Cisco AIR-LAP1310G-A-K9R Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco AIR-LAP1310G-A-K9R manuals!
Problems with Cisco AIR-LAP1310G-A-K9R?
Ask a Question
Free Cisco AIR-LAP1310G-A-K9R manuals!
Problems with Cisco AIR-LAP1310G-A-K9R?
Ask a Question
Popular Cisco AIR-LAP1310G-A-K9R Manual Pages
Hardware Installation Guide - Page 9
... of wireless LANs. OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
ix To use this guide with an autonomous access point/bridge, you should have experience working with Cisco IOS software and be familiar with autonomous access points, refer to the Cisco IOS documentation set available from the Cisco.com home page at Technical Support...
Hardware Installation Guide - Page 21
...be upgraded to the network. Autonomous Access Point/Bridge
The autonomous access point/bridge (model: AIR-BR1310G) supports a management system based on Cisco IOS software. The autonomous access point/bridge uses a single mini-PCI radio (IEEE 802.11b-compliant or IEEE 802.11g-compliant) that can be only configured as , access point, bridge, and workgroup bridge. In large installations, wireless...
Hardware Installation Guide - Page 22
... Access Point
The lightweight access point (model: AIR-LAP1310G) is associated to support access points running Cisco IOS software.
• A lightweight access points/bridge does not support Wireless Domain Services (WDS) and cannot communicate with Cisco 2006 series wireless LAN controllers or 4400 series controllers. Using a controller, you can configure the radio settings.
Cisco...
Hardware Installation Guide - Page 25
... AIR-ANT33381
10-dBi yagi antenna 12-dBi omnidirectional antenna with vertical polarization 13.5-dBi yagi antenna 14-dBi sector antenna with Cisco Aironet 2.4-GHz antennas. Not supported by the access point/bridge. Following installation, access to the unit should be professionally installed. OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide...
Hardware Installation Guide - Page 35
... Warnings, page 2-2 • Safety Information, page 2-3 • Unpacking the Access Point/Bridge, page 2-6 • Before Beginning the Installation, page 2-7 • Installation Summary, page 2-9
OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
2-1 Installation Overview
CH A P T E R
2
This chapter provides warnings, safety information...
Hardware Installation Guide - Page 39
...where structures, trees, or hills do not obstruct radio signals
to and from the unit. • Install the access point/bridge at a height sufficient to be installed in compliance with Sections 810 and 820 of the National Electrical Code and Section 54 of the Canadian Electrical Code. OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
2-5
Hardware Installation Guide - Page 43
...
Figure 2-5
1
Grounding Block
12
3 AC power cord
88830
1 F-type coaxial connectors
Installation Summary
2 Ground wire lug
Caution
You should be password-protected by incorrect power application.
The access point/bridge and power injector can be professionally installed. OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
2-9
Hardware Installation Guide - Page 50
... blinks amber. Disconnect power to associate. Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
3-6
OL-5048-06
After association, the other three LEDs indicate signal strength. If the unit does not associate to align the antenna.
• Preconfigured access point or workgroup bridge modes-the bridge Install LED does not operate. The startup...
Hardware Installation Guide - Page 53
CH A P T E R
4
Troubleshooting Autonomous Access Points and Bridges
This chapter provides troubleshooting procedures for basic problems with the autonomous access point/bridge (model: AIR-BR1310G). For the most up-to-date, detailed troubleshooting information, refer to the Cisco Technical Support and Documentation website at the following URL: http://www.cisco.com/en/US/products/hw/wireless/...
Hardware Installation Guide - Page 56
...assistance.
1
6
Radio did not flash its firmware-contact technical support for
assistance. Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
4-4
OL-5048-06 Table 4-2
LED Blinking Error Codes on an Autonomous Access Point/Bridge
Chapter 4 Troubleshooting Autonomous Access Points and Bridges
The LED blinking error codes are described in Table 4-2.
Hardware Installation Guide - Page 60
For detailed alignment instructions, refer to determine the least congested channel for Access Points. You should be password-protected by using the Install mode RSSI LED indications. For additional information, refer to the Cisco IOS Software Configuration Guide for the radio interface (802.11g).
Note To meet regulatory restrictions, the external antenna access point/bridge unit and ...
Hardware Installation Guide - Page 69
... the Access Point to Autonomous Mode, page 5-8 • Obtaining the Autonomous Access Point Image File, page 5-9
OL-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
5-1 CH A P T E R
5
Troubleshooting Lightweight Access Points
This chapter provides troubleshooting procedures for basic problems with the lightweight access point (model: LAP1310G...
Hardware Installation Guide - Page 74
... port connector (RJ-45 connector)
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
5-6
OL-5048-06 After connecting with the controller, the controller reconfigures the access point with new controller settings, but the static IP addresses for the access point and the default gateway are used only on a lightweight access point that is unable to reach...
Hardware Installation Guide - Page 75
...-5048-06
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
5-7 Clearing Manually Entered Controller Information
When you need to move your access point to allow your username in the Password field and press Enter.
Configuring Controller Information
To manually configure controller information on the controller.
Step 2
Step 3 Step 4 Step 5
Set up...
Hardware Installation Guide - Page 110
Dimensions, Test Methods and Requirements).
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
H-2
OL-5048-06 Statement 1033
Caution
To prevent damage to the power injector before... V and 600 V Single-core Cables; The external load-dump protection device must be installed across the access point/bridge power cable between the vehicle battery and the...
Cisco AIR-LAP1310G-A-K9R Reviews
We have not received any reviews for Cisco yet.