Hoover FH40000 Support and Manuals
Get Help and Manuals for this Hoover item
View All Support Options Below
Free Hoover FH40000 manuals!
Problems with Hoover FH40000?
Ask a Question
Free Hoover FH40000 manuals!
Problems with Hoover FH40000?
Ask a Question
Popular Hoover FH40000 Manual Pages
Owners Manual - Page 2
...described ih the instructions. The plug must be connected to a Hoover Stiles and Service Center or Authorized Hoover Warranty Service Dealer.
• Use cleaner only for all local codes and ordinances....install float before servicing the cleaner,
• Follow manufacturer's instructions for its intended use at any tinde,
° Keep hair, loose clothing, fin_ers, feet and all parts...
Owners Manual - Page 3
...Recovery tank Automatic shut-off ......... To clean filters .......... Nozzle E. Floor cleaning
concentrate
*Some models include a second set of the cleaner body.
How to this manual. Upper handle C. hoover.corn
A
i 'i. f To contact us:- automated service dealer locator
. 1-800-263-6376 - Assembly
Handle assembly ........... Service
14 15-16
17 18
Warranty
19
J
f
A. Brush assembly...
Owners Manual - Page 4
...to models with either 6 or 7 brushes. cleaning solution
15.
4. Clean solution tank cap/measuring cup
6. Recovery tank lid and filter 10. Soft hand grip
12.
2. Mode selector dial: turns brushes
16.
pickup and dry vacuuming
... grounded outlet.
4 17
11
1
_.
13
J
This user manual applies to release
14. 1 3
T_his cleaner is intended
use.
fied on data plate on back of cleaner....
Owners Manual - Page 5
... a snap is felt. dle (C) with hole (B) on upper han- Install brushes and n°zz!e
To install brushes, place handle in
place.
Q
lign control rod (B) on bottom of cleaner. Tilt cleaner back so that it snap in upright position. Assemble handle
Rotate bottom handle support (A) up to the upright position until post fits easily...
Owners Manual - Page 8
...dial to wood floors, follow the flooring manufacturer's recommendations.
Your HOOVER FloorMate TM SpinScrub TM Cleaner can be used to wet clean sealed...for worn finish, bare wood or sepaTM Cleaner to both vacuum dry debris and wet clean non-carpeted floor surfaces such...Refer to "How to clean" section for use FloorMate of these conditions exist.
In this position, the brushes will...
Owners Manual - Page 9
... surface floors such as vinyl, linoleum, marble, laminate wood, polyurethane sealed wood or other tiles, some models include a set of HOOVER@ Grout Cleaner*.
*Available at additional cost if not included with gray bristles. J Continued -_
before using water to remove and replace the brush assemblies.)
Using cup, measure 1-1/2 cupfuls (3 oz.) of grout brushes with your...
Owners Manual - Page 10
... Cleaner* cannot be locked in Hoover your model.
J
_If
rubber ring (D) on cap has become dislodged,
reposition it locks in place.
10 J
Slide tank straight into tank (B).
Rotate cap clockwise until latch snaps in place. formance and to line (C) (1 quart) with uneven side against ledge (E) as shown.
O Replace cap. DO NOT use cleaning...
Owners Manual - Page 11
The recovery tank is full and must be emptied after dry vacuuming and before wet operation.
Remove
filter lid (A), then remove filter (B). Allow filter to air dry between uses.
To remove tank, press down on release button (B) ...
Owners Manual - Page 12
Reposition filter. Press down firmly until snapped in place. Replace lid onto recovery tank, pressing down firmly until it under running water.
Recommended cleaning sequence
Use your HOOVER® FloorMate TM SpinScrub TM Cleaner to:
• Dry Vacuum to the WASH position (B).
To remove debris from screen, remove the pleated filter from screen (D).
The brushes...
Owners Manual - Page 13
...FloorMate of suction (see "Automatic shut-off" section).
*Available at additional cost if not included with your model...not use any
Set Mode selector dial to DRY VAC position and vacuum floor. Continue ... Cl eani g floo s
NOTE: Your HOOVER® FloorMate TM SpinScrub TM cleaner may also be used...See "Cleaning the brushes" for removing and replacing brushes.
3
Fill solution tank with water. ...
Owners Manual - Page 15
J
While holding nozzle in the upright position for easier assem- J
15
Align middle section (E) of the nozzle.
Cleaner should be in place, slide latches inward to lock place. bly of nozzle with opening (F) on cleaner. O To replace nozzle, make sure latches (D) are out.
Owners Manual - Page 16
.... Tilt cleaner back so handle rests on bottom of nozzle with a mild detergent and rinsed. Set aside. Remove nozzle. Press brush assembly firmly to loci< in the upright position. J
16 The ...brushes can be washed with opening (G) on cleaner. To replace brushes, align post (C) on brush block with hole (D) on floor. Return cleaner to prevent leaking....
Owners Manual - Page 17
...set for WET PICKUP.
/ Make sure recovery tank is installed properly.
¢" Empty recovery tank.
¢" Make sure filter and filter lid are properly positioned.
¢" Check Model selector dial to ensure it is set...Mode selector dial to ensure it Cleaning solution won't dispense Brushes won 't run
problems.
Low suction
Water puddling behind cleaner Won't pick up dirty solution
Cleaner pushes ...
Owners Manual - Page 18
...cleaner _o Hoover in delay. To
approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover
Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot) by the complete model number when requesting information or ordering parts. (The model number appears on the back of Hoover on-line at hoovencom OR
¢" Checking the Yellow Pages under "Vacuum Cleaners - If...
Owners Manual - Page 19
... in use , in accordance with the Owner's Manual against original defects in the U.S.A., phone 1-800-944-9200 OR visit Hoover on-line at no cost to you, all labor and parts to place this appliance in a comf_erciat or rental application. Warranty service can only be required before service is rendered.
1.
Appliances purchased elsewhere are questions...
Hoover FH40000 Reviews
We have not received any reviews for Hoover yet.