Cisco 7609S-RSP720CXL-R Support and Manuals
Get Help and Manuals for this Cisco item
This item is in your list!
View All Support Options Below
Free Cisco 7609S-RSP720CXL-R manuals!
Problems with Cisco 7609S-RSP720CXL-R?
Ask a Question
Free Cisco 7609S-RSP720CXL-R manuals!
Problems with Cisco 7609S-RSP720CXL-R?
Ask a Question
Popular Cisco 7609S-RSP720CXL-R Manual Pages
Configuration Guide - Page 9
... document comments to nexus7k-docfeedback@cisco.com
Configuring vPC Peer Links and Links to the Core on a Single Module 7-19 vPC Interactions with Other Features 7-20 Virtualization Support 7-27 vPC Recovery After an Outage 7-27 High Availability 7-28 Licensing Requirements for vPCs 7-29 Guidelines and Limitations 7-29 Default Settings 7-30 Configuring vPCs 7-30...
Configuration Guide - Page 16
... set of code
...passwords, are in boldface screen font. Document Conventions
Preface
Send document comments to nexus7k-docfeedback@cisco.com
Chapter
Description
Chapter 8, "Configuring IP Tunnels"
Describes how to configure IEEE 802.1Q-in-Q (Q-in the manual. Chapter A, "IETF RFCs supported...Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvi
OL-23435-03
Configuration Guide - Page 17
... feeds are a free service.
Cisco currently supports RSS Version 2.0.
In this situation, you might do something that could result in Cisco Product Documentation as an RSS feed and set content to be delivered directly to nexus7k-docfeedback@cisco.com
Caution Means reader be careful. OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvii
Configuration Guide - Page 19
...
Feature Basic parameters
Layer 2
Parameters
Further Information
description, duplex, error disable, flow control, MTU, beacon
Chapter 2, "Configuring Basic Interface Parameters" of this document
Layer 2 access and trunk port settings
Chapter 3, "Configuring Layer 2 Interfaces" of the interface types supported by the Cisco NX-OS software.
Table 1-1 shows where to nexus7k-docfeedback...
Configuration Guide - Page 23
High Availability for Interfaces
IP tunnels and vPCs require the Enterprise Services license. After the switchover, Cisco NX-OS applies the runtime configuration after the switchover. You must install this license on VDCs, see the Cisco Nexus 7000 Series NX-OS Virtual Device Context Configuration Guide, Release 5.x.
Once an interface is an independent logical device to...
Configuration Guide - Page 37
... enabled.
- Interfaces with Cisco-supported transceivers are using Cisco-supported transceivers, use Cisco-supported transceivers. You can be both...Guide, Release 5.x
2-13 To verify that can change a Layer 2 interface into a Layer 2 interface by using the switchport command.
To receive pause frames when you know how the remote port send parameter is enabled or desired, set...
Configuration Guide - Page 52
... auto} 5. exit 7. If you set the speed for autonegotiation, the duplex mode is automatically set to use a specific speed, you specify 10- If you... setting that you can affect the duplex mode used .
Note The interface speed that supports your changes for the same speed or set the speed before setting ...Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Configuration Guide - Page 132
... NX-OS Virtual Device Context Configuration Guide, Release 5.x.
Any feature not included in -service software upgrades (ISSUs). For all asynchronous and echo request packets, the BFD neighbor sets the TTL value to verify that client protocol.
High Availability
BFD supports stateless restarts and in a license package is bundled with Cisco NX-OS Release 5.2, you . For a complete...
Configuration Guide - Page 223
...Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
7-21 You can use LACP on both sides of the vPC peer link. With F-Series line-cards, vPC peer link and downstream vPC channels support upto 16 active LACP links. When you manually... the STP active topology. When you are already configured, but you set all the vPC peer link interfaces to run-time changes and link ...
Configuration Guide - Page 225
...and STP-based redundancy is enabled.
This convergence is excluded from both sides of the Cisco Fabric Service over Ethernet (CFSoE) protocol.
This feature eliminates the need to pin the STP root... features and Rapid PVST+. See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.x, for the Nexus 7000 Series devices does not support PIM SSM or BIDR on vPC. ...
Configuration Guide - Page 228
...error message.
7-26
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03 We recommend that is not supported... device from going up and down.
CFSoE
The Cisco Fabric Services over Ethernet (CFSoE) is a reliable state transport...comments to nexus7k-docfeedback@cisco.com
In addition, you can use -bia) for HSRP or manually configuring virtual MAC addresses ...
Configuration Guide - Page 230
...Beginning with Cisco NX-OS Release 5.0(2), you use the auto-recovery command and method. The software reinitializes the vPCs, bringing up its backward compatibility support. On ...Service Software Upgrade (ISSU), the software reload process on high-availability features.
7-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03 You must save this setting...
Configuration Guide - Page 267
... Requirement
IP tunnels require an Enterprise Services license.
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-3
Note PMTUD on all packets that the tunnel endpoint can configure IP tunnels only in the default VDC and default VRF unless you enable PMTUD, the interface sets the Don't Fragment (DF) bit...
Configuration Guide - Page 268
... interfaces was changed to 4095.
• Cisco NX-OS does not support WCCP on to a Tunnel Interface, page 8-8
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-4
OL-23435-03 The tunnels are logged on tunnel interfaces.
Guidelines and Limitations
IP tunnels have installed the Enterprise Services license for Cisco NX-OS. • You must be...
Configuration Guide - Page 283
... link is not supported.
• You should perform an EPLD upgrade to newer versions in order for EtherType configuration to take effect on the tunnel VLANs.
• Control Plane Policing (CoPP) is a trunk. Chapter 9 Configuring Q-in-Q VLAN Tunnels
Licensing Requirements for Q-in-Q Tunnels
Send document comments to nexus7k-docfeedback@cisco.com
Licensing Requirements...
Cisco 7609S-RSP720CXL-R Reviews
Do you have an experience with the Cisco 7609S-RSP720CXL-R that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cisco yet.
Earn 750 points for your review!