Hunter 21323 Support and Manuals
Get Help and Manuals for this Hunter item
View All Support Options Below
Free Hunter 21323 manuals!
Problems with Hunter 21323?
Ask a Question
Free Hunter 21323 manuals!
Problems with Hunter 21323?
Ask a Question
Most Recent Hunter 21323 Questions
Light On Hunter 21323 Very Dim
The LED light on a Hunter fan that is in my new house is very dim. So dim that it would only serve a...
The LED light on a Hunter fan that is in my new house is very dim. So dim that it would only serve a...
(Posted by atbwdb 6 years ago)
Fan Blade Replacement
One of the blades on my white Hunter celing fan broke. I am looking for a replacement blade for mode...
One of the blades on my white Hunter celing fan broke. I am looking for a replacement blade for mode...
(Posted by killebrew 11 years ago)
Hunter Model 28665
what is manfacturer recommended 4 speed fan / light controller for hunter model 28665 60" fan?
what is manfacturer recommended 4 speed fan / light controller for hunter model 28665 60" fan?
(Posted by dlayne 11 years ago)
Remote Control
The light goes on when I touch 1,2or 3 on the remote. The fan goes on when I use the light up or dow...
The light goes on when I touch 1,2or 3 on the remote. The fan goes on when I use the light up or dow...
(Posted by Cwilstein 12 years ago)
Popular Hunter 21323 Manual Pages
Installation Guide - Page 1
... ceiling. For instructions to install your ceiling fan, go to the service panel.
5-2. read the fan supply line through the inner holes of the fan and light kit.
o Six inches of the outlet box are turned off position, securely fasten a prominent warning device, such as a tag, to your new Hunter fan. Fan Support System
Fan Support System
Suitable Existing Fan Site
Wiring...
Owner's Manual - Page 1
Model Name
Model No. Date Purchased
Where Purchased
Type 3 Models
Owner's Guide and Installation Manual
English
Español
Form# 45031-01 20090910 ©2009 Hunter Fan Co.
For Your Records and Warranty Assistance For reference, also attach your receipt or a copy of your receipt to the manual.
Owner's Manual - Page 2
... personal injury, do not use a solid-state speed control with national and local electrical codes and ANSI/NFPA 70. SAVE THESE INSTRUCTIONS.
• Use only Hunter replacement parts. • To reduce the risk of personal injury, attach the fan directly to the
support structure of the building according to your records and warranty assistance, record information from...
Owner's Manual - Page 3
... three ways, depending on ceiling height and your preference: Low Profile, Standard, or Angled mounting. The steps in one of your Hunter fan in this manual include instructions for all three Installer's Choice mounting methods. Support Brace
Ceiling Outlet Box
For ceilings higher than 8 feet high
CAUTION: To reduce the risk of personal injury, attach the...
Owner's Manual - Page 4
.... Installing Multiple Fans? Proper ceiling fan location and attachment to a licensed installer or electrician.
If you need the following : • Locate the ceiling joist or other suitable support in sets, as they were shipped.
4 45031-01 • 09/10/09 • Hunter Fan Company Refer to the motor or fan blades. If any shipping damage to the included Parts Guide.
Owner's Manual - Page 5
...: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off position, securely fasten a prominent warning device, such as a tag, to the service panel.
2-1. Place a flat washer on the screws. Ceiling Plate
3" Wood Screw
Steps 2-3 - 2-6
5 45031-01 • 09/10/09 • Hunter Fan Company do not use slotted holes directly...
Owner's Manual - Page 6
...Profile Washer
6 45031-01 • 09/10/09 • Hunter Fan Company For Standard or Angled mounting:
3-2. Skip to an almost ...fan and remove the paper caution tag. Remove the set screw from unscrewing. Raise the fan and align the slots in the canopy with three low profile screws. Do not discard the tag until your installation is replaced with the holes in these installation instructions...
Owner's Manual - Page 7
... to a different code, so that incorporates an air gap switch (normal on (encendido)
CAUTION: The remote control device complies with part 15 of the FCC rules.
Changes or modifications not expressly approved by Hunter Fan Company could void your authority to the following two conditions: 1.
This device may cause undesired operation.
Install the included 12...
Owner's Manual - Page 8
... or wire strands are visible. Using the small wire connectors, connect the wires from the fan as follows: • The white (common) power wire from the ceiling to the white... with national and local electrical codes and ANSI/NFPA 70. For all wires and wire connectors, except for clear reception.
8
45031-01 • 09/10/09 • Hunter Fan Company Push all these connections use...
Owner's Manual - Page 9
...canopy trim ring up to align the canopy screw holes with the screw holes aligned, partially install two canopy screws into place. The tabs will snap and lock into the holes opposite the ... 6-2
Step 6-3 Canopy Canopy Trim Ring
Canopy Screw
9 45031-01 • 09/10/09 • Hunter Fan Company Rotate the hanger ball so the tab in the canopy is recommended you need to fall. Align the...
Owner's Manual - Page 10
7 • Installing the Blades and Bulb
7-1. Check the position of 190 Watts. Exceeding that restricts the light kit to a maximum of the bulb to a blade iron using four blade washers and four blade assembly screws.
7-2. Step 7-1 Blade Assembly
Screws
Blade Assembly Screw
10 45031-01 • 09/10/09 • Hunter Fan Company
GU10...
Owner's Manual - Page 11
When necessary, replace the battery with the screws already in the switch plate. Or, you can also...MN-21 battery or equivalent. Off Switch
Down Dimmer
Up Dimmer
Steps 8-1 - 8-4
Step 8-5
Step 8-6
11 45031-01 • 09/10/09 • Hunter Fan Company The up dimmer turns the light on .
8-4. The remote transmitter has four numerical buttons: 0 = Off 1 = Low speed 2 = Medium speed ...
Owner's Manual - Page 12
.... Clean wood finish blades with a direct breeze. In warm weather, use upward air flow pattern
12 45031-01 • 09/10/09 • Hunter Fan Company The fan has four settings in warm weather to prevent scratching. You may use a soft brush or lint-free cloth to cool the room with a furniture polishing cloth...
Owner's Manual - Page 13
... when operating, use the enclosed balancing kit and instructions to make sure wattage of light bulbs installed match the specifications on , replace fuse, or reset breaker. 2. Check to balance the fan. 3. Problem: If the light on 1. If you need parts or service assistance, please call 888‑830‑1326 (In Canada, call 1-866-268-1936) or visit...
Parts Guide - Page 1
... TO THE INSTALLATION MANUAL FOR FULL ASSEMBLY INSTRUCTIONS. Hardware (Drawn to Scale)
x 1 x 2 x 4 x 2 x 3
x 3 x 1 x 4
x 13
Low Profile Washer 3" Wood Screw
Flat Washer 1.5" Wood Screw Screw, Low Profile
Canopy Screw
Setscrew
Mounting Isolator
Screw, Blade Assembly
Balancing
x 1
Kit
Wire
x 4
Connector
x 13
Flat Washer
Hanger Bracket Assembly
Blade Assembly
Bulb Assembly
Fan Parts
(Not...
Hunter 21323 Reviews
We have not received any reviews for Hunter yet.