Audiovox XMC-10A - XM Satellite Radio Receiver Support and Manuals
Get Help and Manuals for this Audiovox item
View All Support Options Below
Free Audiovox XMC-10A manuals!
Problems with Audiovox XMC-10A?
Ask a Question
Free Audiovox XMC-10A manuals!
Problems with Audiovox XMC-10A?
Ask a Question
Popular Audiovox XMC-10A Manual Pages
Installation Guide - Page 1
Xpress® Satellite Radio Receiver
XMC10 Car Cradle Installation Guide
-1- Released: 9-15-05
128-7472 1 of 16
Installation Guide - Page 2
CONTENTS
Congratulations 3 Cautions and Warnings 4 Contents XMC10 5
Accessory Kit 5 Installation/Wiring Precautions 6 Setting Up and Installing Your Kit 7
Interconnect Diagram 6 Using Other Manufacturer's Mounts 9 Installing the Xpress XM® Into the Cradle 9 Connection Options 10 Mounting the Vehicle Antenna 12 Warranty 15
-2-
128-7472 2 of 16
Installation Guide - Page 3
...XM® is a trademark of 16 XM® is America's #1 Satellite Radio provider with the XM Welcome Kit and available at retailers where Audiovox main units are available at www.xmradio.com. All other fees and taxes may apply, including a one step closer to hear - Congratulations
Thank you for service sold . XM® Satellite Radio will revolutionize your specific installation...
Installation Guide - Page 4
... is not installed in a residential environment. Do not install the XMC10 car cradle in a position that you are responsible as airbags, etc.
3. Do not install the unit ...installation facility.
5. If this condition persists after corrective action, consult your view through the windshield, or obstructs viewing of safety devices, such as the vehicle operator to adhere to these instructions...
Installation Guide - Page 5
... 16 Contents XMC10
Install Manual (P/N 1287472)
Swivel Bracket (P/N 136-4048)
CLA Female Socket (P/N 154-1132)
OPTIONAL
Audio Cable (P/N SAT-RCA)
Antenna (P/N 118-1133)
1 pc. 12 Volt-to-5 Volt DC Power Adapter
(P/N 112-3456)
1 pc.
1 pc.
ACCESSORY KIT
Alcohol Cleaning Pad, Surface Cleaning Pad, Instruction Sheet, Antenna Cable Exit Plug (P/N 170-0054)
-5-
1 pc.
Cradle XMC10 (P/N 136-4041...
Installation Guide - Page 6
... the adapter to turn off . Setting Up and Installing Your Kit
NOTE: The XM signal can begin to enjoy XM® Satellite Radio as soon as the Xpress XM® Receiver and Vehicle Kit installation are no obvious satellite signal obstructions such as shown on the adjacent page to direct sunlight or, in place, using the following installation instructions, or enlist the help of 16...
Installation Guide - Page 7
... THE XPRESS XM WIRELESS FM TRANSMITTER. IF THE XMC10 IS INSTALLED USING THE OPTIONAL XMFM-1 FM DIRECT ADAPTER, DO NOT CONNECT AN AUDIO CABLE TO THE LINE OUT CONNECTOR OF THE CRADLE. 2. OR
CLA FEMALE SOCKET WIRES TO VEHICLE +12 VDC POWER RECEPTACLE
XMC10 CRADLE (REAR VIEW)
+12V to +5V DC POWER ADAPTER
TO VEHICLE RADIO ANTENNA...
Installation Guide - Page 8
...in a locked position.
CAUTION:
Do not install the swivel bracket on a leather or fabric surface, or in position on... your kit, clean the mounting surface and thoroughly wipe the area dry with the bracket retainer tab, and slide the cradle down ...so that could impair your vision, block air bag(s) or obstruct vehicle dashboard controls and/or radio CD/ cassetteoperational...
Installation Guide - Page 9
... Xpress XM® Receiver should now be installed using various vehicle-specific aftermarket brackets.
4. After making sure the connectors and guide pin hole are properly lined up, gently lower the Xpress XM® Receiver into the Cradle
SCREW HOLES (2) FOR DIRECT HARD MOUNTING
Install the Receiver as follows:
a. VERTICAL
MOUNTING
SWIVEL
CONFIGURATION
ADJUSTMENT
SCREW
XMC10 CRADLE...
Installation Guide - Page 10
... in your Xpress Receiver. (Refer to the Receiver owner's manual.) The XM audio signal can then be played through your vehicle radio when the car radio is tuned to one of 16 FM Wireless Transmitter - XMC10 SYSTEM CONNECTOR
-10-
128-7472 10 of the available frequencies. Xpress XM® RECEIVER REAR VIEW
CRADLE FRONT VIEW
CONNECTOR GUIDE PIN
RECEIVER NOTCH
Xpress XM® RECEIVER SYSTEM...
Installation Guide - Page 11
In this case, it is best to turn the Xpress Receiver FM modulator option off to the auxiliary inputs of 16 TO VEHICLE RADIO ANTENNA JACK
c.
OPTIONAL FM DIRECT ADAPTER XMFM-1 (PURCHASED SEPARATELY)
XMC10 CRADLE (RIGHT SIDE VIEW)
OPTIONAL SAT-RCA AUDIO CABLE (PURCHASED SEPARATELY) (CONNECT TO AUXILIARY AUDIO INPUTS ON VEHICLE HEAD UNIT.)
-11-
128-7472...
Installation Guide - Page 12
7. The magnet will secure the antenna in the associated User Guide and obtain an audio output. If necessary, move the antenna to the Xpress XM system as outlined in the desired position. b.
Apply power to different
-12-
Plug the antenna into the ANT connector on the back of the display to be placed on a relatively flat surface...
Installation Guide - Page 13
... another non-scratch method. Make sure you avoid any obstructions that could crimp, kink or twist the cable; After determining the optimum position, turn off Xpress XM power, disconnect the power adapter from the antenna position to the cradle. use protective grommets wherever rough openings are encountered.
Installation Guide - Page 15
...part thereof which vary from the date of this Warranty, the product is in lieu of the factory serial number/bar code label(s). U.S.A. : AUDIOVOX...been damaged through alteration, improper installation, mishandling, misuse, neglect,...satellite transmissions, repeater signal or receiver unit. This Warranty gives you specific legal rights and you .
This Warranty is to be repaired or replaced...
Installation Guide - Page 16
© 2005 Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, New York 11788
128-7472 -16-
128-7472 16 of 16
Audiovox XMC-10A Reviews
We have not received any reviews for Audiovox yet.