Husqvarna YT42CS Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna YT42CS manuals!
Problems with Husqvarna YT42CS?
Ask a Question
Free Husqvarna YT42CS manuals!
Problems with Husqvarna YT42CS?
Ask a Question
Popular Husqvarna YT42CS Manual Pages
Operation Manual - Page 2
... traction with the ground and cause you may block your tractor. II. Tires can occur if the operator is clear of riding mower-related injuries.
Shut off blades, set parking brake, stop before operating or storing the machine. GENERAL OPERATION
• Read, understand, and follow all instructions on a slope, is dangerous. CHILDREN CAN BE SERIOUSLY INJURED...
Operation Manual - Page 3
...bed with manufacturer's recommended parts, when necessary. • Mower blades are a major factor...Adjust and service as required. • Maintain or replace safety and instruction labels, as...blades, shift into reverse and back down slopes, not across. • Watch for Ride-On Mowers
III.
Do not attach towed equipment except at all slopes requires extreme caution. V. GENERAL SERVICE...
Operation Manual - Page 5
..., it means when you to negative (-) terminal with the exception of this manual.
Battery location will make assembly easier. NOTE: For battery installation see "REPLACING BATTERY" in the Service and Adjustments section in the Maintenance section of those parts left hand is located between terminals) charge battery for shipping purposes. A
Fig. 2
5 Positive terminal must be...
Operation Manual - Page 6
... the Operation section of this manual.)
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:
✓ Engine oil is at the factory.)
✓ Ensure mower deck is operating properly. PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓ All assembly instructions have been completed. ✓ No remaining loose parts in carton. ✓ Battery is...
Operation Manual - Page 11
... brake pedal all turns slowly. Too heavy of this manual.
11 To service engine and mower, see the Maintenance section of a load, while on hills. • If stopping is dangerous. TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
Fig. 12 NOTE: To protect hood from damage when transporting your tractor, ensure transmission is strongly discouraged. Tires can lose...
Operation Manual - Page 13
... FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.
1. Place tractor safely on...manual.
• The left hand turns until finished (See Fig. 13). Shut- Drive tractor forward for approximately 5 feet (1,5 m) then backwards for normal operation. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this section of mower...
Operation Manual - Page 14
... once a year you should replace the spark plug, clean or replace air filter, and check blades and belts for wear. At least once a season, check to operator abuse or negligence. To receive full value from the warranty, operator must maintain tractor as instructed in the Service and Adjustments section of this manual. IF YOU FEEL THEY...
Operation Manual - Page 15
... vent holes open or remove caps or covers. Should the transaxle ever leak or require servicing, contact your tractor is in the
Service and Adjustments section of this manual.)
TIRES
• Maintain proper air pressure in the disengaged position.
Replace belts if they begin to clean fan or transmission while engine is running with the...
Operation Manual - Page 18
... FUEL FILTER (See Fig. 24)
The fuel filter should be replaced once each use. 1. CLUTCH/BRAKE PEDAL CLEAN TOP SIDE
STEERING PLATE
STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
Fig. 25
• Keep finished surfaces and wheels free of all gasoline, oil, etc.
• Protect painted surfaces with your tractor's Operator's Manual) onto...
Operation Manual - Page 19
... INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
• Depress brake pedal fully and set parking brake. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key to "STOP" and remove key. • Ensure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from under tractor until it is spring...
Operation Manual - Page 20
... spring (J). J F
E H Fig. 30
• Install belt onto electric clutch pulley (M). A
• ATTACH FRONT LINK (E) - Lift rear corner of mower and position slot in tractor front suspension bracket (F).
• Insert end of tractor. Insert rod end of link assembly through front hole in link assembly over pin (B) on opposite side of this manual.
B
F
M
A
E
C
D
Fig. 32
20...
Operation Manual - Page 23
...factory and is set front wheel toe-in same position as shown.
If "jumper cables" are not adjustable. WEAK OR
FULLY CHARGED
DEAD BATTERY BATTERY
Fig. 40
REPLACING BATTERY (See ...BLACK grounding cable to good chassis ground, away from tractor.
• Install new battery with terminals in or camber, contact a qualified service center. TO ATTACH JUMPER CABLES • Connect one...
Operation Manual - Page 25
...IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. Always follow the mix... Clean entire tractor. (See "CLEANING" in the Maintenance section of this manual.)
• Inspect and replace belts, if necessary. (See belt replacement instructions in the Service and Adjustments section of this manual.)
•...
Operation Manual - Page 26
... or damaged wiring. 4. Contact an authorized service center/department. Replace fuse. 5. Clean underside of fuel. 2. Worn, bent or loose blade. 2. Tighten loose part(s). See "TO START ENGINE" in fuel.
9. Depress brake pedal. 2. Disengage attachment clutch. 3. Dirty air filter.
4. Replace blade. Out of mower housing.
4. Engine not "CHOKED" properly. 3. Loose...
Operation Manual - Page 27
... cell(s). 2. Air trapped in transmission during
shipment or servicing. 5. Replace blade mandrel. 5. Travel speed too fast.
2. TROUBLESHOOTING
PROBLEM
CAUSE
Engine continues to run when operator leaves seat with blades listed in parts manual.
11.
Worn/damaged mower drive belt. 3. Frozen blade mandrel.
1. Replace with attachment clutch engaged
1. Turn switch "ON". 2. Faulty...
Husqvarna YT42CS Reviews
We have not received any reviews for Husqvarna yet.