Whirlpool GGW9250PW Support Question
Whirlpool GGW9250PW Support Question
Find answers below for this question about Whirlpool GGW9250PW.Need a Whirlpool GGW9250PW manual? We have 1 online manual for this item!
Question posted by tdriver844 on May 14th, 2022
High Pitched Sqeeking At Start Up
after pushing the start button there is a high pitched squeek for about 2 min, then it goes away.
Current Answers
Answer #1: Posted by Odin on May 16th, 2022 12:40 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See the answer by Anonymous at https://www.fixya.com/support/t4627049-whirlpool_ggw9250pw3_gas_dryer_loud.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool GGW9250PW Manual Pages
Use and Care Guide - Page 3
..., the information in the vicinity of this manual must not exceed 3 feet.
3
This is , tell you how to prevent property damage, personal injury, or death.
- DRYER SAFETY
Your safety and the safety of others . These words mean:
DANGER
You can happen if the instructions are very important. Always read and obey...
Use and Care Guide - Page 4
...the Canadian Natural Gas and Propane Installation Code, CSA B149.1. s Do not reach into the dryer if the drum is removed from the accumulation of local codes, with gasoline, drycleaning solvents, ...vapors that could ignite or explode.
s Do not place items exposed to play on or in the dryer. s Do not dry articles that you understand and have been previously cleaned in, washed in, ...
Use and Care Guide - Page 5
...Shield Platinum), 8530071 (Biscuit) or 8530072 (Pewter).
Check that all parts are installing your dryer or refer to avoid having loose items fall behind the machines during operation. Read "Electrical ...so, you will need to the "Assistance or Service" section of this manual. Ask for adjusting dryer feet)
s Level
s ¹⁄₄" nut driver or socket wrench
s Knife
s Safety...
Use and Care Guide - Page 6
...you will be installed or stored in the same closet as gasoline, away from dryer. At lower temperatures, the dryer might be large enough to do not permit, installation of the door... also be considered. s Additional clearances might not shut off at temperatures below 45ºF (7ºC). Dryer only
0" (0 cm)
38" min. (96.52 cm)
0" (0 cm)
27" (68.6 cm)
0" (0 cm)
Minimum installation...
Use and Care Guide - Page 7
... - The installation must be plugged into a grounded 3 prong outlet. Recessed area B. GROUNDING INSTRUCTIONS
s For a grounded, cord-connected dryer: This dryer must be provided. WARNING: Improper connection of electric shock. Dryer only
14" max. (35.6 cm)
18" min. (45.72 cm)
48 in.2 (310 cm2)
3" (7.6 cm)
24 in mobile homes to the Manufactured Home Construction...
Use and Care Guide - Page 8
...is mounted on the model/serial rating plate for test gauge connection, immediately upstream of the dryer in accordance with appropriate conversion. Option 2 (Alternate method)
Approved aluminum or copper tubing:... (6.1 m) if local codes and gas supplier permit.
If the total length of your dryer has a ³⁄₈" male pipe thread.
gas must be installed in accordance with...
Use and Care Guide - Page 9
...lint. For more information, see the "Assistance or Service" section of fire, this dryer MUST BE
EXHAUSTED OUTDOORS. 4" (10.2 cm) heavy metal exhaust vent and clamps must not be connected...paint, wallpaper, carpets, etc. If using an existing vent system, clean lint from entering the home. Dryer B. WARNING: To reduce the risk of this elevation.
Elbow C. IMPORTANT: Observe all joints. Exhaust ...
Use and Care Guide - Page 10
... outside. Two close-clearance installations are shown here. Over the top installation (also available with dryer vent to wall vent mismatch):
Part Number 4396037 - 0" (0 cm) to 18" (45...for your local dealer. s The number of elbows used.
Bend vent gradually to have the dryer converted. Refer to order. Periscope installation
NOTE: The following kits: 279818 (white) 279925 (biscuit) 279969...
Use and Care Guide - Page 11
...
15 ft (4.6 m)
NOTE: Side and bottom exhaust installations have a 90º turn to move and install dryer.
IMPORTANT: Do not use . Install exhaust hood. See "Determine Vent Length." Use clamps to seal exterior wall...body of 90° turns or elbows you will need .
Connect vent to dryer location. Install Leveling Legs
WARNING
Excessive Weight Hazard Use two or more information, please...
Use and Care Guide - Page 12
... .
s If the gas supply line shutoff valve is level.
3. (On gas models) Check to be different, according to its final position. Bubbles will not start the dryer. Make sure dryer is closed .
11. Move dryer into its final position.
2. Level Dryer
Check the levelness of your tools.
3. If flexible metal tubing is a recommended connection. Read...
Use and Care Guide - Page 13
.... Place laundry into dryer and shut door.
NOTE: Time is desired. Pressing the More Time or Less Time buttons will be... dried on it (including cooking oils). Do not dry anything flammable on a clothesline or by using an Air Cycle. DRYER USE
More Less
Starting Your Dryer
WARNING
Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer...
Use and Care Guide - Page 14
... instructions. s Avoid drying heavy work clothes with Manual Cycles. Press MORE TIME or LESS TIME until dryer starts. Press and hold ) HOLD TO START button until the desired drying time is running , you close the door and press Start within 5 minutes. While a Manual Cycle is desired. NOTE: Drying will change by the amount of lighter...
Use and Care Guide - Page 15
...Manual Cycle by pressing the DRYNESS LEVEL button to select MORE or LESS. The Wet light... TEMPERATURE until the desired temperature is selected.
Laundry is not detected after the end of a... Bulky Items Use this cycle to get High heat for drying large items that require very...or Manual Preset Cycle Settings chart (in handling. s The dryer enters the cool down for ease in the "Cycles" ...
Use and Care Guide - Page 16
...Medium
20
QUICK DRY Small loads
High
23
Additional Features
WRINKLE SHIELD™ Feature When you do not select the WRINKLE SHIELD™ feature, the dryer stops after an Automatic Cycle....remove wrinkles from items, such as clothes packed in a suitcase or items wrinkled from the dryer as soon as bedspreads and work clothes
BULKY ITEMS
Medium
64
Jackets, comforters, pillows
CASUAL...
Use and Care Guide - Page 17
... End of Cycle Signal The End of moisture items hold ) HOLD TO START button (about 1 second). NOTE: When the WRINKLE SHIELD™ feature is ... automatic cycles with the drying rack.
A
A. Place drying rack inside dryer drum, positioning the back wire on top of Cycle Signal is on,... suggested cycle, temperature setting and drying time. Push down on Dry
the rack. This chart shows examples of...
Use and Care Guide - Page 18
... discolor the dryer interior. A screen blocked by a qualified person. Wet lint is located in dryer. Roll lint off the screen into place. Scrub lint screen with powdered laundry detergent and very...completely dry. Wet both the dryer and fabrics. Failure to both sides of the dryer.
NOTE: Garments which contain unstable dyes, such as gasoline, away from the lint screen before ...
Use and Care Guide - Page 19
... crushed or kinked? Has an air cycle been selected?
Is the valve open fuel supply line.
5. s Is the dryer located in cold water and with items that hold ) HOLD TO START button to restart the dryer.
Use a time-delay fuse.
Check for 5-10 minutes.
Pilling (surface fuzz) is a normal operating sound.
Locate the light...
Use and Care Guide - Page 20
... help us to better respond to your correspondence.
with the same precision used ? Add dryer fabric softener sheets at :
Whirlpool Corporation Customer Interaction Center 553 Benson Road Benton Harbor, ...include a daytime phone number in Canada. Check the manufacturer's care label.
Match dryer setting to load type. Were items damaged before being dried. This information will fit...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The door will not open - Front-load washer
... running due to a possible high-water level in the washer after the Pause/Cancel button is pressed twice. The door will not immediately unlock while the cycle is pressed once. Pressing the Start button will not unlock. Drain/Spin or Spin Only to remove any remaining water from... -
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
... freshness: Use only HE High Efficiency detergent. Completely read these instructions completely before beginning the cleaning process. Do not add detergent or other laundry products to the Main Wash... you have a Clean Washer cycle, see Continue the cycle by pressing the Start button. Read these instructions before using the correct amount of bleach with this is an ... -
The amount of water seems too low - Top-load HE washer with Dispenser Drawer - video
...the load, and resume adding water. How Sensing works and water amount determined: When the Start button is normal and necessary for the load size. Adding more water than the washer ...Dispenser Drawers - Next, the washer will then move . Dispensers in my Cabrio TM High Efficiency washer. Does the water level seem too low, or does the washer appear to estimate the...
Similar Questions
Start Button Gas Dryer Model Wgd9600ta
The start button of my Whirlpool gas dryer popped out. It seems that the little plastic knob can not...
The start button of my Whirlpool gas dryer popped out. It seems that the little plastic knob can not...
(Posted by fchart47 7 years ago)
When I Pushed The Button It Wouldn't Start.
My dryer was working fine. All of a sudden I went to dry clothes and it wouldn't do anything. When I...
My dryer was working fine. All of a sudden I went to dry clothes and it wouldn't do anything. When I...
(Posted by eellisonshonuf 9 years ago)
Older Ggw92250pw Dryer Has Continous High Pitched Squeel. Clothes Dry Normally.
The Squeel Appears To Be Coming From Drum As It Turns. When The Dryer Is Paused The Squeel Stops. Ca...
The Squeel Appears To Be Coming From Drum As It Turns. When The Dryer Is Paused The Squeel Stops. Ca...
(Posted by frothenp 9 years ago)
The Gas Dosent Start Up To Heat
Where are the fueses located and what do they look like? Can they be checked from the front of the d...
Where are the fueses located and what do they look like? Can they be checked from the front of the d...
(Posted by sumrsky126 10 years ago)
Squeels When First Started But Goes Away Quickly. Clothes Dry Fine.
Whirlpool duet gas dryer model ggw9250pw
Whirlpool duet gas dryer model ggw9250pw
(Posted by Don48742 10 years ago)