HP ProDesk 480 G7 PCI Micro Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
This item is in your list!
View All Support Options Below
Free HP ProDesk 480 G7 PCI Micro manuals!
Problems with HP ProDesk 480 G7 PCI Micro?
Ask a Question
Free HP ProDesk 480 G7 PCI Micro manuals!
Problems with HP ProDesk 480 G7 PCI Micro?
Ask a Question
Popular HP ProDesk 480 G7 PCI Micro Manual Pages
Maintenance and Service Guide - Page 2
... additional requirements may require upgraded and/or separately purchased hardware, drivers, software or BIOS update to change without notice. Then select Manuals.
This computer may not be bound by the terms of Windows. SD is always enabled.
To access the latest user guides, go to http://www.hp.com/support, and follow the instructions to http://www.microsoft...
Maintenance and Service Guide - Page 42
...
34 Chapter 4 Removal and replacement procedures
ENWW
The system automatically ...devices; For example, if you install unsupported memory modules. NOTE: ...supported
NOTE: The system does not operate properly if you are labeled DIMM1, DIMM2, DIMM3, and DIMM4.
When upgrading...● Mandatory JEDEC SPD information
The computer supports the following setups:
● 512 Mbit, 1 Gbit,...
Maintenance and Service Guide - Page 62
... up all the needed device drivers have installed an operating system other than the factory-installed operating system, check to see if it is on.
● Check the power light on the front of general suggestions before turning it in System Software Requirement Disks (SSRD).
● Spend time troubleshooting the problem with the computer or...
Maintenance and Service Guide - Page 77
... or is bad.
ENWW
Solving hardware installation problems 69 Replace the system board. Power light blinks red three times and then white two times
Use this information to isolate the faulty module. Replace DIMMs one at a time to troubleshoot the computer. Replace third-party memory with HP memory.
4. Solution
To avoid damage to the DIMMs or the...
Maintenance and Service Guide - Page 79
.... The cable is not configured for a new expansion board were installed.
Contact an authorized service provider. Cause
Solution
Network drivers are operating
cable. The network controller is attached to the correct device. Network controller stopped working without apparent cause
Use this information to troubleshoot the computer.
Be sure that the other end are not...
Maintenance and Service Guide - Page 87
... prompt during system restarts (warm boots) as well as during startup. ● Establish an administrator password that controls access to the Computer Setup (F10) Utility and the
settings described in this section. ● Establish minimum requirements for valid passwords, including length and required types of characters. ● Secure integrated I/O functionality, including the serial, USB...
Maintenance and Service Guide - Page 89
... size (for each installed module)
● System BIOS version
● ME Firmware version (Intel only)
● Video BIOS version
● Reference code revision
● Super I/O firmware version
● USB Type-C controller firmware version
● Born...number
● Integrated MAC Address
ENWW
Computer Setup-Main 81 Lists smaller subset if Basic System Information is selected.
Maintenance and Service Guide - Page 99
.... Allow No Panel configuration
When enabled, POST blink and beep codes and error messages are not generated. Default is enabled.
Default is enabled.
Button Sensitivity
Select from low, medium, or high.
Increase Idle Fan Speed(%)
Sets idle fan speed percentage. ENWW
Computer Setup-Advanced 91
Integrated Camera
Clear to disable the headphone jack.
This...
Maintenance and Service Guide - Page 103
...error condition.
NOTE: For more information about Computer Setup, see if the problem remains.
4. Table 7-1 POST numeric codes and text messages
Control panel message
Description
101-Option ROM Checksum Error...the memory test.
To manually switch to 30 days on the screen. Recommended action
1. 7 POST error messages
This section lists the error codes, error messages, and the various...
Maintenance and Service Guide - Page 104
... Computer Setup or Windows utilities.
2. Verify proper memory module type.
201-Memory Error
RAM failure.
1.
Replace DIMM with the chipset.
1. Rearrange the DIMMs so that memory modules are installed properly.
3. RTC (real-time clock) battery may need to save the memory
boot (memory added or removed). See the Removal and Replacement section for instructions on installing a new...
Maintenance and Service Guide - Page 122
...product for
manuals and
specific product
information, and
then follow the on-screen instructions.
Code is configured to enforce hardware protection to block all direct read-write access to this memory when the
(SPD) configuration module, 128
information. The Intel chipset is updated via Intel secure firmware update utility.
System BIOS code is installed in
select...
Maintenance and Service Guide - Page 132
... 70 nonvolatile memory 111 numeric error codes 95
O operating guidelines 11, 14 optical drive
installation 24 removal 24 optical drive cage removal and replacement 26 optical drives 7 overheating, prevention 11, 14
P password
Power-On 103, 104 security 103 Setup 103, 104 POST error messages 95 power cord set requirements country specific 119 power problems 59 power supply illustrated 5 operating...
User Guide - Page 11
... access this document: ▲ Type HP Documentation in the computer Maintenance and Service Guide on the inside of the system board is located in the taskbar search box, and then select HP
Documentation.
-
A diagram of the chassis. Support
To locate resources that provide product details, how-to find your model name in the taskbar search box...
User Guide - Page 12
...
Diagnostics tools
For additional information, see the computer Maintenance and Service Guide at http://www.hp.com/support.
You can request a copy from http://www.hp.com/go to http://www.hp.com/support and follow the instructions to find your product, and then select Manuals.
2 Chapter 1 Locating HP resources Type HP Documentation in printed format, you to sign up at...
User Guide - Page 13
Follow the instructions to find diagnostics tools (continued)
Topic
Location
Audible beep and light code definitions POST error codes
See the computer Maintenance and Service Guide at http://www.hp.com/support. Product updates 3
Table 1-4 Where to find your product, and then select Manuals. Product updates
To locate resources that you have the latest drivers for the computer. Table ...
HP ProDesk 480 G7 PCI Micro Reviews
Do you have an experience with the HP ProDesk 480 G7 PCI Micro that you would like to share?
Earn 750 points for your review!
We have not received any reviews for HP yet.
Earn 750 points for your review!