Home » eMachines » Desktops » eMachines EL1852G

eMachines EL1852G Support Question

Find answers below for this question about eMachines EL1852G.
Need a eMachines EL1852G manual? We have 1 online manual for this item!

eMachines Overview Questions Manuals Reviews Videos Research

Question posted by reyespejo7777 on April 5th, 2013

Compatible Ram Memory For Emachine D443

Is Strontium MAC Memory SRD3 4G 1066SMAC compatible with Emachines D443?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by tintinb on April 5th, 2013 6:33 PM

This answer was accepted by the poster of the original question.

tintinb

Member since:
October 26th, 2012

Points: 7,056,560

1,100
points

Yes. You can use your Strontium MAC Memory SRD3 4G 1066SMAC memory to your laptop because according to eMachines website, this computer has the following features.

• Up to 2 GB of DDR3 system memory, upgradable to 4 GB using two soDIMM modules

Read the full information here:

http://support.gateway.com/emachines/notebook/2011/eMachines/emd/emd443/eMD443sp2.shtml

If you have more questions, please don't hesitate to ask here at HelpOwl. Experts here are always willing to answer your questions to the best of our knowledge and expertise.

Regards,

Tintin

Related eMachines EL1852G Manual Pages

eMachines EL1852 Service Guide - Page 1

eMachines EL1852 Service Guide PRINTED IN TAIWAN

eMachines EL1852 Service Guide - Page 5

... local market requirements and enhance product competitiveness, your regional office MAY have a DIFFERENT part number code to -date information available on card, modem, or extra memory capability). You MUST use the list provided by your regional web or channel. FRU Information Please note WHEN ORDERING FRU PARTS, that you with all...

eMachines EL1852 Service Guide - Page 7

... 25 Removing the Heat Sink Fan Assembly 26 Removing the Processor 27 Removing the HDD-ODD Bracket 28 Removing the Expansion Boards 33 Removing the Memory Modules 35 Removing the Power Supply Unit 35 Removing the Front I/O and Card Reader Assembly 37 Removing the Mainboard 40 Hardware Diagnostic Procedure 41 System...

eMachines EL1852 Service Guide - Page 9

System Features Component Operating system support Processor Core logic Graphics controller Memory Expansion options Connectivity Hard disk drive (HDD) Optical disc drive (ODD) ...Two DIMM slots supporting 240-pin unbuffered DDR3 SDRAM modules • Data rate supported: 1066/1333 MT/s • Maximum memory: 4 GB (using two 2 GB modules) • One PCI Express x16 slot • One PCI Express x1...

eMachines EL1852 Service Guide - Page 10

...- Ethernet jack (RJ45) - Key lock • Power LED • Power button 2 EL1852 Service Guide Memory Stick PRO (MS PRO) 220 W power supply unit (non-PFC 110V and 220V with 8 MB SPI... (VGA) port - Microphone, line-out, and line-in -1 card reader • The following memory cards are supported: - USB ports (two) - Component Card reader (optional) Power supply Antivirus software...

eMachines EL1852 Service Guide - Page 15

...) to make changes to as "Setup" or "Setup Utility" in a battery-backed nonvolatile memory called CMOS RAM. If the values and the actual hardware do not agree, POST generates an error message. ... making other changes to the security setup • When trying to configure the hardware. This memory area is turned off. The values take effect when the system is a hardware configuration program ...

eMachines EL1852 Service Guide - Page 18

... for your reference only and are not user-configurable. Parameter Processor Type Processor Speed System Memory Product Name System Serial Number System BIOS Version BIOS Release Date Asset Tag Number Description Type... the system Speed of the processor installed on the system Size of system memory detected during boot-up Official model name of the computer. Product Information The Product Information menu...

eMachines EL1852 Service Guide - Page 21

...-code attacks and prevent harmful software from executing and propagating on your OS documentation for the PCI hole or PCI memory hole which is physically installed. Select the amount of the memory between the 2 GB and 4 GB limits to enable the Intel Execute Disable Bit Technology. When enabled, some or all of...

eMachines EL1852 Service Guide - Page 23

...-saving mode when an RTC alarm occurs. Deep power off until the power button is suspend to RAM, i.e., the system shuts down with the exception of a refresh current to wake up from a power...is used . Wake Up by PS/2 KB/ Mouse Enables or disables the system to the system memory. The computer remains off mode Enables or disables compliance to the last power state before the power loss...

eMachines EL1852 Service Guide - Page 25

... level. Frequency/Voltage Control Field Enable Clock to All DIMM/ PCI Spread Spectrum Description When enabled, clock signals will be sent to the PCI and memory slots regardless of the pulses creates EMI (electromagnetic interference). This reduces interference problems with other electronics in clock speed causing the overclocked processor to disable...

eMachines EL1852 Service Guide - Page 43

EL1852 Service Guide 35 Removing the Memory Modules 1. Removing the Power Supply Unit 1. Disconnect the 4-pin and 24-pin ATX power supply cables from the chassis (2). Gently pull the DIMM upward to release the DIMM (1). 2. Press the holding clips on both sides of the DIMM slot outward to remove it from the mainboard.

eMachines EL1852 Service Guide - Page 49

... possible about the symptoms of the failure is set to the correct voltage setting. Unplug the power cord from the computer. 4. Verify that the processor, memory module(s), and expansion board(s) are firmly and properly attached to the computer and all connected peripheral devices from the computer. 3. Turn off the power to...

eMachines EL1852 Service Guide - Page 50

... pre-boot process. NOTE Please note that may differ between different platforms based on a LED display. Test base 512 KB memory. Restore CPUID value back into memory. Viewing BIOS Checkpoints Viewing all RAM below 1MB Read-Write including E000 and F000 shadow areas but closing SMRAM. 42 EL1852 Service Guide Main BIOS checksum...

eMachines EL1852 Service Guide - Page 51

... when the BIOS determines that the found flash part size equals the recovery file size. If the CMOS checksum is corrupt. Initializes both the 8259 compatible PICs in the super I/O. Check the validity of the flash part. Initialize BIOS, POST, Runtime data area. Give control to the current configuration of the...

eMachines EL1852 Service Guide - Page 52

.... Test for boot strap processor Early CPU Init Exit Initializes the 8042 compatible Key Board Controller. Testing and initialization of PS/2 mouse. Initialize System Management Interrupt. Set the window for initialization. Also, update the Kernel Variables. Display total memory in system RAM size if needed. 44 EL1852 Service Guide Traps INT1Ch vector to...

eMachines EL1852 Service Guide - Page 53

...needed . Prepares the runtime language module. End of POST initialization of ESCD in memory test. The error associated with 0FFh. Static Device Initialization (function 1); Check .... Takes care of implementation that include manual configured onboard peripherals, memory and I/O decode windows in system RAM size if needed . Display boot option popup menu. Uninstall POST...

eMachines EL1852 Service Guide - Page 55

... boot device NO ROM BASIC Description This is a generic message indicating the BIOS could not find a proper boot diskette. Memory Message Gate20 Error Multi-Bit ECC Error Parity Error RAM R/W test failed CMOS Memory Size Wrong Description The BIOS is unable to a bad cable or faulty diskette drive. This may be detected. This...

eMachines EL1852 Service Guide - Page 56

...as Master in POST. The IDE/ATAPI device configured as Secondary Master failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and configure ...initialized by the BIOS. The IDE/ATAPI device configured as Secondary Slave failed an ATAPI compatibility test. The IDE/ATAPI device configured as Slave in the 6th IDE controller could not ...

eMachines EL1852 Service Guide - Page 57

...to detect and configure IDE/ATAPI devices in the 6th IDE controller failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to replace the hard...S.M.A.R.T. The IDE/ATAPI device configured as Slave in the 6th IDE controller failed an ATAPI compatibility test. S.M.A.R.T. This message can be reported by an ATAPI device using the S.M.A.R.T. failure ...

eMachines EL1852 Service Guide - Page 97

... (non-PFC) • CP - CPB09-D220A (PFC) • CP - Card Reader Item Controller Card compatibility Specification Multi-in1 • Memory Stick (MS) - supports up to 2 TB • CompactFlash, Type I/II (CF, Type I and II) -... supports up to 2 TB • Memory Stick PRO (MS PRO) - DPS-220UB-5A (FR) • Lite-On - supports up to...