Sharp XL-MP131 Support Question
Sharp XL-MP131 Support Question
Find answers below for this question about Sharp XL-MP131.Need a Sharp XL-MP131 manual? We have 1 online manual for this item!
Question posted by jamesaharber on November 26th, 2016
Our Sharp Xl Mp131 Has 1 Red Then 4 Short Blinking Red Lights Power
Our Sharp XL MP131 has 1 red then 4 short blinking red lights but doesnt power
Current Answers
Answer #1: Posted by waelsaidani1 on November 26th, 2016 8:14 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,777
Member since:
May 12th, 2013 Points: 19,501,777
Unplug the power cord from the outlet
2) Wait at least 1 hour (60+ Minutes)
3) Press and hold the power button (on the set, not the remote) for 60 seconds
4) Keep holding power button while plugging back in, and for another 60 seconds after. When plugging back in, go directly to the wall outlet, bypassing any power strips or surge protectors.
If this reset process does not work, it would unfortunately confirm an internal hardware failure.
Related Sharp XL-MP131 Manual Pages
XL-MP131 Operation Manual - Page 1
... this product, please read this SHARP product. Remote control 1 AM loop antenna 1 FM antenna 1 (RRMCGA052AWSA) (QANTL0005AWZZ) (92LFANT1746A) Note: Only the above accessories are included. It will guide you for purchasing this manual carefully.
Accessories
Please confirm that the following accessories are included. XL-MP131 Micro Component System consisting of XL-MP131 (main unit) and CP...
XL-MP131 Operation Manual - Page 2
... radiate radio frequency energy and, if not installed and used in a particular installation. XL-MP131 SPECIAL NOTES
Important Instruction
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE...information. NOTES
It is intended to alert the user to Part 15 of Sharp that any unauthorized changes or modifications to radio communications.
These limits are located on , ...
XL-MP131 Operation Manual - Page 3
...blocked by the manufacturer that they may cause the product and cart combination to .
11 Power Sources - Unplug this product on the marking label. ample, near water - The ...required, be moved with the product. Slots and openings in a wet basement; Important Instruction
XL-MP131
3 Do not use instructions should be sure the service technician has used a replacement plug ...
XL-MP131 Operation Manual - Page 4
XL-MP131 IMPORTANT SAFETY ...- Unauthorized substitutions may result in performance - Never spill liquid of other electric light or power circuits, or where it from the wall outlet
and refer servicing to its normal...of antenna grounding as opening
or removing covers may touch dangerous voltage points or short-out parts that are required, be fatal.
18 Overloading - When installing an ...
XL-MP131 Operation Manual - Page 5
ENERGY STAR® is a U.S. registered mark.
0312
Contents
XL-MP131
Page
General Information
Precautions 6 Controls and indicators 7 - 9
Preparation for Use
System connections 10 - 12 Remote control 13
Basic Operation
General control 14 Setting the clock ...
XL-MP131 Operation Manual - Page 6
...top of the equipment.
4" (10 cm) 4" (10 cm) 4" (10 cm)
POWER/ CD
XL-MP131 MICRO COMPONENT SYSTEM
Use the unit on this product with a higher voltage other than that which generate electrical noise. Hold...range of accident causing damage.
In case of this may result in a fire or other factors.
SHARP will not be the same as this unit with the volume control setting up high, or while ...
XL-MP131 Operation Manual - Page 7
Power On/Stand-by Button 14 4. Cassette Compartment 28 7. Remote Sensor 13 12. Memory/Set Button 15, 21,...Disc or Tape Stop Button 18, 29
7
General Information Volume Control 14 13. Tuning Down Button 26 24. Controls and indicators
CD
XL-MP131
Front panel
Reference page 1. Tape Record Pause Button 30, 31 6. Disc Tray Open/Close Button 16 9. Disc Number Select Buttons 16...
XL-MP131 Operation Manual - Page 8
... Total Indicator 23 11. Extra Bass Indicator 14 17. AC Power Cord 12 3. Bass Reflex Duct
1
3
4. XL-MP131 Controls and indicators (continued)
12
3
45
6 789
General ...MP3 Indicator 17 5. WMA Indicator 17 6. FM Stereo Mode Indicator 26 13. Video/Auxiliary (Audio Signal) Input Jacks 36 7. Memory Indicator 21, 25 16. Subwoofer Pre-output Jack 37
Speaker...
XL-MP131 Operation Manual - Page 9
...Tuner Preset Down, Time Down Button 15, 18, 27, 29
28. Remote Control Transmitter 13
2. Power On/Stand-by Button 14
8. Video/Auxiliary Button 36
3
12. Disc Play or Repeat Button 16,... Forward, Tape Fast Forward,
Tuner Preset Up, Time Up Button 15, 18, 27, 29
9 XL-MP131
General Information
Remote control
1
Reference page
1. Disc Random Button 20
22
23 24
15. Enter Button...
XL-MP131 Operation Manual - Page 10
XL-MP131 System connections
Make sure to unplug the AC power cord before any connections. Antenna connection (see page 12)
AC INPUT
RIGHT LEFT
SUBWOOFER PRE-OUT
Speaker connection (see page 11) 10
AC outlet (AC 120 V, 60 Hz)
AC power connection (see page 11)
FM antenna
AM loop antenna
Right speaker
Left speaker
Preparation...
XL-MP131 Operation Manual - Page 11
...OUT
Red
Black
Caution:
Use speakers with screws (not supplied). Do not let the bare speaker wires touch each other.
Place the AM loop antenna on the unit or near the AC power ...FM 75 OHMS
GND
LOOP
VIDEO/AUX IN
RIGHT LEFT
RATED SPEAKER IMPEDANCE: 6 OHMS MIN. XL-MP131
SPEAKERS SPEAKERS
Preparation for Use
Antenna connection
Supplied FM antenna: Connect the FM antenna wire to the...
XL-MP131 Operation Manual - Page 12
...unit will not be used , disconnect the supplied FM antenna wire.
12
Note: When the power is plugged in use for a prolonged period of this will enter the demonstration mode. Outdoor...select the extra bass mode. To cancel the demonstration mode: When the unit is finished. XL-MP131 System connections (continued)
Preparation for improved cooling. Wait until the process is in the unit...
XL-MP131 Operation Manual - Page 13
...indicated in
the battery compartment (back of time.
Change the lighting or the direction of the remote control
Check the remote ...the range shown below: Press the ON/STAND-BY button. Remote control
XL-MP131
Battery installation
Use 2 "AA" size batteries (UM/SUM-3, R6, ... if this occurs. The remote control can enjoy music. Does the power turn on the unit to take out.
13 This will not be...
XL-MP131 Operation Manual - Page 14
... main unit with the volume set to increase or decrease the volume.
0 ..... 30 MAXIMUM
Bass control
When the power is turned clockwise, the volume will appear.
FLAT ROCK
No equalization. For pop music.
Remote control operation: Press... the display brightness
You can switch the display brightness by mode. XL-MP131 General control
Volume control
Main unit operation: When the VOL + / -
XL-MP131 Operation Manual - Page 15
...
[When the power is set with the remote control.
15 If the "CLOCK" does not appear in step 3, step 4 (for details.]
2 Perform "Setting the clock" from step 1. Setting the clock
XL-MP131
5 Press the... also be skipped. To confirm the time display: [When the unit is restored after a power failure or unplugging the unit.
PM 11:59) The 12-hour display will appear. To change the ...
XL-MP131 Operation Manual - Page 29
...tab hole with no effect on the recorded signal (Variable Sound Monitor). If a power failure occurs during tape operation, the tape head will remain engaged with the tape ... preliminary test to record on a cassette tape
XL-MP131
Before recording:
When recording important selections, make sure that the desired material is properly recorded. SHARP is restored. In this unit.
To protect the...
XL-MP131 Operation Manual - Page 33
...button to the next page
33 White
Red
The illustrations show the timer playback setting... button.
8 Set the time to enter the power stand-
If a station has not been programmed,...is ready for timer playback or timer recording.
XL-MP131
4 Within 10 seconds, press the
or
button ...timer recording source: TUNER. The "TIMER" indicator lights up too high.
11Press the ON/STAND-BY button...
XL-MP131 Operation Manual - Page 36
... below.
Adjust the volume using video equipment, connect the audio output to this unit and the video output to a ...VIDEO/AUX button. 4 Play the connected equipment. Advanced Features SPEAKERS
XL-MP131
Enhancing your headphones have a 1/8" (3.5 mm) diameter plug and ...the line output jacks
Red
Red
WhiteRATED SPEAKER IMPEDANCE: 6 OHMS MIN. VCR, DVD, etc. Auto power on function: When...
XL-MP131 Operation Manual - Page 37
...IN
RIGHT LEFT
RATED SPEAKER IMPEDANCE: 6 OHMS MIN. Set the unit to the power standby mode and then turn it .
Playback stops in amplifier
CD player
Symptom ...SHARP dealer or service center.
Is the volume level set to the correct time. Are the speaker wires disconnected?
No sound is pressed, the unit does not respond.
Reset the clock. Are the headphones connected? XL-MP131...
XL-MP131 Operation Manual - Page 41
... continuous improvement, SHARP reserves the right to 20 kHz...-out (audio signal): 200 mV/10 k ohms at 70 Hz
Video/Auxiliary (audio signal):...power Rated input power Impedance Dimensions
Weight
2-way type speaker system 2" (5 cm) tweeter 5-1/8" (13 cm) woofer 170 W
85 W 6 ohms Width: 7-1/4" (185 mm) Height: 10-1/4" (260 mm) Depth: 9-1/16" (230 mm) 6.1 lbs. (2.8 kg)/each
References
XL-MP131...
Similar Questions
Sharp Xl-uh240 Timer Flash Red Light And System Is Not Open
Sharp xl-uh240 timer flash red light and system is not open
Sharp xl-uh240 timer flash red light and system is not open
(Posted by tvtuman 9 years ago)
I Had A Greenwald Power Failure And Cannot Turn System On Red Light Just Flashes
(Posted by Anonymous-141751 9 years ago)
Red Light Wont Turn On
I just set up my new soundbar and it worked great for about four days..Now when it turns on via a sm...
I just set up my new soundbar and it worked great for about four days..Now when it turns on via a sm...
(Posted by PLavin223 10 years ago)
Resetting Sharpxl Mp131
we had power outage. When the power came back on it will ot come on. It flashes 4 short and 1 long r...
we had power outage. When the power came back on it will ot come on. It flashes 4 short and 1 long r...
(Posted by debps55 11 years ago)
Xl-mp131 Will Not Turn On
I have a SHARP XL-MP131 micro component system. The unit is plugged in but will not turn on. Instead...
I have a SHARP XL-MP131 micro component system. The unit is plugged in but will not turn on. Instead...
(Posted by hehlenusa 12 years ago)