46 Videos
Husqvarna YTH18K46 Review BEST Husqvarna YTH18K46 Review
Duration: 1:59
Total Views: 1,618
Duration: 1:59
Total Views: 1,618
Popular Husqvarna YTH18K46 Manual Pages
Owners Manual - Page 2
... ruts, bumps, rocks, or other attachments; Always turn off engine and wait for all instructions on the machine and in severe injury or death. These operators should evaluate their ability to operate the riding mower safely enough to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it .
• Mow up...
Owners Manual - Page 4
....
PRODUCT SPECIFICATIONS
Gasoline Capacity and type: Oil Type (API-SG-SL):
Oil Capacity:
Spark Plug:
Ground Speed (MPH/KPH): Charging System: Battery:
Blade Bolt Torque:
2.5 Gallons/9,46 L Unleaded Regular
SAE 10W30 (above is available through your nearest authorized service center/department.
age" sections of the California Public Resources Code). In the state of a new tractor...
Owners Manual - Page 6
... to disengage transmission (See "TO TRANSPORT" in front of tractor is operating properly.
Verify that all belt keepers.
✓ Check wiring. PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓ All assembly instructions have been completed. ✓ No remaining loose parts in carton. ✓ Battery is properly prepared and charged. ✓ Seat is adjusted comfortably and tightened...
Owners Manual - Page 13
... MOWER HOUSING" in the tractor seat, start engine. Sitting in the Service and Adjustments section of mower should be used .
13 Depress reverse drive pedal to give best performance of manual).
3. Repeat this section of the attachment being used when the mower housing is wet. that has been cut desired.
• When operating attachments, select a ground speed that will plug mower...
Owners Manual - Page 14
...tractor does not cover items that have been subjected to see if you should replace the spark plug, clean or replace air filter, and check blades and belts for Loose Fasteners C Check/Replace Mower Blades T Lubrication Chart 0 Check Battery Level R Clean Battery and Terminals
Clean Debris Off Steering Plate Check Transaxle Cooling
Check Mower Levelness
Check V-Belts
Check Engine Oil Level
Change...
Owners Manual - Page 15
... the engine.
• The attachment clutch should never operate unless the operator is in the
Service and Adjustments section of this manual).
NOTE: Protect your local parts dealer.
Lbs
62-75 Nm). ROS "ON" POSITION
ENGINE "ON" POSITION (NORMAL OPERATING)
BLADE
BLADE BOLT (SPECIAL)
MANDREL ASSEMBLY
STAR
CENTER HOLE
Fig. 15
BATTERY
Your tractor has a battery charging system...
Owners Manual - Page 16
... or transmission while engine is running or while the transmission is used for checking level. CLEAN AIR SCREEN
Air screen must meet API service classification SG-SL. • Be sure tractor is not required for dirt, grass clippings and other cooling shrouds.
Pour slowly. TO CHANGE ENGINE OIL (See Fig. 16 & 17)
Determine temperature range expected before oil change if the tractor is...
Owners Manual - Page 17
... up any holes in mower with the cutting deck engaged until the deck is in engine or transmission will shorten the useful life of the mower deck. MAINTENANCE
SPARK PLUGS
Replace spark plugs at the left end of your tractor. Water in the "DISENGAGED" position, set the parking brake, and stop the engine.
3. Drive the tractor to a level, clear spot on your lawn, near enough to a water...
Owners Manual - Page 18
... arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it is on level surface and engage parking brake. • Lower attachment lift lever to "STOP" and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in "DISENGAGED...
Owners Manual - Page 19
...link (E) into bracket, slide
collar (L) onto guide and secure with washer and retainer spring (J). Position hole in link assembly over pin (B) on outside of this manual.
Lift rear corner of
mower and position slot in arm over pin (D) on opposite side of tractor.
• Insert end of trac- SERVICE AND ADJUSTMENTS
• ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - E
A
B
Fig...
Owners Manual - Page 21
.... 4. Install mower (See "TO INSTALL MOWER" section in this section of manual). • Work belt off the steering plate
(F) and remove from tractor rear to be replaced without tools. SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 31)
The mower blade drive belt may also check brake by placing freewheel control in "transmission disengaged" position. Install belt on...
Owners Manual - Page 23
... problems, take your tractor to an authorized service center for service or replacement, it from starting. • Check wiring. The fuse holder is necessary, see engine manual. Grasp hood at the factory and adjustment should not be purged after reinstallation and before operating the tractor. If adjustment is located behind the dash. See "PURGE TRANSMISSION" in the Repair
Parts...
Owners Manual - Page 24
Allow the engine to cool before painting. TRACTOR
Remove mower from one ounce of oil through spark plug hole(s) into cylinder(s).
• Turn ignition key to "START" position for a few seconds to distribute oil.
• Replace with new spark plug(s). When mower is to be disconnected and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in the Maintenance section of the season...
Owners Manual - Page 25
... dead battery. 2. Check/replace solenoid or starter. Clean and regap or change oil.
6. Replace fuel filter.
8. Spark plug wire loose.
10. Dirty engine air screen/fins.
11. Contact an authorized service center/department. Worn, bent or loose blade. 2. Replace damaged parts.
25 Out of grass, leaves, trash under mower. 3. Dirty air filter. 6. Water in Service Adjustments...
Owners Manual - Page 26
... set between half and full speed (fast) position before stopping engine.
1. See Operation section.
26 Frozen idler pulley. 4. Replace blade mandrel. 5. Engine speed too slow.
1. Mower deck not level.
4. Buildup of grass, leaves, and trash around mandrels.
1. Check wiring and connections. 5. Replace battery. 2. Place freewheel control in transmission during
shipment or servicing...
Husqvarna YTH18K46 Reviews
We have not received any reviews for Husqvarna yet.