3M X70 Support and Manuals
Get Help and Manuals for this 3M item
Popular 3M X70 Manual Pages
Operating Guide - Page 1
.... After
reading, store them in this manual. • The reproduction, transmission or use of this manual is a trademark of Microsoft Corporation. • Internet Explorer is subject to ensure correct usage through understanding. CAUTION Before using, read the "Product Safety Guide" and this projector. X70/X80
Multimedia Projector Operator's Guide
Thank you for future reference.
Operating Guide - Page 6
...Setting Up
Arrangement
WARNING • Before installation, make sure that the projector is turned off and the power code is disconnected. • Do not set up and move the projector, while it is hot. • Install the projector...b [inch (cm)]
C
X80 :max [inch (cm)]
X80 :min X70
50(1.3) 77(2.0) 10(25) 23(58) 20(50)
77(2.0) 117(3.0) ...instructions of the "Product Safety Guide" and this manual...
Operating Guide - Page 8
... sure to activate the laptop's RGB external image output (set the laptop to CRT display or to the projector may generate extremely loud noises or other CRT or TFT monitors to be recommended to use the standard drivers in malfunction and/or damage to the instruction manual of this is attempted. • Please use other...
Operating Guide - Page 35
...support the DHCP function, select the TURN OFF. Set the address of the Network to an outer Network. The menu shows the information about the current Network setting as gateway to be used . NETWORK - The projector...ON TURN OFF
INFORMATION
Pressing the (or the ENTER) button displays the INFORMATION menu. SETUP
IP ADDRESS menu to reset the NETWORK menu items. : EXECUTE CANCEL
All items on...
Operating Guide - Page 37
.... do not try
to clean the projector or replace the lamp yourself.
• If the lamp should break (it will make a loud bang when it to burst. For lamp recycling, go to www.lamprecycle.org. (in USA) For product disposal, contact your local dealer to have the lamp replaced even if the bulb is not broken.
• Use...
Operating Guide - Page 38
... projector with the lamp door removed. memo When the lamp has been replaced after replacement) will result in place. Then, one side of the lamp door is displayed, complete this operation within 10 minutes of replacement by the handle. Be careful not to replace the lamp. is raised. Lamp (continued)
Replacing The Lamp
If the indicators or a message prompts you to replace the lamp...
Operating Guide - Page 45
... not constitute or imply a machine defect. Troubleshooting (continued)
Phenomena That May Easily Be Mistaken For Machine Defects
WARNING • Never use the projector if abnormal operations such as by referring to the manual
- Cases not involving a machine defect
Reference pages
The electrical power cord is not set up the signal source device by a power...
Operating Guide - Page 49
...the projector. Apartado Postal 14-139 Mexico, D.F. 07000 Mexico
DN00591 (X70/X80_OG_ENG)
3M ...replacement lamps, outdoor operation, or different voltages has not been tested and could damage the projector peripheral equipment and/or create a potentially unsafe operating condition. 3M Multimedia projectors and Wall Display Systems are designed, built, and tested for use of this entire manual...
Safety Guide - Page 5
... instructions for use by children. Service personnel must also read and understand the safety information contained in the "Service Manual". Explanation of other replacement lamps, outdoor operation or different voltages has not been tested and could result in death or serious injury. This projector is not intended for household use or use indoors, using the X70/X80 Multimedia Projector...
Safety Guide - Page 6
... . Adhere strictly to perform service/repair or maintenance, except as outlined in use . - Do not leave projector unattended while in the installation instructions when installing the 3M™ wall/ceiling kit.
6
3M™ Multimedia Projector X70/X80 Product Safety Guide
© 3M 2004 Do not attempt to disconnect. - Installation of the projector should be tripped over, pulled...
Safety Guide - Page 12
...
(3) (4)
(2)
12
3M™ Multimedia Projector X70/X80 Product Safety Guide
© 3M 2004
Make sure that it , as shown in place. ENGLISH
3. Insert lamp module: Carefully insert (4) the new lamp module. X70 : Optional Lamp: 78-6969-9718-4 X80 : Optional Lamp: 78-6969-9719-2 (Contact 3M customer Service.) Interlocking the 2 tabs (5) of the lamp door to secure the lamp module in the...
Safety Guide - Page 13
...are trademarks or registered trademarks of any defective parts (labor included). This warranty gives you specific legal rights and you purchased the product of their respective companies.
© 3M 2004
3M™ Multimedia Projector X70/X80 Product Safety Guide
13 Use the cables which are met.
INSTRUCTIONS TO USERS: This equipment complies with the requirements of any...
Safety Guide - Page 27
...IN DEN STRAHL BLICKEN LASER KLASSE 2 WAVE LENGTH:640-660nm MAX OUTPUT:1mW
MODEL:H-IRC4B
MANUFACTURER: B MANUFACTURED
JANUARY,2003 INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,...MODEL:H-IRC4
MANUFACTURER: B MANUFACTURED
JANUARY,2003
INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,TOKYO,JAPAN
101-0031
MADE IN CHINA
© 3M 2004
3M™ Multimedia Projector X70/X80 Product Safety Guide...
Safety Guide - Page 36
...IN DEN STRAHL BLICKEN LASER KLASSE 2 WAVE LENGTH:640-660nm MAX OUTPUT:1mW
MODEL:H-IRC4B
MANUFACTURER:
B
MANUFACTURED
JANUARY,2003
INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,...MODEL:H-IRC4
MANUFACTURER: B MANUFACTURED
JANUARY,2003
INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,TOKYO,JAPAN
101-0031
MADE IN CHINA
36
3M™ Multimedia Projector X70/X80 Product Safety Guide
© 3M...
Safety Guide - Page 45
...IN DEN STRAHL BLICKEN LASER KLASSE 2 WAVE LENGTH:640-660nm MAX OUTPUT:1mW
MODEL:H-IRC4B
MANUFACTURER: B MANUFACTURED
JANUARY,2003 INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,...
MODEL:H-IRC4
MANUFACTURER: B MANUFACTURED
JANUARY,2003 INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,TOKYO,JAPAN
101-0031 MADE IN CHINA
© 3M 2004
3M™ Multimedia Projector X70/X80 Product Safety Guide
...
3M X70 Reviews
We have not received any reviews for 3M yet.