Installation and Troubleshooting Guide (.htm)
Page 22
... need the following tools and supplies to install the system in a two-post relay rack: • #2 Phillips screwdriver • 11/32-inch wrench or nut driver (if changing bracket to flush-mount configuration) • Masking tape or felt-tip pen to install the system into a two-post, open -frame relay rack... not been securely anchored in a four-post rack cabinet. Two-Post Rack Installation The two-post rack kit is used to others may result. www.dell.com | support.dell.com Replacing the Rack Doors Refer to the procedures for additional safety information regarding rack installation.
... need the following tools and supplies to install the system in a two-post relay rack: • #2 Phillips screwdriver • 11/32-inch wrench or nut driver (if changing bracket to flush-mount configuration) • Masking tape or felt-tip pen to install the system into a two-post, open -frame relay rack... not been securely anchored in a four-post rack cabinet. Two-Post Rack Installation The two-post rack kit is used to others may result. www.dell.com | support.dell.com Replacing the Rack Doors Refer to the procedures for additional safety information regarding rack installation.
Installation and Troubleshooting Guide (.htm)
Page 29
...) NOTE: These screws are shown reinstalled on other slide assembly. Rack Installation Guide 1-23 2 Using a #2 Phillips screwdriver and an 11/32-inch wrench or nut driver, remove two 12-24 x 0.5-inch pan-head Phillips screws, two nuts, and two shoulder washers from each front center bracket (see Figure 1-17). 3 Remove the...
...) NOTE: These screws are shown reinstalled on other slide assembly. Rack Installation Guide 1-23 2 Using a #2 Phillips screwdriver and an 11/32-inch wrench or nut driver, remove two 12-24 x 0.5-inch pan-head Phillips screws, two nuts, and two shoulder washers from each front center bracket (see Figure 1-17). 3 Remove the...
Installation and Troubleshooting Guide (.htm)
Page 30
... nuts on the mounting brackets on both slide assemblies that you tightened with two 12-24 x 0.5-inch Phillips screws (see Figure 1-18). Figure 1-18. www.dell.com | support.dell.com 8 Holding the left slide assembly into position in the rack. 11 Use an 11/32-inch wrench or nut...
... nuts on the mounting brackets on both slide assemblies that you tightened with two 12-24 x 0.5-inch Phillips screws (see Figure 1-18). Figure 1-18. www.dell.com | support.dell.com 8 Holding the left slide assembly into position in the rack. 11 Use an 11/32-inch wrench or nut...