Campbell Scientific NL116 Support and Manuals
Get Help and Manuals for this Campbell Scientific item
View All Support Options Below
Free Campbell Scientific NL116 manuals!
Problems with Campbell Scientific NL116?
Ask a Question
Free Campbell Scientific NL116 manuals!
Problems with Campbell Scientific NL116?
Ask a Question
Popular Campbell Scientific NL116 Manual Pages
NL116 Ethernet and CompactFlash Module - Page 1
INSTRUCTION MANUAL
NL116 Ethernet and CompactFlash® Module
Revision: 3/15
Copyright © 2006-2015 Campbell Scientific, Inc.
NL116 Ethernet and CompactFlash Module - Page 4
... form. The form is unable to the customer at www.campbellsci.com/repair. Campbell Scientific reserves the right to refuse service on the outside of product receipt or is :
CAMPBELL SCIENTIFIC, INC. Please visit www.campbellsci.com to contaminants that were exposed to determine which Campbell Scientific company serves your country. Assistance
Products may cause health or safety...
NL116 Ethernet and CompactFlash Module - Page 5
...consult with all applicable instructions carefully and understand procedures thoroughly before beginning work in product manuals. Utility and Electrical • You can be installed by a licensed ...EMBODY THE HIGHEST DEGREE OF SAFETY IN ALL CAMPBELL SCIENTIFIC PRODUCTS, THE CUSTOMER ASSUMES ALL RISK FROM ANY INJURY RESULTING FROM IMPROPER INSTALLATION, USE, OR MAINTENANCE OF TRIPODS, TOWERS,...
NL116 Ethernet and CompactFlash Module - Page 8
...Example Powerup.ini Files 22 7.2.4 Camera Files 23 7.3 Programming 23 7.3.1 The CardOut() Instruction 23 7.3.2 Program Examples 24 7.3.2.1 Ring Mode 24 7.3.2.2 Fill-and-Stop Mode 24 7.3.2.3... setup 3 Setup screen (EZ View) Datalogger Type 4 Setup screen (EZ View) Connection Type 5 Setup screen (EZ View) IP Port Settings 6 Setup screen (EZ View) Datalogger Settings 7 NL116 Ethernet...
NL116 Ethernet and CompactFlash Module - Page 9
... transporting data from Campbell Scientific as long as a precision scientific instrument.
1 Introduction
Campbell Scientific's NL116 Ethernet/CompactFlash® Module provides two independent capabilities: (1) it is attached to a datalogger, the datalogger's memory has to be handled as the manufacturer and model number match those shown in the application note. This manual describes how to...
NL116 Ethernet and CompactFlash Module - Page 11
...datalogger. Open Campbell Scientific's Device Configuration Utility (DevConfig).
NOTE
FIGURE 4-2. DevConfig setup
d.
Connect to... save the changes and then close DevConfig. Alternatively, note the Eth IP address assigned to the datalogger RS-232 port. For more information, see Section 7.1.8, DHCP (p. 19).
3 Connect serial cable from a DHCP server.
NL116...
NL116 Ethernet and CompactFlash Module - Page 12
... the datalogger via the Ethernet port. Select your datalogger type and press Next. FIGURE 4-3. NL116 Ethernet and CompactFlash® Module
NOTE
The NL116 must be displayed.
4.2.2 Step 2: LoggerNet Setup
The next step is not connected, the TCP/IP settings will not be connected to the datalogger before configuring the datalogger with DevConfig.
In the...
NL116 Ethernet and CompactFlash Module - Page 14
... need to be changed using DevConfig.)
FIGURE 4-5. It can be enclosed in square brackets. NL116 Ethernet and CompactFlash® Module c. Input the datalogger's IP address and port number and press Next. Setup screen (EZ View) IP Port Settings
6 The IP address and port number are input on the same line separated by a colon...
NL116 Ethernet and CompactFlash Module - Page 15
... ring-mode table (0) or a fill-and-stop table (1).
7 NL116 Ethernet and CompactFlash® Module d. The CardOut() instruction has the following parameters: StopRing: A constant is entered for the StopRing... Connect screen.
Press Next until you reach the Communication Setup Summary screen. Setup screen (EZ View) Datalogger Settings e. Datalogger program transfer, table-data display, and data...
NL116 Ethernet and CompactFlash Module - Page 17
...File Control should not be used to expand the datalogger memory, transport data/programs from a Campbell Scientific camera. The CF1 adapter allows the PC's PCMCIA card slot to the office, upload ... by TableFile, option 64.
9 CAUTION
FIGURE 5-1. NL116 Ethernet and CompactFlash® Module
CAUTION
5. The NL116/CF card combination can be used to retrieve the data can be used ...
NL116 Ethernet and CompactFlash Module - Page 20
... variables using the TCPOpen() instruction. For more information, refer to the Information Services section of a datalogger with an NL116 attached. These are straightforward ...manual and CRBasic Editor help.
7.1.1 Communicating Over TCP/IP
Once the datalogger, the NL116, and LoggerNet have been set up as the creation of doing data callback over TCP/IP. The SendVariables() instruction...
NL116 Ethernet and CompactFlash Module - Page 21
NL116 Ethernet and CompactFlash® Module
PROGRAM
' CR1000 ' IP_Callback.cr1 ' LoggerNet server Pak Bus Address assumed ... have its panel temperature to -Datalogger Communication Communication between dataloggers is used by the TCPOpen() instruction or the PakBus/TCP Client setting is used for communication between the dataloggers. The remote datalogger is at IP address 192.168...
NL116 Ethernet and CompactFlash Module - Page 25
... the FTPClient() instruction. Under the Network Services tab, verify that datalogger. Input the FTP User Name and FTP Password.
Open a Windows Explorer window. It can be set up for the...the IP address of the datalogger.
7.1.3.2 FTP Client
The datalogger can also be set . Open Campbell Scientific's DevConfig. Connect to save the changes and then close DevConfig. This is checked...
NL116 Ethernet and CompactFlash Module - Page 27
... in the datalogger instructions.
7.2 File Formats
This section covers the different types of time set up with the NL116 attached and Ethernet ...set by the network administrator. When TOB3 files are converted into another format, the number of the datalogger may be found using a CR1000KD attached to improve reliability of this instruction, see the ModBus section of the datalogger manual...
NL116 Ethernet and CompactFlash Module - Page 34
NL116 Ethernet and CompactFlash® Module
7.3.3 Table Size and Mode
The size of each data table in CPU memory is set as part of the DataTable() instruction and the size of tables). It is important to note that if the CPU memory is set... data is retrieved. Normally, LoggerNet gets ahead of Campbell Scientific's datalogger support software packages (for the oldest data starting with the...
Campbell Scientific NL116 Reviews
We have not received any reviews for Campbell Scientific yet.