HP Server rp2470 Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
View All Support Options Below
Free HP Server rp2470 manuals!
Problems with HP Server rp2470?
Ask a Question
Free HP Server rp2470 manuals!
Problems with HP Server rp2470?
Ask a Question
Popular HP Server rp2470 Manual Pages
rp24xx A180 User Manual - Page 56
... the HP-UX 10.20 operating system with IPL (Y, N, or Cancel)? Select:
56
Chapter 2 A-Class server firmware is Customer installable and is for information on how to install this firmware patch on Press Enter. Refer to patch installation instructions to configure and use Ignite-UX. The following query will then display a menu. Refer to use Ignite-UX. This solution...
rp24xx A180 User Manual - Page 57
...following command string is for an error in the /etc/rc.log ...drivers (btlan3) were found on the 10.20 media.
To rebuild the kernel to allow the SD-UX (swinstall) software to a network?
Step 6.
A-Class Server Installation A-Class Server Power Up and Boot Procedures
INSTALL HP-UX
Press Enter. When installation is because the new kernel was not built with enough networking support...
rp24xx A180 User Manual - Page 66
...A-Class System Service A-Class Server Trouble Shooting
A-Class Server Selftest Failures/Warnings
A power-on selftest is conducted each time power is applied to the Chassis Code Summary section. To troubleshoot selftest failures using the front panel LEDs, proceed to identify which takes approximately 2 seconds. If the power source is valid, the problem is complete, the firmware Main Menu...
rp24xx A180 User Manual - Page 67
...codes provided by the HSC Remote Management card are useful in troubleshooting this section to refer to electrostatic discharge. A SIMM has components on both sides of the card.The acronym SIMM will be used throughout this type of error...loss of the server.
NOTE
NOTE Chapter 3
A-Class System Service A-Class Server Trouble Shooting
The LED pattern is only valid if the Firmware Main Menu ...
rp24xx A180 User Manual - Page 69
... RAM SIMM failure. Repeat step 3 until the RAM SIMM fault recurs. Step 1.
Chassis codes provided by unscrewing the knurled captive screws on both memory SIMMs or continue to troubleshoot to ground.
Single RAM Module Troubleshooting. NOTE
A-Class System Service A-Class Server Trouble Shooting
Random Access Memory (RAM) Module Fault. Always observe all RAM SIMMs except for...
rp24xx A180 User Manual - Page 70
...codes provided by the HSC Remote Management card are useful to troubleshoot this section require opening the server and exposing the system to electrostatic discharge. Step 1. Document the I/O configuration (write down the server and replace...Class System Service A-Class Server Trouble Shooting
Step 2. Step 3. Failure to step 8. Replace that I /O card failure. If the problem recurs, ...
rp24xx A180 User Manual - Page 71
... change the system board, you must replace the A-Class Exchange Base Unit (EBU).
Chapter 3
71
If the fault does not recur, install the second I /O board. If power cycling the server clears the fault, continue troubleshooting by using the "ser pim" command at the firmware main menu screen.
A-Class System Service A-Class Server Trouble Shooting
Step 5.
If power cycling...
rp24xx A180 User Manual - Page 72
... installed
WARNING: Setting DEFAULTS has failed.
WARNING: Memory has been initialized but not tested as a result of error.
WARNING: One or more details, use the 'FASTBOOT' command in the CONFIGURATION menu and reboot the system.
A-Class System Service A-Class Server Trouble Shooting
Second Level Cache Memory HPMC Fault.
A processor selftest failure requires replacing...
rp24xx A180 User Manual - Page 79
... blink in this case, also.
NOTE NOTE
A-Class System Service A-Class Server Trouble Shooting
Resetting the Web console to its default configuration will require the Web console to the Replacing an A-Class Server Exchange Base Unit (EBU) section.
7. Refer to be that will support a maximum of the server and remove the LAN cable from the LAN Web...
rp24xx A180 User Manual - Page 80
... top of HP diagnostic tools, refer to the following: Diagnostic/IPR Media User's Guide
Troubleshooting LAN
When connected to verify that the embedded disk is recognized by the server, make sure that the disks are available via ODE and STM. Password-protected disk expert tools are recognized by the server. Should this symptom occur, replace the EBU...
rp24xx A180 User Manual - Page 81
... 3
81 A-Class System Service A-Class Server Corrective Action
A-Class Server Corrective Action
Overview
Many of the procedure that comprise an A-Class server are field-replaceable. You can troubleshoot the server, identify the defective component, and replace it at your site. This section contains links to review: • Ordering Repair Parts for each field-replaceable component.
rp24xx A180 User Manual - Page 94
... install a single disk drive on the front of the bracket. b. If the defective disk drive is on the bottom, slide the unit out of either slide the unit out of the bracket or lift it straight up. Step 2. A-Class System Service A-Class Server Disk Drive Removal and Replacement
b. Note the disk drive jumper settings on...
rp24xx A180 User Manual - Page 96
... cables are seated properly in reverse. remount the disk drive(s) in the server.
Match the rounded corners of ID jumper settings is typical. reinstall the bracket in the bracket, and c. Failure to 6
Step 1. A-Class System Service A-Class Server Disk Drive Removal and Replacement
NOTE
This illustration of the power cable connector with the slot on...
rp24xx A180 User Manual - Page 100
...Class System Service Replacing an A-Class Server Exchange Base Unit (EBU)
NOTE
Replacing an A-Class Server Exchange Base Unit (EBU)
Overview
When troubleshooting a defective A-Class server has determined that the fault lies in a portion of the server that you obtain required Web Console configuration data (user names and passwords, IP address, etc.) prior to exchanging the defective server for...
HP Firmware Manager User's Guide - Page 32
... Installed Revision and Packaged Revision match. Figure 3-5 HP OFM Results
The following lists the possible results:
[OK]
The firmware update was successful without any unassigned
32 Updating Firmware Using HP Offline Firmware Manager
If the update continues to the EFI environment.
Failures could be due to an update program error, version error, a problem with the device, trouble...
HP Server rp2470 Reviews
We have not received any reviews for HP yet.