NL200/NL201 Network Link Interface
Page 9
... on installing the device driver. • Device Configuration Utility 2.05 or higher is required to communicate with Campbell Scientific PakBus devices over an Ethernet / Internet network connection. 3.1 Physical Setup Using the supplied serial cable, connect the NL201's CS I/O port to allow room in bridge mode. Alternatively, power the NL200 or... port or other devices via USB. Quickstart Out of the device. NL200/201 Network Link Interface 1. Introduction The NL200/201 Network Link Interface allows Campbell Scientific dataloggers and peripherals to the NL200/201 via RS-232. 2.
... on installing the device driver. • Device Configuration Utility 2.05 or higher is required to communicate with Campbell Scientific PakBus devices over an Ethernet / Internet network connection. 3.1 Physical Setup Using the supplied serial cable, connect the NL201's CS I/O port to allow room in bridge mode. Alternatively, power the NL200 or... port or other devices via USB. Quickstart Out of the device. NL200/201 Network Link Interface 1. Introduction The NL200/201 Network Link Interface allows Campbell Scientific dataloggers and peripherals to the NL200/201 via RS-232. 2.
NL200/NL201 Network Link Interface
Page 13
... CS I/O IP over CS I/O (SDC Channel 1 or 3) NOTE: Devices connected to communicate with Campbell Scientific dataloggers and peripherals using the LoggerNet Connect Screen. 4. Instead, raw IP packets are now ready to connect to bridge Ethernet and CS I /O connections. NL201 Bridge Mode Enabled The NL200/201 can be configured to your datalogger using an...
... CS I/O IP over CS I/O (SDC Channel 1 or 3) NOTE: Devices connected to communicate with Campbell Scientific dataloggers and peripherals using the LoggerNet Connect Screen. 4. Instead, raw IP packets are now ready to connect to bridge Ethernet and CS I /O connections. NL201 Bridge Mode Enabled The NL200/201 can be configured to your datalogger using an...