HP NC320m - PCI Express Gigabit Server Adapter Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
Popular HP NC320m Manual Pages
HP ProLiant Network Adapter Scripting Utility User Guide - Page 5
... Slot and port order for adapters in non-HP BladeSystem configurations • Enclosure switch bay number and...support iSCSI or TOE,
they are ignored.
• If an adapter supports multifunction parameters but the parameters are not assigned, the existing
settings...following conditions apply:
• The multifunction adapter must
upgrade to Service Pack 2 or later. Scripting 5 Multiport adapters ...
HP ProLiant Network Adapter Scripting Utility User Guide - Page 6
... combinations of adapters an error occurs. Teams on target...read from the Microsoft website for
installation instructions and a list of adapters that...individual adapters. and NDIS 5.1 intermediate drivers. Internet Protocol security
(IPsec);
...Order (TLB-PO)
• The NCU supports two or more information.
• TOE...) are set global chimney=enabled" command.
• Some HP NC-Series...
HP ProLiant Network Adapter Scripting Utility User Guide - Page 7
...Tolerance
teams, the adapters must
upgrade to Service Pack 2 or later. Internet Protocol security
(IPsec); Download article number KB912222 (http://support.microsoft.com/kb/912222/en-us... firewalls; and NDIS 5.1 intermediate drivers. o Automatic o 802.3ad Dynamic with Fault Tolerance o Switch-assisted Load Balancing with Fault Tolerance (SLB)
• HP NC-Series Intel adapters that have...
HP ProLiant Network Adapter Scripting Utility User Guide - Page 12
...switch, hub).
• TargetInterruptsPerSecond-The driver will adjust the interrupt moderation setting for monitoring,
control, and automatic ...and Power Interface (ACPI) when link
is set to manual.
• OptimizationMethod-When this configuration is ...setting Auto is
hardware-dependent and can support. Increasing receive
descriptors can support. Be sure this desired DPC rate.
HP ProLiant Network Adapter Scripting Utility User Guide - Page 13
...set to manual, the user can select a Target DPC Rate and the driver adjusts the adapter's interrupt setting to achieve that are allowed if you must upgrade...address with a locally administered address. The default is always written to Service Pack 2 or later.
• VlanID-Specifies the VLAN identifier value...is supported by the adapter. current network conditions. Duplicate names are not teamed. A ...
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 3
... ...9 Restarting Virus Throttle ...9 Log and Event File ...10
Troubleshooting ...11
Potential solutions for INP configuration problems 11 Installing an Intelligent Networking Pack license 11 Using Virus Throttle ...11
Technical support...13
Before you contact HP...13 HP contact information ...13 Free automated customer support services 13
Acronyms and abbreviations...15 Index...16
Contents 3
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 5
Click Software & Driver Downloads from the left menu bar. 3. Installing the INP rpm packages
The INP licensing (hp-pel) package must be installed on the HP website (http://www.hp.com)
o hp-pel. To install the rpm packages: 1. Navigate to the HP website (http://www.hp.com). 2. Install the Virus Throttle rpm package (hp-vt). # rpm -Uvh hp-vt-..linux.rpm The INP licensing...
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 7
... to that have established connections. When "virus-like ") behavior in the requests. To start Virus Throttle immediately after installation, run the following command: # /etc/init.d/hp-vt start on system boot-up. The driver examines all outbound connection requests and determines if the request is for the delay queue and are viral in...
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 9
...occurring. Stopping Virus Throttle
To manually stop Virus Throttle, run the following command. # /etc/init.d/hp-vt stop
Restarting Virus Throttle...protocol stack.
• Known host working set size. No "virus-like " activity was initialized.
&#...been
detected since the filter driver was detected. • Packets dropped due to restart Virus Throttle. # /etc/init.d/hp-vt restart
Using Virus Throttle...
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 11
...-like " behavior.
A virus has infected your service representative.
• Installing an Intelligent Networking Pack License-contains troubleshooting information about
installing an Intelligent Networking Pack license.
• Using Virus Throttle-contains troubleshooting information about using Virus Throttle.
Using Virus Throttle
Problem
Possible cause
Possible solution
The Virus...
ProLiant Essentials Intelligent Networking Pack Linux Edition User Guide - Page 13
... Packs, refer to have the following sites offer troubleshooting information, compatibility notes, and software upgrades (including Softpaqs and drivers). Technical support
In this section
Before you contact HP...13 HP contact information...13 Free automated customer support services 13
Before you contact HP
Be sure to the HP website (http://www.hp.com).
• In other locations, see the...
Windows NT4 Network Adapter Scripting User Guide - Page 9
HP...properties that you use the HP Network and Teaming Configuration Utility ...'s documentation regarding unattended setup, and follow the ...Manual,
FailOnFault, SmartSwitch, TransmitLoadBalancing, and SwitchAsstLoadBalancing.
10
Windows NT4 Network Adapter Scripting User Guide
HP CONFIDENTIAL Codename: Gilmer Part Number: 334274-00A Last Saved On: 4/22/03 10:21 AM Revise UNATTEND.TXT to install...
HP ProLiant Essentials Intelligent Networking Pack - Windows Edition User Guide - Page 25
... Switch assisted Load Balancing with Fault Tolerance (SLB) and 802.3ad Dynamic with HP server adapter networking software, include link loss, transmit path validation, and receive path... the team has more members than the switch supports in the team because it has an incompatible setting. Click OK to networking infrastructure problems.
These features are receiving router protocol frames from...
HP ProLiant Essentials Intelligent Networking Pack - Windows Edition User Guide - Page 37
... activity
settings. Troubleshooting 37 ...settings. The NC31xx 10/100 adapters do not support the Active Path Failover mechanism. Retest
means none of the members with a status of the team
Degraded (Active Path) is a Ensure the echo node device is on the team.
Configuring advanced networking features
Problem...installed This may be expected Active Path Failover enabled behavior based...
HP ProLiant Essentials Intelligent Networking Pack - Windows Edition User Guide - Page 39
... with CDPv2. Troubleshooting 39 Open the NCU and go to receive the first
CDP or LLDP frame. These team modes do not support Fast Path Failover, Active Path Failover and Router Path Failover. This feature is expected behavior for Install a ProLiant Essentials Intelligent
licensable features.
This is disabled and I can't set the VLAN ID...
HP NC320m Reviews
We have not received any reviews for HP yet.