Husqvarna GT48XLSi Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna GT48XLSi manuals!
Problems with Husqvarna GT48XLSi?
Ask a Question
Free Husqvarna GT48XLSi manuals!
Problems with Husqvarna GT48XLSi?
Ask a Question
Most Recent Husqvarna GT48XLSi Questions
Can I Switch From Smartswitch To A Key Switch
(Posted by gom19644 3 years ago)
Smart Switch
mower starts and runs great for about 5 minutes then just shuts off, all the lights on the switch go...
mower starts and runs great for about 5 minutes then just shuts off, all the lights on the switch go...
(Posted by sturgonon 3 years ago)
Smartswitch Will Not Turn Green And Start
Smartswitch will not turn green and start. Followed all troubleshooting in manual with no success.Se...
Smartswitch will not turn green and start. Followed all troubleshooting in manual with no success.Se...
(Posted by aylorr 9 years ago)
Popular Husqvarna GT48XLSi Manual Pages
Owners Manual - Page 4
.... TABLE OF CONTENTS
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 4 CUSTOMER RESPONSIBILITIES 4 ASSEMBLY 5-6 OPERATION 7-15 MAINTENANCE SCHEDULE 16
MAINTENANCE 16-20 SERVICE AND ADJUSTMENTS 21-27 STORAGE 28 TROUBLESHOOTING 29-30 WARRANTY 31-34 ESPAÑOL 36
4 age" sections of the California Public Resources Code). In the state of a new tractor. Federal laws apply on or near...
Owners Manual - Page 5
... instructions). • For battery and battery cable installation see "RE- (1) Oil Drain Tube
UNASSEMBLED PARTS
Slope Sheet
(1) Quick Connect
*Installed by depressing brake pedal.
• Place freewheel control in disengaged position to disengage transmission (See "TO TRANSPORT" in the Operation section of this manual.
TO ROLL TRACTOR OFF SKID (See
Operation section for location...
Owners Manual - Page 6
...tractor, check to see "TO TRANSPORT" in the Operation section of this manual).
✓ It is operating properly.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓ All assembly instructions have been completed. ✓ No remaining loose parts...shown on your tractor for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual. CHECK FOR PROPER...
Owners Manual - Page 8
...updates.
(G)* REVERSE OPERATION SYSTEM (ROS) - Used to tractor.
(EE) BLADE SWITCH SYMBOL -
Locks clutch/brake pedal into the brake position.
(CC) PARKING BRAKE SYMBOL - Used to engage mower blades or other attachments mounted to set forward movement of tractor... of mower deck or other attachments mounted to indicate low battery voltage or a charging system fault.
(J) CRUISE...
Owners Manual - Page 11
...8226; Look down hills.
• Avoid stopping or changing speed on rough, rolling terrain or hills. •... HEIGHT" in the Operation section of this manual.) • With mower in the neutral... tractor is running , depress brake pedal all turns slowly. The ROS button should only be lit. Install ... Do not operate the mower without first setting the parking brake will stop mower blades....
Owners Manual - Page 13
...Instructions for approximately three (3) seconds until the indicator returns to blinking blue and repeat this manual.
Drive tractor to primary position. Do not store, spill or use engine or carburetor cleaner products in the fuel tank or permanent damage may be refueled. 5. To avoid engine problems, the fuel system should change oil...operation you should be set to bottom of ...
Owners Manual - Page 17
... then RED battery cable and remove battery from your tractor does not function as described, repair the problem immediately. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your tractor is running, any attempt by turning counterclockwise.
• Install new or resharpened blade with stamped "THIS SIDE UP...
Owners Manual - Page 18
... the crankcase oil level before oil change if the tractor is used more than 100 hours in one year. Tighten oil fill cap/dipstick securely each eight (8) hours of the drain valve.
• Refill engine with API service classification SG-SL. Ensure dipstick cap is in lower dash and remove.
ENGINE OIL FILTER
Replace the engine oil filter every...
Owners Manual - Page 19
...Service air cleaner more often under dusty conditions.
of your tractor...oil, etc.
• Protect painted surfaces with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will not run properly using a garden hose or pressure washer to carburetor, replacement is over the air intake blower located...position in "PRODUCT SPECIFICATIONS" section of ...
Owners Manual - Page 22
...Installation in "TO REPLACE MOWER BLADE DRIVE BELT" in this manual.
C
PLACE 90° END INTO HOLE
S
T
S. ANTI-SWAY BAR
T. Position hole in arm over pin on rear mower bracket (D) and secure with retainer spring.
• Repeat on opposite side of tractor... of tractor chassis and secure with washer and retainer spring.
• Repeat on opposite side of the manual. SERVICE AND ...
Owners Manual - Page 28
... OF AN ENGINE WHILE IN STORAGE. • Empty the fuel tank by setting parking brake, disengaging
attachment clutch and using fuel stabilizer. placement instructions in the Service and Adjustments section of this manual). NOTE: Fuel stabilizer is removed from tractor for damage, breakage and wear. The oil will not be distributed during storage.
IMPORTANT: NEVER COVER...
Owners Manual - Page 30
....
10. Bulb(s) or lamp(s) burned out. 3. Faulty regulator (if so equipped). 4. Replace regulator. 4. Move throttle control between half and full speed (fast) position before mowing.
4. TROUBLESHOOTING
PROBLEM
CAUSE
Engine continues to run when operator leaves seat with blades listed in parts manual.
11. Faulty operator-safety presence control system.
Poor cut - Clogged mower deck...
Owners Manual - Page 31
...warrants to the original retail purchaser that resulting from coverage, and other manufacturers' engines under this Husqvarna® product is used for exceptions - Husqvarna will repair or replace at its discretion, any authorized Husqvarna Servicing Dealer/Center using the product immediately upon any obligations under normal use will assign the transmission / transaxle manufacturer...
Owners Manual - Page 32
... components/parts such as belts, pulleys, spindle housings, bearings, blades, rods, height adjusters, caster/anti scalp wheels etc...
However, registering your responsibility (at www.usa.husqvarna.com (US & Canada) to an authorized Husqvarna Servicing Dealer for use of oils that do not know the location of your operator's manual;
(l) Operation of the unit with improperly installed...
Parts Manual - Page 18
..., Axle Tire, Rear 23 x 10.5-12 Tube, Rear (Service Item Only) Rim Assembly, Rear Sealant, Tire (10 oz. Tube)
NOTE: All component dimensions given in U.S. GT48XLSi (96043017700), PRODUCT NO. 960 43 01-77
DECALS
16
15
17 16
14 14
4 9
1 7
6
3
2 10
5
8
KEY PART NO. TRACTOR - NO.
14 585 68 14-01 15 532 42...
Husqvarna GT48XLSi Reviews
We have not received any reviews for Husqvarna yet.